Amana ADB1400PY Undercounter Dishwasher

1

2

3

4

5

6

Undercounter Dishwasher  

PRODUCT MODEL NUMBERS  

PRODUCT DIMENSIONS  

ADB1400PY  

ADB1500AD  

ADB1300AF  

ADB1100AW  

ADB1400AG  

ADB1400AM  

ADB1500AM  

Electrical Requirements: 120 V, 60 Hz, AC only, 15 A or 20 A. Fused electrical  

supply. Copper wire only. A time-delay fuse or circuit breaker and separate  

circuit is recommended.  

If direct wiring dishwasher: Use flexible,  

armored, or nonmetallic sheathed copper wire  

with grounding wire that meets the wiring  

requirements for your home and local codes and  

ordinances. Use a UL Listed or CSA Approved conduit connector.  

If connecting dishwasher with a power supply cord:  

33¹/²  

"

(85.1 cm)  

minimum  

with rear  

leveling  

legs  

Use power supply cord kit (Part Number 4317824)  

marked for use with dishwashers. Follow the kit  

instructions for installing the power supply cord.  

removed  

Power supply cord must plug into a grounded 3 prong outlet  

located in the cabinet next to the dishwasher opening. Outlet must  

meet all local codes and ordinances.  

Water Supply Requirements: A hot water line with 20 psi to 120 psi  

(138 kPa to 862 kPa) water pressure. Water temperature must be 120°F (49°C)  

water at dishwasher. Use 3/8" (9.5 cm) O.D. copper tubing with compression  

fitting or flexible braided water supply line.  

NOTE: 1/2" (1.3 cm) minimum plastic tubing is not recommended.  

Use a 90° elbow with 3/4" (9.5 cm) hose connection with rubber washer. (part  

number W10273460). Do not solder within 6" (15.2 cm) from water inlet valve.  

*Insulation may be compressed  

(not used on all models)  

Drain Requirements: A new drain hose is supplied with your dishwasher. If  

this is not long enough, use a new drain hose with a maximum length of 12'  

(3.7 m) (Part No. 3385556) that meets all current AHAM/IAPMO test standards,  

is resistant to heat and detergent, and fits the 1" (2.5 cm) drain connector of  

the dishwasher.  

Make sure to connect drain hose to waste tee or disposer inlet above drain trap  

in house plumbing and  

Air gap  

20" (50.8 cm) minimum above the  

floor. It is recommended that the drain  

hose either be looped up and securely  

fastened to the underside of the  

counter, or be connected to an air gap.  

Make sure to use an air gap if the drain  

hose is connected to house plumbing  

lower than 20" (50.8 cm) above  

subfloor or floor.  

Use 1/2" (1.3 cm) minimum I.D. drain line fittings.  

If required, the air gap should be installed in accordance with the air gap  

installation instructions. When connecting the air gap a rubber hose (not  

provided) will be needed to connect to the waste tee or disposer inlet.  

Because Whirlpool Corporation policy includes a continuous commitment to improve Dimensions are for planning purposes only. For complete details, see Installation  

our products, we reserve the right to change materials and specifications without  

notice.  

Instructions packed with product. Specifications subject to change without notice.  

W11542836B  

1

VIEW FULL SCREEN PDF MANUAL

General	Details
Name	Amana ADB1400PY Undercounter Dishwasher
Make	Amana
Language	English
Filetype	PDF (Download)
File size	0.38 MB

Download PDF

(1 votes, average: 5.00 out of 5)

Loading...

• ALL DISHWASHER INSTRUCTIONS & USER MANUALS
• Amana

Amana ADB1400PY Undercounter Dishwasher Overview

Summary of Contents

• Page 1: Undercounter dishwasher product model numbers include ADB1400PY, ADB1500AD, ADB1300AF, ADB1100AW, ADB1400AG, ADB1400AM, and ADB1500AM. Electrical requirements are 120 V, 60 Hz, AC only, with a recommended separate circuit. For direct wiring, use flexible, armored, or nonmetallic sheathed copper wire with a grounding wire. If connecting with a power supply cord, a minimum length of 33 1/2 is required. Water supply requirements include a hot water line with 20 psi to 120 psi water pressure and a temperature of 120°F. Use 3/8 copper tubing or a flexible braided water supply line for connections. Drain requirements specify a new drain hose supplied with the dishwasher, with a maximum length of 12'. The drain hose must connect to a waste tee or disposer inlet above the drain trap. An air gap is recommended if the drain hose is connected to plumbing lower than 20 above the floor. Whirlpool Corporation reserves the right to change materials and specifications without notice.
• Page 2: Cabinet cutout dimensions are provided for installation. Shaded areas of cabinet walls indicate where utility connections may be installed. Measure from the lowest point on the underside of the countertop. The height may be reduced to 33.5 inches by removing the rear leveling legs from the dishwasher. Minimum height, measured from the narrowest point of the opening, is 34 inches. Dimensions are for planning purposes only. For complete details, refer to the installation instructions packed with the product. Specifications are subject to change without notice. Whirlpool Corporation reserves the right to change materials and specifications.
• Page 3: Lave-vaisselle sous comptoir Numéros de modèle du produit Dimensions du produit Spécifications électriques : Alimentation de 120 V CA à 60 Hz protégée par un fusible de 15 A ou 20 A. Utiliser des conducteurs de cuivre gainés non métalliques ou blindés souples pour le raccordement. Spécifications de l’alimentation en eau : Une conduite d’eau chaude sous pression de 20 lb/po² à 120 lb/po². L’utilisation d’un tuyau de plastique d’un minimum de 1/2 po n’est pas recommandée. Exigences d’évacuation : Un tuyau d’évacuation neuf est fourni avec le lave-vaisselle. Veiller à raccorder le tuyau d’évacuation à la canalisation d’égout en T ou au raccord de broyeur à déchets. Utiliser un dispositif de brise-siphon si le tuyau d’évacuation est raccordé à moins de 20 po au-dessus du sol. Les dimensions sont indiquées à des fins de planification uniquement. La politique de Whirlpool Corporation est de travailler à l’amélioration de ses produits.
• Page 4: Dimension de l’ouverture à découper dans l’armoire. Les zones grisées des parois de l’armoire indiquent les endroits où les raccordements électriques peuvent être installés. Mesurer depuis le point le plus bas de la face inférieure du comptoir. Cette dimension peut être réduite à 33 ¹/2 po (85,1 cm) en retirant les pieds de nivellement arrière du lave-vaisselle. Vérifier que toutes les surfaces n’ont aucune aspérité qui empêcherait l’installation du lave-vaisselle. Dimension minimale mesurée au point le plus étroit de l’ouverture. 34 po (86,4 cm) minimum. La politique de Whirlpool Corporation, c’est aussi notre engagement à travailler sans relâche à l’amélioration de nos produits. Les dimensions sont indiquées à des fins de planification uniquement. Pour des détails complets, voir les Instructions d’installation fournies avec le produit.
• Page 5: Lavavajillas para instalarse debajo del mostrador Números de modelos de productos Dimensiones del producto Requisitos eléctricos: Un suministro eléctrico de 120 V, 60 Hz, CA solamente, con fusibles de 15 A o 20 A. Requisitos del suministro de agua: Una tubería de agua caliente con presión de agua de 20 lb/pulg² a 120 lb/pulg². Temperatura del agua que llega al lavavajillas debe ser de 120°F (49°C). Requisitos de desagüe: Se provee una manguera nueva de desagüe con su lavavajillas. Asegúrese de conectar la manguera de desagüe al colector de residuos en “T”. Se recomienda que la manguera de desagüe se enrolle y fije con firmeza a la parte inferior de la barra de cocina. Las dimensiones son solo para fines de planificación.
• Page 6: Dimensiones del corte del armario. Las áreas sombreadas de las paredes del gabinete muestran dónde se pueden instalar las conexiones de servicio. Se puede reducir a 33¹/2 (85,1 cm), quitando las patas niveladoras traseras del lavavajillas. Mínimo, medido desde el punto más angosto de la abertura. Revise todas las superficies para asegurarse de que no hayan protuberancias que pudieran impedir la instalación del lavavajillas. Las dimensiones son solo para fines de planificación. Nos reservamos el derecho de cambiar materiales y especificaciones sin previo aviso. Las especificaciones están sujetas a cambio sin previo aviso.