Whirlpool WDF550SAA Undercounter Dishwasher

1

Undercounter Dishwasher  

PRODUCT MODEL NUMBERS  

PRODUCT DIMENSIONS  

WDF550SAA฀฀฀฀฀฀฀฀฀฀฀฀฀WDF550SAF  

Side View  

Rear View  

Electrical Requirements:฀120-volt, 60-฀z, AC-only, 15- or฀  

20-amp fused electrical supply. Copper wire only. A time-  

delay fuse or circuit breaker and separate circuit is฀  

recommended.  

24" (61 cm)*  

23 ⁵/₉"฀(59.8฀cm)  

If direct wiring dishwasher: Use flexible, armored, or฀  

nonmetallic, sheathed copper wire  

with grounding wire that meets the  

wiring requirements for your home  

and local codes and ordinances.  

Use a UL Listed or CSA Approved strain relief.  

32¹⁄₂" to 34¹⁄₂"  

(82.6 to 87.6 cm)  

If connecting dishwasher with a power supply cord:  

Use Power Supply Cord Kit (Part  

Number 4317824) marked for use  

with dishwashers. Follow the kit instructions  

for installing฀the power supply cord.  

Power supply cord must plug into a grounded฀  

3฀prong, outlet, located in the cabinet next to฀  

the dishwasher opening. Outlet must meet all฀  

localcodes and ordinances.  

16 ⁵/₈"฀(42.2 cm)  

2 ¹⁄₂" (6.2 cm)  

Water Supply Requirements:A hot water line with 20 to  

120 psi (138 to 862 kPa) water pressure. Watertemperature  

must be 120°F (49°C) water at dishwasher.U฀ se ³⁄₈" O.D.  

copper tubing with compression fitting or฀flexible braided  

water supply line (Part Number 4396897RP)฀(¹⁄₂" minimum  

plastic tubing is not recommended). Use a฀90°฀elbow with  

³⁄₄" hose connection with rubber washer. Do฀not solder  

within 6" (15.2 cm) of the water inlet valve.  

* To front of door frame  

CABINET CUTOUT DIMENSIONS  

Drain Requirements:  

34" to 35"  

(86.4 cm to 88.9 cm)  

■ Use the new drain hose supplied with your dishwasher.  

NOTE: If a longer drain hose is required:  

■ Use a new drain hose with maximum length of  

10 ft฀(3 m) that meets all current AHAM/IAPMO฀  

test฀standards.  

A

24" (61 cm)  

minimum  

■ Use a new drain hose that is resistant to heat  

and฀detergent.  

■ Use a new drain hose that fits the 1" (2.5 cm)  

drain฀connector on the dishwasher.  

■

Connect drain hose to waste tee or disposal inlet  

above฀drain trap in house plumbing.  

6"  

■

Connect drain hose to house plumbing 20" (50.8 cm)฀  

minimum above the floor.  

(15.2 cm)  

NOTE: It is recommended that the drain hose either  

be฀looped up and securely fastened to the underside  

of the฀counter฀or be connected to an air gap.  

24 (61 cm)  

maximum  

A. All surfaces free from intrusions  

■ Use a drain air gap if the drain hose is connected  

to฀house plumbing lower than 18" (45.7 cm) above  

the฀subfloor or floor.  

* Underside of countertop to floor  

NOTES:  

Drain Air Gap  

■

Cut holes in shaded area of cabinet walls or floor for plumbing and electrical service.  

air gap  

■

ADA installation฀–฀32¹⁄₂" (82.5 cm) beneath 34" (86.4 cm) high countertops may be  

accomplished by adjusting the toekick and leveling legs.  

■

Use ¹⁄₂" (1.3 cm) minimum I.D. drain line fittings.  

NOTE: Do not connect drain lines from other devices  

to the฀dishwasher drain hose.  

Because Whirlpool Corporation policy includes a continuous commitment to improve  

our products, we reserve the right to change materials and specifications without notice.  

Dimensions are for planning purposes only. For complete details, see Installation  

Instructions packed with product. Specifications subject to change without notice.  

W10518038-D-WH  

5/1/16  

https://manual-hub.com/  

VIEW FULL SCREEN PDF MANUAL

General	Details
Name	Whirlpool WDF550SAA Undercounter Dishwasher
Make	Whirlpool
Language	English
Filetype	PDF (Download)
File size	0.12 MB

Download PDF

(1 votes, average: 5.00 out of 5)

Loading...

• ALL DISHWASHER INSTRUCTIONS & USER MANUALS
• Whirlpool

Whirlpool WDF550SAA Undercounter Dishwasher Overview

Summary of Contents

• Page 1: Undercounter dishwasher product model numbers and dimensions are provided. Electrical requirements include a 120-volt, 60 Hz, AC-only, 15- or 20-amp fused electrical supply. For direct wiring, use flexible, armored, or nonmetallic sheathed copper wire with a grounding wire. If connecting with a power supply cord, use a Power Supply Cord Kit marked for dishwashers. Water supply requirements specify a hot water line with 20 to 120 psi water pressure and a temperature of 120°F. Use ³⁸ O.D. copper tubing or a flexible braided water supply line for connections. Drain requirements include using the new drain hose supplied with the dishwasher. A drain hose must be resistant to heat and detergent and fit the 1 drain connector. It is recommended to loop the drain hose up and securely fasten it or connect it to an air gap. Whirlpool Corporation reserves the right to change materials and specifications without notice.