Whirlpool WDF340PAMW 24-Inch Dishwasher
Dishwasher Quick Start Guide
OPERATING INSTRUCTIONS
Step 1. Prepare and
Load the Dishwasher
Filter Cleaning:
FILTER SHOULD BE REMOVED AND CLEANED EVERY 1 - 3 MONTHS FOR BEST PERFORMANCE.
IMPORTANT: Remove
leftover food, bones,
toothpicks, and other hard
items from dishes. Remove
labels from containers before
washing.
WARNING
Rinse Filter Cup and Plate under cold water.
Tip Over Hazard
To remove filter, pull out lower rack, grasp Filter Cup and rotate
counterclockwise. Pull up to remove. Remove the Filter Plate. Rinse both under
cold water in sink. A soft brush can be used to remove stuck on food. Replace
filter plate. Ensure filter plate is correctly seated under tabs. To install filter cup,
push down through opening. Turn clockwise to seat. Filter cup will click in to
place when seated properly. Do not operate dishwasher with loose or missing
Do not use dishwasher until completely
installed.
A
Do not push down on open door.
Doing so can result in serious injury or
cuts.
filters.
B
A. Upper Filter
Assembly
B. Lower Filter
Adjusting Racks:
You can raise or lower the middle rack to fit tall items in either
the middle or bottom rack. Adjusters are located on each side
of the middle rack. To raise the rack: Press both rack adjuster
thumb levers and lift the rack until it is in the up position and
level. To lower the rack: Press both rack adjuster thumb
levers and slide the rack to its down position and level.
Lower Rack
Upper Rack
Toss and Go Rack
NOTE: Racks vary by model.
NOTE: The middle rack must be level. Remove dishes before
adjusting rack.
� Make sure when the dishwasher door is closed that no items are blocking the
detergent dispenser.
Height Adjustments (on some models)
� Items should be loaded with soiled surfaces facing down and inward toward
FOLLOW THE PROGRESS OF YOUR DISHWASHER
The Clean indicator glows when a cycle is finished.
the spray, as shown in the graphics above.
� Avoid overlapping items like bowls or plates that may trap food.
� Place plastics, small plates, and glasses in upper rack.
NOTE: Silverware basket may vary by model.
Cycle Guide
This information covers several different models. Your dishwasher may not have all of the cycles and options described.
NOTE: To repeat the same cycle and options used in the previous wash cycle, select Start twice.
Cycles:
Descriptions:
Quick
For fast results, this cycle will clean dishes using slightly more water and energy. For improved
drying, select a Heat Dry / Extended Dry option.
NOTE: Some detergents are not recommended for short wash cycles; please refer to your detergent
packaging for more information.
Silverware Basket
Normal
Boost
This dishwasher’s government energy certifications were based on the Normal cycle with only the
Heat Dry option selected. ** This cycle is recommended for daily, regular, or typical use to completely
wash and dry a full load of normally soiled dishes.
NOTE: Make sure no spray arms are blocked & are rotating freely.
This cycle is an enhanced Normal Cycle, and it uses more liters of water and heats it to a higher
temperature throughout a longer cycle time to improve cleaning performance. Defaults to Extended
Dry for improved drying. Includes a heated dry option.*
Heavy
Use for hard-to-clean, heavily soiled pots, pans, casseroles, and regular tableware. Defaults to
Extended Dry for improved drying. Includes a heated drying option.*
Extended Soak This cycle quietly soaks dishes with an extended prewash which eliminates the need to presoak
dishes, saving personal time and effort. For optimal cleaning results during this cycle, add prewash
detergent. Use this cycle for loads with heavy amounts of dried-on or hard-to-clean baked-on food.
Defaults to Extended Dry for improved drying. Includes a heated drying option.*
Step 2. Add Detergent
High-quality premeasured tablets and packs are recommended for improved performance.
Options:
Descriptions:
Heat Dry
Dries dishes with a heated dry cycle. Load Plastic items in upper racks. This dishwasher’s
government energy certifications were based on the Normal cycle with only the Heat Dry option
selected. **
Extended Dry
Increases the cycle time and temperature to provide improved dry performance over the heat dry
option. For best drying results, use extended dry and rinse aid. Load plastic items in upper racks.
Step 3. Add Rinse Aid
*The government energy certifications are not based on this cycle and may increase your energy usage. See the Normal
cycle description for the government energy certification cycle.
**No other washing and drying temperature options were selected, and the dishwasher was not subjected to truncated
testing. Rinse aid was not used, and there was no detergent used in the prewash.
Full
� Check the rinse aid indicator with the door down
Full
(varies by model). Add rinse aid when indicator
drops to “Add” level or about every 1 to 3
months.
Add
Add
� Add rinse aid to hinged lid-style dispenser by
twisting the rinse aid cap 1/4 turn clockwise to
open and lift off. Pour rinse aid into the opening
until the indicator level is at “Full.” Replace the
rinse aid cap and turn to “Lock.” Make sure cap is
fully locked.
Online Ordering Information
For detailed installation instruction and maintenance information, winter storage, and transportation tips, please see
the Owner’s Manual included with your machine.
For information on any of the following items, a full cycle guide, detailed product dimensions, or for complete
� To add rinse aid to sliding lid-style dispenser, open
the rinse dispenser lid by gently pushing in the
center of the lid with your thumb and pulling up on
the edge. Pour rinse aid into the opening until the
dispenser is full. Then, close the dispenser by
pushing down gently on the lid.
Register
Product
Schedule
Service
How To’s &
FAQ
Manuals &
Downloads
Add
Service
Plan
Parts
Accesso-
ries
If you are experiencing poor drying performance, you may
want to try a higher setting. Turn the arrow adjuster to a
higher number to increase the amount of rinse aid.
To contact us, use the information listed below for the appropriate region.
Accesso-
ries
United States:
Canada:
Step 4. Select Cycle & Option(s)
Please refer to Cycles & Options chart for more detailed description.
1–866–698–2538
1–800–807–6777
Whirlpool Brand Home Appliances
Customer eXperience Center
553 Benson Road
Whirlpool Brand Home Appliances
Customer eXperience Centre
200–6750 Century Ave.
Benton Harbor, MI 49022–2692
Mississauga, Ontario L5N 0B7
Please scan the QR code
to access the installation
videos & the online-only
items.
Step 5. Start or Resume a Cycle
IMPORTANT: If anyone opens the door (such as for adding a dish), the
Start/Resume button must be selected each time.
S TA R T C A N C E L
Resume
Drain
W11538001B
| General | Details |
|---|---|
| Name | Whirlpool WDF340PAMW 24-Inch Dishwasher |
| Make | Whirlpool |
| Language | English |
| Filetype | PDF (Download) |
| File size | 2.62 MB |

Whirlpool 2B19 Dishwasher

Whirlpool WFO3O33PLAUS Standard Dishwasher

Whirlpool W11323304G Dishwasher

Whirlpool WH7IPC15BM60 Dishwasher

Whirlpool FINPUTSAD Dishwasher

Whirlpool W7U HS31 X Dishwasher

Whirlpool Thron Dishwasher

Whirlpool WDF332PAMS 24 Front Tall Tub Dishwasher

Whirlpool WRF540CWHZ Dishwasher

Whirlpool WDF130PAHB Dishwasher

Whirlpool WDF340PAMW 24-Inch Dishwasher Overview
Summary of Contents
- Page 1: Dishwasher Quick Start Guide Prepare and load the dishwasher. Filter cleaning: Filter should be removed and cleaned every 1 - 3 months for best performance. Remove leftover food, bones, toothpicks, and other hard items from dishes. Rinse filter cup and plate under cold water. You can raise or lower the middle rack to fit tall items. Make sure when the dishwasher door is closed that no items are blocking the detergent dispenser. This information covers several different models. Your dishwasher may not have all of the cycles and options described. For fast results, the quick cycle will clean dishes using slightly more water and energy. High-quality premeasured tablets and packs are recommended for improved performance. Check the rinse aid indicator with the door down.
- Page 2: Guide de démarrage rapide du lave-vaisselle Étape 1. Préparation et chargement du lave-vaisselle Nettoyage du filtre : le filtre devrait être enlevé et nettoyé tous les 1 à 3 mois pour obtenir de bons résultats. Enlever les restes alimentaires, os, cure-dents et autres articles durs de la vaisselle. Rincer les deux pièces sous l’eau froide dans l’évier. Ne pas utiliser le lave-vaisselle avant qu’il ne soit complètement installé. Positionnement des paniers : il est possible de soulever et d’abaisser le panier du centre pour placer des articles de grande taille. Vérifier qu’aucun article ne bloque le distributeur de détergent lorsque la porte du lave-vaisselle est fermée. SUIVI DE L’AVANCEMENT D’UN PROGRAMME DU LAVE-VAISSELLE : le témoin indicateur Clean s’allume lorsqu’un programme est terminé. Programme Normal : recommandé lors d’une utilisation quotidienne pour laver et sécher une pleine charge de vaisselle normalement sale. Étape 2. Ajout de détergent : pour de meilleurs résultats, utiliser des pastilles et des sachets prémesurés de qualité supérieure. Étape 3. Ajouter du liquide de rinçage : contrôler le témoin d’agent de rinçage lorsque la porte est complètement ouverte.














