Home > KitchenAid > Kitchenaid MVWC565FW1 Dishwasher
Kitchenaid MVWC565FW1 Dishwasher
INSTALL ACCESS PANELS
48. Power supply cord—Plug into
a grounded 3 prong outlet
50. Reinstall access panels and fasteners
Insulation
(on some models)
Plug into a grounded 3 prong outlet.
49. Reconnect power
Reconnect electrical power at the fuse box or circuit
breaker box.
NOTE: With the access panel off, start the dishwasher and allow
it to complete the shortest Installation Cycle while checking unit
for leaks. See instructions on this manual under Check Operations
section.
Place the toe panel behind the access panel against the
dishwasher leg. If insulation is included on this model, make sure
insulation does not interfere with the float assembly. Push the
access panel up toward the top of the product so that it hangs on
the hooks on the plastic side members.
■ Reinstall the toe/access panel assy.With side shield to go
between the toe/access panel assembly and the side member.
Align the rectangular slot in the foam and assembly the toe/
access panel assembly to the unit using the screw.
CHECK OPERATION
■ Read the dishwasher Quick Start Guide that came with your
dishwasher.
■ Check that all parts have been installed and no steps were
skipped. Check that you have used all tools.
■ Run the Installation Cycles as follows (Note that it can be
beneficial to run this with the access panel removed in order
to look for presence of water under the unit. If running in this
state, the float switch wire MUST still be connected to the float
switch.)
NOTE: Remove film on door Score around door for easier
removal.
■ If the dishwasher is not working properly, disconnect power
or unplug dishwasher and refer to the “If Dishwasher Does Not
Operate” section.
■ Press any 3 keys (except Delay or Cancel) in the sequence
1-2-3-1-2-3-1-2-3 with no more than 1 second between key
presses to enter the Installation cycle then press button #2.
■ Close the door and the cycle will start.
■ All LEDs turn on immediately upon receiving entry sequence.
■ A tone may play depending on the model.
■ The cycle will pause when the door is opened and resume
when closed.
■ No Start/Resume key press required to resume.
■ The installation cycle may last several minutes.
51. Check access panel edge
■ Press Cancel key to exit installation cyle mode. The product
will exit this mode after 10 minutes or if power is removed from
the appliance.
NOTE: It is normal for the drain pump to sound loud upon the
first run since no water is present in the system.
Numeric
Display
All
LEDs
on
5
(Some
models
1
2
3
4
6
7
Approximate
interval
0:30
(Maximum
5:00)
1:00
(Maximum
5:00)
Check that the lower edge of the access panel touches the floor.
Adjust if necessary.
Time
0:01
2:00
0:20
0:20
0:20
0:30
Machine
Action
Wash+
Third
Wash+
Dispenser
(Middle
spray
Fill 3.8
L+
Wash+
Fan
Level
Wash+
Heater
(Lower
spray
arm)
Rack. If
present
in this
model
Wash
motor
pulses
(Ceiling
spray
arm)
Initial
Drain
pulses
arm)
Drain
Pause
Pracess
27
| General | Details |
|---|---|
| Name | Kitchenaid MVWC565FW1 Dishwasher |
| Make | KitchenAid |
| Language | English |
| Filetype | PDF (Download) |
| File size | 11.84 MB |
(1 votes, average: 5.00 out of 5)
Loading...
KitchenAid KDTE304RBS Third Level Jet Rack Dishwasher
KitchenAid KDTF324PPA Dishwasher
KitchenAid w11323304 Dishwasher
KitchenAid KDFE104KWH Two Rack Dishwasher
KitchenAid KDTE104KPS Dishwasher
KitchenAid KDFE104KBL Front Dishwasher
KitchenAid KDTF924PPS Flush Cabinet Dishwasher
KitchenAid KDTE304RBS Level Jet Rack Dishwasher
KitchenAid KDF Series Dishwasher
KitchenAid W11589937B Dishwasher
FISHER PAYKEL DD24DCHTX9 N Sanitize Dishwasher
BOSCH SHE41CM2N Recessed Handle Dishwasher
KitchenAid KDTE304RBS Level Jet Rack Dishwasher
FISHER AND PAYKEL DW60UT4I2 Built Under Dishwasher
MAYTAG W11363089B Dishwasher
gorenje GI52040X Dishwasher
BOSCH SHV53CM3N Dishwasher
BOSCH SHX3AR Dishwasher
BOSCH SPV4EKX25E Dishwasher
AEG FSK74747P Dishwasher