BOSCH SHPM65W55N Dishwasher
Operating the Dishwasher en-us
To change the signal volume:
1. Open the door.
Delay Start
You can delay the start of the cycle in
one hour increments up to 24 hours.
2. Press the On/Off button (.
3. Hold down function key # and
press Start button P until the
display 8 indicates Ê:¯x (x can
be any number). Release both
buttons.
¤:¯³ 1 hour delay
¤: 24 hours delay
To set Delay start:
4. Press function key # until the
display shows °:¯.
1. Open the door and press the
On/Off button (. Select a cycle.
2. Press the Delay button from the
wash cycle options H until the
displayed time corresponds with
your requirements.
5. Press function key 3. Each time
the button is pressed the set
value increases by one level;
when it reaches the valueꢁ°:¯´,
the display jumps back to °:¯¯
(off).
3. Press the Start button P to
activate Delay start.
6. Press Start button P to save
the setting.
To cancel Delay start:
1. Open the door and press the
Delay button until ¤:¯¯ is
indicated on the digital
display 8.
2. Press the Start button P to
save setting.
Auto power off
This setting determines the length of
time the control panel stays
illuminated after the cycle is
complete. To save energy the
recommended setting is Æ:¯³.
Note: Your dishwasher is protected
against unintentional operation. If the
appliance door remains open for
more than 4 seconds after pressing
the Start button, the operation will be
paused. Press the Start button again
and close the appliance door.
This setting can be adjusted from
Æ:¯¯ to Æ:¯.
Æ:¯¯ dishwasher does not turn off
automatically
Æ:¯³ dishwasher turns off
automatically after 1 minute
Æ:¯ dishwasher turns off
automatically after
Wash cycle end
The wash cycle has ended when the
display 8 reads ¯:¯¯.
120 minutes (2 hours)
To change the setting:
If the signal tone has been set, the
wash cylce end is also indicated by a
buzzer.
1. Press the On/Off button (.
2. Hold down the function key #
and press the Start button P
until the display 8 indicates
Ê:¯x (x can be any number).
3. Release both buttons.
°:¯¯
°:¯³
°:¯
°:¯´
Off
low
medium
loud
4. Press the function key # until
the display 8 indicates Æ:¯x.
5. Press the function key 3 until
the display corresponds with your
requirements.
6. Press the Start button P.
27
en-us Operating the Dishwasher
Note: Your dishwasher is protected
against unintentional operation. If the
appliance door remains open for
more than 4 seconds after pressing
the Start button, the operation will be
paused. Press the Start button again
and close the appliance door.
Switching off the appliance
Short time after the end of the wash
cycle:
1. Open the door.
2. Switch off On/Off button (.
3. Turn off water supply.
4. Remove the utensils when they
have cooled down.
Terminating the wash cycle
(Reset)
ꢀ WARNING
e
l
c
y
c
h
s
a
w
e
h
t
g
n
i
t
a
n
i
m
r
e
T
for approximately 3 seconds until
RISK OF INJURY!
To avoid risk of injury, always
use caution when opening the
door during or following a wash
cycle as hot water or steam
may escape. Do not fully open
the door until water noises have
stopped and steam has
subsided.
2. Wait about 1 minute while the
dishwasher drains.
3. Press On/Off button (.
You may now power the dishwasher
back on and begin a new cycle if
desired.
Changing the wash cycle
When the Start button ( has been
pressed, the wash cycle cannot be
changed. The only way a wash cycle
can be changed is by terminating the
wash cycle (Reset).
Interrupting the wash cycle
ꢀ CAUTION
Expansion (overpressure) may
cause the appliance door to
open and/or water to escape! If
the door was opened on an
appliance which has a hot water
connection or is heated, always
leave the door ajar for several
minutes and then close.
InfoLight®
While the wash cycle is running, a
light spot shines on the floor under
the appliance door.
Do not open the appliance door until
the light point is no longer visible on
the floor.
If the appliance door is not
completely closed, the light spot
flashes*.
If the appliance is installed at
eye-level, with flush furniture front, the
light point is not visible.
In darkened rooms, some light
scattering may be visible. This is
normal and cannot be changed.
1. Open the door.
2. Switch off On/Off switch (.
The LED$s go out. The wash cycle
is saved.
3. To continue the wash cycle,
switch on the On/Off switch (
again.
4. Close the door.
You can switch the Infolight on or off.
³:¯¯
³:¯³
Off
low
28
| General | Details |
|---|---|
| Name | BOSCH SHPM65W55N Dishwasher |
| Make | Bosch |
| Language | English |
| Filetype | PDF (Download) |
| File size | 2.74 MB |
(1 votes, average: 5.00 out of 5)
Loading...
BOSCH SMV6ZCX49E-39 Dishwasher
BOSCH SMI4HVS33E Dishwasher
BOSCH SRV2HKX39G Dishwasher
BOSCH SGS4HAW40G Dishwasher
BOSCH SGH4HVX32G Dishwasher
BOSCH SMS4ECI26E Dishwasher
BOSCH SMS6EDI02G Free-Standing Dishwasher
BOSCH SMS6EDW02G Free-Standing Dishwasher
BOSCH SMV4HTX27G Dishwasher
BOSCH SMV4HCX48E Dishwasher
Miele G 7783 SCVi AutoDos K2O FF Dishwasher
Electrolux FSE52607P Dishwasher
bolero AGUAZERO 8000 Dishwasher
FISHER PAYKEL DD24SV2T9 N Dishwasher
FISHER PAYKEL DD24SCTB9N Dishwasher
MORA IM6465S Dishwasher
BOSCH 81739 Dishwasher
FISHER PAYKEL DD24SI9 N Integrated Single DishDrawer Dishwasher
Hotpoint W11518627 Dishwasher
Omega ODWIF6015 Integrated Dishwasher