Home > ILVE > ILVE E5 Dishwasher

ILVE E5 Dishwasher

Connection Of Drain Hoses  
To ensure problem free operation please follow these guidelines during installation:  
IMPORTANT: In new builds, the plumbing should be flushed to ensure no impurities  
remain in the supply before appliances are connected.  
1.Remove tape, foam, manual etc from inside the machine  
2.Connect the supply hose to the tap. Ensure the inlet hose is secure at the machine  
and tap ends.  
3.Connect the drain hose to the waste. If the drain hose is connected to a spigot in  
the S bend under the sink, please make sure that the hole in the spigot is drilled  
out to the same dimension as the internal diameter of the spigot to prevent blockage.  
The drain hose (maximum length 4M) should be positioned as shown here:  
4.Insert the plug into the power socket and switch it on.  
5.Open the tap and ensure there are no leaks. Push the machine home in its cavity  
and adjust the feet ensuring the machine is level. Ensure the door can close without  
obstruction. Take care to prevent kink of the fill and drain hoses.  
6.Run a short program to confirm the unit fills and drains OK.  
7.If the unit displays an error code or a leak that cannot be resolved please contact us  
on customercare@eurolinx.com.au  
Finally secure the unit to the side or benchtop, switch the unit off, switch power to  
the unit off and turn off the tap.  
How to drain excess water from hoses  
If the sink is 1000 higher from the floor, the excess water in hoses cannot be drained  
directly into the sink. It will be necessary to drain excess water from hoses into a bowl  
or suitable container that is held outside and lower than the sink.  
17  
GeneralDetails
NameILVE E5 Dishwasher
MakeILVE
LanguageEnglish
FiletypePDF (Download)
File size5.24 MB
Download PDF
1 Star2 Stars3 Stars4 Stars5 Stars (1 votes, average: 5.00 out of 5)
Loading...
ILVE IVFID10 Dishwasher
ILVE IVFID10 Dishwasher

ILVE E5 Dishwasher