kleenmaid DW6020XB Black /Built Under Dishwasher
Improper connection of the equipment earthing conductor can result in the risk of an
electric shock.
Check with a qualified electrician or service representative if you are in doubt whether the
appliance is properly earthed.
Do not modify the plug provided with the appliance. If the plug does not fit properly to
the outlet, please have a qualified electrician install a proper outlet.
Cold Water Connection
How to connect the AquaStop supply hose
1. Pull the AquaStop supply hose completely out from storage compartment located at rear of
dishwasher.
2. Tightly screw the AquaStop supply hose to a cold water tap with 3/4 inch thread.
3. Turn water fully on before starting the dishwasher.
If the water pipes are new or have not been used for an extended period of time, let the water run to
make sure that the water is clear. This precaution is needed to avoid the risk of the water inlet becoming
blocked and causing damage the appliance.
About the AquaStop supply hose:
The AquaStop supply hose has double walls. The hose's system guarantees its intervention to
block the flow of water in case of the supply hose breaking and when the air space between the supply
hose itself and the outer corrugated hose is full of water.
NOTE: The total length of the supply hose assembly is 1830mm. The available length of the supply
hose from the dishwasher case to the supply connector is 1500mm.
AquaStop supply hose
How to disconnect the AquaStop supply hose
1. Turn off the water.
2. Unscrew the AquaStop supply hose from the tap.
WARNING
A hose that attaches to a tap can burst if it is installed on the same water line as the dishwasher. If your sink has one, it is
recommended that the hose be disconnected and the hole plugged.
Please turn off the water supply tap after using.
Drain Hose Connection
Insert the drain hose into a drain pipe with a minimum diameter of 40mm, or let it run into the sink, making sure to avoid
bending or crimping it. The height of the drain pipe must be less than 1000mm. The free end of the hose must not be
immersed in water to avoid back flow.
NOTE: The total length of the drain hose assembly is 1874mm. The available length of the drain hose from the
dishwasher case to the drain connector is 1640mm.
Please securely fix the drain
hose in either position A or
position B.
Counter
Back of dishwasher
A
Drain hose
B
Water Inlet
Drain Pipe
21
Mains Cable
| General | Details |
|---|---|
| Name | kleenmaid DW6020XB Black /Built Under Dishwasher |
| Make | kleenmaid |
| Language | English |
| Filetype | PDF (Download) |
| File size | 2.96 MB |
(1 votes, average: 5.00 out of 5)
Loading...
Kleenmaid DW6020XB Black Built Under Dishwasher
kleenmaid DW6032 Dishwasher
KLEENmaid DW6031 Dishwasher
KLEENmaid DW4531 45cm Dishwasher
kleenmaid DW6020X Dishwasher
kleenmaid DW6032 Semi Integrated Dishwasher
FISHER PAYKEL DOOR DD60ST Door Panel Integrated Tall Single DishDrawer Dishwasher
LG DFB-425FP Dishwasher
BOSCH SPS2HKI58E Dishwasher
FISHER PAYKEL DW60U4I2 Sanitise Integrated Dishwasher
FISHER AND PAYKEL DD60SCX9 Single Dish Drawer Dishwasher
Honeywell HCTDS1W Dishwasher
SHARP SDW6757ES Dishwasher
Master Kitchen 340965 Drawer Dishwasher
SIEMENS SN93HX60CG Dishwasher
Montpellier MDWBID6053 Dishwasher