BOSCH SMS68L08GC Active Water Dishwasher
en-usꢀDishwasher Connection
some detergents to lose effectiveness. Lower water
temperatures will increase run times. The hot water supply
pressure must be between 7.25 - 145 psi (0.5 - 10 bar).
3. Properly tighten all water connections.
4. After all connections are made, turn on the hot water
and check for leaks.
WARNING
Scalding Hazard
5.2ꢀInstalling the Drain Connection
The drain hose must be installed with either a high loop or
an air gap.
▶ Do not perform any work on a pressured hot water line.
Serious injury could result. Only qualified plumbers
should perform plumbing work. Do not attempt any work
on the dishwasher hot water supply plumbing until you
are certain the hot water supply is shut off.
NOTICE:
Proper drain hose installation
▶ The dishwasher drain hose must be installed with a
portion of it at least 33” (84 cm) off the floor; otherwise
the dishwasher may not drain properly.
Remove garbage disposal plug
▶ If the dishwasher drain hose will be connected to a
garbage disposal connection, first remove the plug from
the disposal connection.
NOTICE:
Soldering plumbing lines
▶ Temperatures required for soldering and sweating will
damage the dishwasher. If plumbing lines are to be
soldered or sweated, keep the heat source at least 6
inches (152.4 mm) away from the dishwasher.
Plumbing codes
▶ Check local plumbing codes for approved plumbing
procedures and accessories. All plumbing should be
done in accordance with national and local codes.
Note
Important notes for drain connection:
¡ If local ordinance require an air gap, install it according
to the manufacturer’s instructions.
¡ The drain hose length can be extended if necessary.
Use kit #SGZ1010UC. The maximum length of the drain
hose, including the hose leading to the air gap, is 150″
(380 cm).
¡ You may attach the hose clip to the inside of the
adjacent cabinet to hang the drain hose (screws are not
supplied) in place of using a nonmetallic tie as pictured
in the next illustrations. Do not exceed 43” in drain hose
height.
Note
Important notes for water connection:
¡ If using a solder joint instead of a compression fitting,
be sure to complete all solder connections before
connecting the water supply line to the dishwasher.
¡ Use an approved dishwasher water supply line with the
correct fittings for this connection.
¡ If using copper tubing or other material not depicted in
this manual for water supply, defer to a licensed
plumber for proper installation.
¡ Always use appropriate seals when making plumbing
connections.
1. Flush the incoming water line for approximately 1
minute to clear any foreign material.
2. Connect the dishwasher water supply line to the water
shut off valve, using the adaptor if included with your
model.
‒ Install a shut off valve if one isn’t already in the
supply line.
‒ Make sure there are no sharp bends or kinks in the
water line that might restrict water flow.
1. Place hose clamp around end of drain hose BEFORE
connecting to the plumbing.
12
| General | Details |
|---|---|
| Name | BOSCH SMS68L08GC Active Water Dishwasher |
| Make | Bosch |
| Language | English |
| Filetype | PDF (Download) |
| File size | 1.05 MB |
(1 votes, average: 5.00 out of 5)
Loading...
BOSCH SMV6ZCX49E-39 Dishwasher
BOSCH SMI4HVS33E Dishwasher
BOSCH SRV2HKX39G Dishwasher
BOSCH SGS4HAW40G Dishwasher
BOSCH SGH4HVX32G Dishwasher
BOSCH SMS4ECI26E Dishwasher
BOSCH SMS6EDI02G Free-Standing Dishwasher
BOSCH SMS6EDW02G Free-Standing Dishwasher
BOSCH SMV4HTX27G Dishwasher
BOSCH SMV4HCX48E Dishwasher
AEG GS60AIM Dishwasher
Whirlpool WFC 3C26 Dishwasher
BOSCH SPV6EMX65Q Dishwasher
FISHER PAYKEL DD60SDFHX9 Single DishDrawer Dishwasher
BOSCH SPS2HMI54Q Dishwasher
FISHER AND PAYKEL DD60D2NB9 Dishwasher
BOSCH SHE4AEM2N 100 Series Black Full Console Dishwasher
Rubicum DRYSTACK Multistage Dishwasher
AEG FSK53617Za Dishwasher
FISHER and PAYKEL DD60DTX6HI CN Dishwasher