KUCHT K6502D Dishwasher
Installation Preparation
PREPARE ELECTRICAL WIRING
WARNING:
FOR PERSONAL SAFETY:
Remove house fuse or open circuit
breaker before beginning installation.
Do not use an extension cord or adapter
plug with this appliance.
1-1/2”(38.1mm) Dia
Hole
3“(76.2mm)
Electrical Requirements:
• This appliance must be supplied with 120V / 60 Hz.,
and connected to an individual properly grounded
branch circuit, protected by a 15 or 20 ampere circuit
breaker or time delay fuse.
24”(609.6mm)
Wall
• Wiring must be two wire with ground.
• If the electrical supply does not meet the above
requirements, call a licensed electrician before
proceeding.
Cabinet Preparation & Wire Routing:
Grounding Instructions This appliance must be connected
to a grounded metal, permanent wiring system, or an
equipment grounding conductor must be run with the
circuit conductors and be connected to the equipment
grounding terminal or lead on the appliance.
• The wiring may enter the opening from either
side, rear or the floor within the shaded area.
• Cut a 1-1/2”(38.1mm) max. dia. hole to admit the electrical
cable. The hole must be free of sharp edges. If
the cabinet wall is metal, the hole edge must be
covered with a bushing/grommet.
WARNING:
• Cable direct connections may pass through the
same hole as the drain hose and hot water line,
if convenient.
Improper connection of the equipment
grounding conductor can result in a risk
of electric shock. Check with a qualified
electrician or service representative if
you are in doubt that the appliance is
properly grounded.
Electrical Connection to Dishwasher:
• The electrical connection is located on the right
front side of the dishwasher.
• The cable must be routed as shown in Fig. 5
Cable must extend a minimum of 24”(609.6mm) from the
rear wall.
4
| General | Details |
|---|---|
| Name | KUCHT K6502D Dishwasher |
| Make | Kucht |
| Language | English |
| Filetype | PDF (Download) |
| File size | 1 MB |

KUCHT KD240PR Panel Ready Dishwasher



























