BOSCH SHV53CM3N 300 Series Full Dishwasher
Dishwasher Connectionꢀen-us
effectiveness. Lower water temperatures will increase run
times. The hot water supply pressure must be between 15
- 145 psi (1 - 10 bar).
4. After all connections are made, turn on the hot water
and check for leaks.
5.2ꢀInstalling the Drain Connection
WARNING
The drain hose must be installed with either a high loop or
an air gap.
Scalding Hazard
▶ Do not perform any work on a pressured hot water line.
Serious injury could result. Only qualified plumbers
should perform plumbing work. Do not attempt any work
on the dishwasher hot water supply plumbing until you
are certain the hot water supply is shut off.
NOTICE:
Proper drain hose installation
▶ The dishwasher drain hose must be installed with a
portion of it at least 33” (84 cm) off the floor; otherwise
the dishwasher may not drain properly.
Remove garbage disposal plug
NOTICE:
Soldering plumbing lines
▶ If the dishwasher drain hose will be connected to a
garbage disposal connection, first remove the plug from
the disposal connection.
▶ Temperatures required for soldering and sweating will
damage the dishwasher. If plumbing lines are to be
soldered or sweated, keep the heat source at least 6
inches (152.4 mm) away from the dishwasher.
Plumbing codes
▶ Check local plumbing codes for approved plumbing
procedures and accessories. All plumbing should be
done in accordance with national and local codes.
Note
Important notes for drain connection:
¡ If local ordinance require an air gap, install it according
to the manufacturer’s instructions.
¡ The drain hose length can be extended if necessary.
Use kit #SGZ1010UC. The maximum length of the drain
hose, including the hose leading to the air gap, is 150″
(380 cm).
¡ You may attach the hose clip the inside of the adjacent
cabinet to hang the drain hose (screws are not
supplied) in place of using a nonmetallic tie as pictured
in the next illustrations. Do not exceed 43” in drain hose
height.
Note
Important notes for water connection:
¡ If using a solder joint instead of a compression fitting,
be sure to complete all solder connections before
connecting the water supply line to the dishwasher.
¡ Use an approved dishwasher water supply line with the
correct fittings for this connection.
¡ If using copper tubing or other material not depicted in
this manual for water supply, defer to a licensed
plumber for proper installation.
¡ Always use appropriate seals when making plumbing
connections.
1. Flush the incoming water line for approximately 1
minute to clear any foreign material.
2. Connect the dishwasher water supply line to the water
shut off valve.
‒ Install a shut off valve if one isn’t already in the
supply line.
‒ Make sure there are no sharp bends or kinks in the
water line that might restrict water flow.
1. Place hose clamp around end of drain hose BEFORE
connecting to the plumbing.
2. If you have a garbage disposal, connect the drain hose
to the garbage disposal with either a high loop or an air
gap.
3. Properly tighten all water connections.
15
| General | Details |
|---|---|
| Name | BOSCH SHV53CM3N 300 Series Full Dishwasher |
| Make | Bosch |
| Language | English |
| Filetype | PDF (Download) |
| File size | 4.33 MB |
(1 votes, average: 5.00 out of 5)
Loading...
BOSCH SMV6ZCX49E-39 Dishwasher
BOSCH SMI4HVS33E Dishwasher
BOSCH SRV2HKX39G Dishwasher
BOSCH SGS4HAW40G Dishwasher
BOSCH SGH4HVX32G Dishwasher
BOSCH SMS4ECI26E Dishwasher
BOSCH SMS6EDI02G Free-Standing Dishwasher
BOSCH SMS6EDW02G Free-Standing Dishwasher
BOSCH SMV4HTX27G Dishwasher
BOSCH SMV4HCX48E Dishwasher
Home and Marker TURBOWASH Angoily Dishwasher
FISHER and PAYKEL DD60ST4ZB9 Dishwasher
TESLA WD690MW Dishwasher
FISHER PAYKEL DW24UT2I2 Tall Dishwasher
Haier HDW15U3B1 Steam Built Under Dishwasher
BOSCH SHP87P Dishwasher
FISHER AND PAYKEL DW60UC6B Built Under Dishwasher
FISHER AND PAYKEL DD60D2NX9 Dishwasher
Avanti DWF24V3S Dishwasher
FISHER PAYKEL DD60SDFX9 Single DishDrawer Dishwasher