Home > Gorenje > gorenje GI62040X Dishwasher

gorenje GI62040X Dishwasher

2. Insert the plug into the socket. The power supply is 220-240V AC 50 Hz, the specification of the  
socket is 12 A 250 VAC.50 Hz.  
Make sure that the water supply is turned on to full pressure. Close the door, press the"Power"button,  
Press the "Program" button to select a desired "Wash cycle". (See the section entitled "Wash  
Cycle Table") . With a little force to ensure the door is properly closed.  
6. Starting a Washing Program  
Wash cycle table  
NOTE: A click could be heard when the door is closed perfectly.  
When the washing is over, you can shut off the switch by pressing "Power" button.  
Running  
Time  
(min)  
Cycle Selection  
Information  
Description  
of Cycle  
Detergent  
Pre/main  
Energy  
(kWh)  
Water  
(L)  
Program  
Crystal  
Change the Program  
Crystal wash cycle to be used Main wash(40℃)  
Premise: A cycle that is underway can only be modified if it has only been running for a short time.  
Otherwise, the detergent may have already been released, and the appliance may have already  
drained the wash water. If this is the case, the detergent dispenser must be refilled (see the section  
entitled " Fill in the Detergent " ).  
for more delicate items which  
are sensitive to high  
temperatures.  
Rinse  
Hot rinse  
Drying  
3/16g  
4/17g  
118  
180  
0.900  
1.300  
11  
16  
Pre-wash  
Press"Power" button to cancel the program, and turn on it again ,then you can change the  
program to the desired cycle setting (see the section entitled "Starting a wash cycle. . . " ).  
NOTE: If you open the door when washing, the machine pauses and warning alarm rings.  
For the heaviest soiled loads,  
such as pots, pans, casserole  
dishes and dishes that have  
been sitting with dried food  
on them for a while.  
Main wash(60℃)  
Rinse1  
Rinse2  
Hot rinse  
Drying  
Intensive  
When you close the door  
, the machine will keep on working .  
The 6 program lights show the state of the dishwasher:  
a) One of the program lights on--> cycle running  
b) One of the program lights blinking -->pause  
Pre-wash  
For normally soiled loads,  
such as pots, plates, glasses  
and lightly soiled pans.  
standard daily cycle.  
Main wash(44℃)  
Hot rinse  
Drying  
(*EN60436)  
(Standard  
Program)  
4/17g  
237  
0.936  
11  
NOTE: If all the lights begin to glimmer, that indicates the machine is out of order, please turn off the  
main power and water supply before calling a service.  
A shorter wash for lightly  
soiled loads that do not  
Rapid need drying.  
Main wash(40℃)  
Hot rinse  
15  
39  
11  
0.500  
0.100  
7
4
Forget to Add Dish  
A forgotten dish can be added any time before the detergent cup opens.  
1 Open the door a little to stop the washing.  
To rinse dishes that you  
plan to wash later that day  
Pre-wash  
/
2 After the spray arms stop working, you can open the door completely.  
3 Add forgotten dishes.  
Pre-Rinse  
4 Close the door, the dishwasher will work after ten seconds.  
EN 60436: this program is the test cycle  
WARNING!  
open the door when appliance is working, The buzzer rings 10 times and the LED1,LED3 flash.  
It is dangerous to open the door when washing, because the hot water may scald you.  
1.The ECO program is suitable to clean normally soiled tableware,it is the most efficent program  
in terms of its combined energy and water consumption .  
2.Manual pre-rinsing of tableware items leads to increased water and energy consumption and is  
not recommended .  
3.Washing tableware in a household dishwasher usually consumes less energy and water than  
hand dishwashing when the household dishwasher is used according to this instruction manual.  
Switch Off the Dishwasher  
The buzzer rings 6 times, only in this case the programme has ended.  
The information for comparability test in accordance with EN60436,as follows:  
1.Switch off the dishwasher by pressing thePowerbutton.  
2.Turn off the water tap!  
-
-
-
Capacity: 13 settings  
Position of upper basket: Low position  
Rinse aid setting: 6 ( or 4 for four setting dispenser)  
Open the door carefully. Hot steam may escape when the door is opened!  
Hot dishes are sensitive to knocks. The dishes should therefore be allowed to cool down around  
15 minutes before removing from the appliance.  
Open the dishwasher's door, leave it ajar and wait a few minutes before removing the dishes. In  
this way they will be cooler and the drying will be improved.  
Turning on the Appliance  
Starting a wash cycle...  
Draw out the lower and upper basket, load the dishes and  
1. push them back. It is recommended to load the lower basket first, then the upper one (see the  
section entitled "Loading the Dishwasher"). Pour in the detergent (see the section entitled "Salt,  
Detergent and Rinse Aid").  
Unloading the dishwasher  
It is normal that the dishwasher is wet inside.  
Empty the lower basket first and then the upper one. This will avoid water dripping from the upper  
basket onto the dishes in the lower one.  
15  
14  
GeneralDetails
Namegorenje GI62040X Dishwasher
MakeGorenje
LanguageEnglish
FiletypePDF (Download)
File size3.46 MB
Download PDF
1 Star2 Stars3 Stars4 Stars5 Stars (1 votes, average: 5.00 out of 5)
Loading...
gorenje GV673B66 Dishwasher
gorenje GV673B66 Dishwasher
gorenje 642D65 Dishwasher
gorenje 642D65 Dishwasher
gorenje GV673A61 Dishwasher
gorenje GV673A61 Dishwasher
gorenje GV642C65 Dishwasher
gorenje GV642C65 Dishwasher
gorenje GV673B60 TotalDry Dishwasher
gorenje GV673B60 TotalDry Dishwasher
Gorenje Voll-I GV 64x B Dishwasher
Gorenje Voll-I GV 64x B Dishwasher
gorenje GV693C60XXL Dishwasher
gorenje GV693C60XXL Dishwasher
gorenje GI52040X Dishwasher
gorenje GI52040X Dishwasher
gorenje GV62040 Dishwasher
gorenje GV62040 Dishwasher
gorenje GV52040 Dishwasher
gorenje GV52040 Dishwasher

gorenje GI62040X Dishwasher