Home > ATAG > ATAG VA7214LR 60 cm Dishwasher

ATAG VA7214LR 60 cm Dishwasher

Installation  
Setup  
The recess and connection dimensions are included in the separate installation instructions.  
Check that all dimensions are correct before starting the installation. Note that the height of the  
cover door can be adjusted to match other fittings.  
Handle the front corners of the dishwasher with care so that they do not get bent, which can  
affect door opening.  
Make sure the area on which the dishwasher is to be installed is firm. Adjust the adjustable feet  
so that the dishwasher is level. Tighten the lock nuts.  
If the dishwasher is built-in the surrounding furnishings must be resistant to any condensation  
from the dishwasher.  
Mount the protective film beneath the worktop and up around the edge. The function of the  
protective film is to protect the worktop from moisture. (The protective film is in the enclosed  
plastic bag.)  
Check that the machine is installed such that the door opens freely, otherwise door lock  
functionality may be disrupted.  
Note that the door springs may need adjusting after a cover door has been fitted. Adjust the left  
and right door springs equally until the door is evenly balanced.  
Drainage connection  
This dishwasher is suitable for installing in a raised recess (to attain an ergonomic working height).  
This means that the dishwasher can be placed so that the drainage hose runs to a lower level than  
the bottom of the dishwasher, such as by routing it directly to a floor drain.  
The drainage hose can also be connected to a connection nipple on the sink unit's water trap. The  
connection nipple must have an internal diameter of at least 14 mm.  
The drainage hose may be extended by a maximum of 2.5 m (the total length of the drainage hose  
must not exceed 4.5 m). Any joints and connecting pipes must have an internal diameter of at least  
14 mm.  
No part of the drainage hose may be more than 950 mm above the bottom of the dishwasher.  
Attach the drainage hose with a hose clamp. Ensure that the drainage hose has no kinks.  
Connection to water supply  
Use only the inlet hose supplied with the dishwasher. Do not re-use old or other spare hoses.  
The supply pipe must be fitted with a water tap (stopcock). The water tap must be easily accessible,  
so that the water can be shut off if the dishwasher has to be moved.  
Once the installation is complete, turn on the water tap and allow the pressure to settle for a while.  
Check that all connections are watertight.  
Connect to cold water  
Connect the dishwasher to the cold water supply if the building is heated using oil, electricity or gas.  
Connect to hot water  
Connect the dishwasher to the hot water supply (max. 70 °C) if the building is heated using an  
energy-efficient means such as district heating, solar power or geothermal power. Choosing a hot  
water connection reduces the dishwasher's energy consumption.  
47  
GeneralDetails
NameATAG VA7214LR 60 cm Dishwasher
MakeATAG
LanguageEnglish
FiletypePDF (Download)
File size7.31 MB
Download PDF
1 Star2 Stars3 Stars4 Stars5 Stars (1 votes, average: 5.00 out of 5)
Loading...
ATAG DW7214MC Dishwasher
ATAG DW7214MC Dishwasher
ATAG VA8214LU Dishwasher
ATAG VA8214LU Dishwasher
ATAG VA7213SMN Dishwasher
ATAG VA7213SMN Dishwasher

ATAG VA7214LR 60 cm Dishwasher