Mueller DW-2400 Dishwasher
STEP 10
STEP 11
Perform a PRE-TEST by reviewing this list after install-
ing your dishwasher:
Perform the WET-TEST by following these instruc-
tions:
ꢀ Check to be sure the power is OFF.
ꢀ Open the door and remove all foam and paper pack-
aging.
ꢀ Read the Instruction Manual for operating instruc-
tions.
ꢀ Check the door opening and closing. If the door does
not open and close freely or tends to fall, check spring
adjustments.
ꢀ Make sure that the wiring is secure under the dish-
washer, not pinched or in contact with other compo-
nents.
• Check door alignment with tub. If the door hits the tub,
level the dishwasher.
ꢀ Plug the power cord into the outlet.
• Power on and select the “Rinse” wash program.
• Close the door and press the “Start” button.
ꢀ Check to be sure that water enters the dishwash-
er. If water does not enter the dishwasher, check if
the water and the power are turned on.
ꢀ Check for leaks under the dishwasher. If a leak is
found, turn the power supply off, then tighten
connections. Restore power after the leak is
corrected.
ꢀ Check for leaks around the door. A leak around
the door could be caused by door rubbing or hitting
against adjacent cabinetry.
ꢀ Pull the lower rack out about halfway. The rack should
not roll back or forward on the door. If the rack moves,
adjust the leveling legs.
ꢀ Check door alignment with the cabinet. If the door hits
the cabinet, reposition or relevel the dishwasher.
ꢀ Make sure that the water supply and drain lines are
not kinked or in contact with other components. Contact
with the dishwasher frame could cause noise.
ꢀ Turn on the sink hot water faucet and verify water
temperature.
ꢀ Incoming water temperature must be between 120°F
(49°C) and 150°F (65°C). A minimum of 120°F (49°C)
temperature is required for best wash performance.
ꢀ Turn on the water supply. Check for leaks. Tighten
connections if needed.
ꢀ Reposition the dishwasher if necessary.
ꢀ The dishwasher will drain and turn off about 10
to 12 minutes after the first fill. Check the drain
lines. If leaks are found, turn the power off at the
breaker and correct plumbing as necessary.
ꢀ Restore power after corrections are made.
ꢀ Open the dishwasher door and check if most of
the water has drained. If not, check the drain line for
kinks.
• Run the dishwasher through another fill and
drain cycle.
ꢀ Check for leaks and correct if required.
• At the end of the drain, open the door and press
the “Power off” button.
12
| General | Details |
|---|---|
| Name | Mueller DW-2400 Dishwasher |
| Make | MUELLER |
| Language | English |
| Filetype | PDF (Download) |
| File size | 0.33 MB |
(1 votes, average: 5.00 out of 5)
Loading...
Mueller DW-1800 Series 18 Inch Dishwasher
Mueller DW-1800 18 in. Black Front Digital Dishwasher
Miele G 5051 Dishwasher
FISHER PAYKEL DW60U6I1 Dishwasher
FISHER AND PAYKEL DD24SCTX9 N Tall Dishwasher
BOSCH SPV6YMX11E Dishwasher
SIEMENS SX75EX00CS Fully Integrated Dishwasher
TOMADO TDW5501W Tabletop Dishwasher
FISHER AND PAYKEL DD60SI9 Dishwasher
Miele AK-CC 550A APFD 102 Dishwasher
Whirlpool WDFS3R4NWESG Sense Dishwasher
bolero AGUAZERO 8000 Dishwasher