BOSCH 041203 Dishwasher
¡ Never install the appliance in boats or in vehicles.
¡ The warranty applies only when using the appli-
ance as intended.
¡ The fitted unit must be heat-resistant up to 90 °C.
Positioning the appliance
Note: Do not use silicone to bond the appliance to
the worktop.
¡ Before installing the appliance, check that the
local conditions of the supplier are compatible
with the appliance settings specified on the rating
plate (type of gas and pressure, power, voltage).
¡ Secure the power cord to the cabinet to prevent it
from touching hot parts of the oven or hob.
¡ Before any work is carried out on the appliance,
switch off the power supply and the gas supply.
¡ Connect the appliance to the power supply using
the earth.
1. Position the hob with the upper side facing down
on a flat, stable surface.
2. Apply the adhesive seal supplied to the lower
edge of the hob. The adhesive seal prevents the
penetration of liquids.
3. Screw the brackets supplied into the specified po-
sition so that they can turn freely.
¡ Do not make any changes to the inside of the ap-
pliance. If required, contact our technical cus-
tomer service.
4. Turn the hob around and insert it into the recess.
Insert the hob in the front of the recess.
Before installing
5. Turn the brackets and tighten them fully.
¡ This appliance is a class 3 appliance in accord-
ance with the EN 30-1-1 standard for gas appli-
ances: Built-in appliance.
The position of the brackets depends on the work-
top thickness.
¡ The unit in which the appliance is installed must
be stable and secured appropriately.
Installing the appliance flush
1. Install the appliance so that there is an even gap
¡ The units in the vicinity of the appliance, the lamin-
ated panels and the adhesive with which they are
secured must be made of non-flammable, heat-
resistant materials.
¡ Do not install this appliance above refrigerators,
washing machines, dishwashers or similar.
¡ The appliance must only be installed on an oven
with forced ventilation. Check the dimensions of
the oven in the installation instructions for the
oven.
‒ The hob should be slightly below the work sur-
face. On tiled worktops, the contact surfaces
can be raised, if necessary, with temperature-
and water-resistant rails.
2. Check that the appliance works correctly and is in
¡ If you install an oven underneath the hob, the work
surface thickness may differ from the dimensions
given in these instructions. Take note of the in-
formation in the oven installation instructions.
¡ If you install an exhaust air fan or an extractor
hood, refer to the installation instructions for these.
Always observe the minimum vertical distance to
the hob.
the correct position.
3. Fill the gap between the work surface and the hob
using a suitable commercially available silicone
adhesive.
Smooth the silicone adhesive with a spatula or a
finger wetted with soap before a solid layer forms.
Note: Leave the silicone adhesive to dry before you
use the appliance.
Tip: If you use an unsuitable silicone adhesive on
natural stone work surfaces, it may cause discolour-
ation that can no longer be removed. A suitable ad-
hesive is available from our technical customer ser-
vice.
Preparing the units
¡ Make a cut-out in the worktop with the required di-
mensions depending on the relevant installation
method: Standard (a) or flush (b).
¡ Any panel that is attached closer to the built-in
niche than the specified clearance must be made
of non-combustible material. Always maintain a
distance of at least 5 mm between the panel and
the appliance. Maximum clearances for the panel:
30 mm thickness x 70 mm height.
¡ Seal the cut surfaces of wooden work surfaces
with a special glue seal to protect them from mois-
ture.
Removing the appliance
1. Disconnect the appliance from the electricity and
gas connections.
2. Unscrew the brackets and proceed in reverse or-
der.
Connecting the gas
Observe the country-specific guidelines.
¡ If there is no built-in oven underneath the hob, in-
sert a non-flammable separator (e.g. metal or ply-
wood) at a distance of 10 mm from the hob. This
prevents access to the underside of the hob. The
distance from the intermediate floor to the mains
connection for the appliance must be at least 10
mm.
CAUTION ‒ Risk of explosion!
A gas leakage may cause an explosion.
▶ If any connection is handled, check the seal.
¡ Arrange the gas connection so that the shut-off
valve is accessible.
¡ Ensure that the information on the rating plate re-
garding the gas type and gas pressure complies
with the local connection conditions.
Preparing the furniture item for flush installation
¡ Connect the appliance to a fixed gas pipe or a
flexible metal pipe.
¡ All cutting work on the work surface must be car-
ried out in a specialist workshop.
¡ The flexible metal pipe must not come into contact
with the moving parts of the unit in which the ap-
pliance is installed (e.g. a drawer) and must not
be routed through any spaces which might be-
come obstructed.
¡ The cuts must be clean and precise because the
cutting edge is visible on the surface. The stability
of the units must also be ensured after the cutting
work.
¡ Only use special, temperature- and water-resistant
work surfaces (e.g. natural stone or tiles).
¡ Gas connection elbow on the appliance: R 1/2.
5
| General | Details |
|---|---|
| Name | BOSCH 041203 Dishwasher |
| Make | Bosch |
| Language | English |
| Filetype | PDF (Download) |
| File size | 0.38 MB |
(1 votes, average: 5.00 out of 5)
Loading...
BOSCH SMV6ZCX49E-39 Dishwasher
BOSCH SMI4HVS33E Dishwasher
BOSCH SRV2HKX39G Dishwasher
BOSCH SGS4HAW40G Dishwasher
BOSCH SGH4HVX32G Dishwasher
BOSCH SMS4ECI26E Dishwasher
BOSCH SMS6EDI02G Free-Standing Dishwasher
BOSCH SMS6EDW02G Free-Standing Dishwasher
BOSCH SMV4HTX27G Dishwasher
BOSCH SMV4HCX48E Dishwasher
BOSCH SMS4HVC03E Dishwasher
BOSCH SGV78C53UC Dishwasher
GRUNDIG GR5500 Dishwasher
CMA DISHMACHINES CMA-180 VL Rack Straight Dishwasher
AEG FSK53617Z Dishwasher
Electrolux ESL2500RO Dishwasher
Hotpoint 869991662940 Dishwasher
BOSCH SHX78B75UC Dishwasher
IKEA AA-2281075-2 LAGAN Dishwasher
Thermador DWHD640EFP Dishwasher