aspes ALV1047 Dishwasher
Using little detergent can result in poor
cleaning and you can see whitish streaksin
hard water.
dishes.
4.12. Filling the rinse-aid and setting
To fill the rinse aid compartment, open
the rinse-aid compartment cap. Fill the
compartment with rinse aid to the MAX level
and then close the cap. Be careful not to
overfill the rinse aid compartment and wipe
up any spills.
See the detergent manufacturer’s
instructions for a further information.
4.9. Filling the detergent
Push the latch to open the dispenser and
pour in the detergent.
In order to change the rinse aid level,
follow the below steps before turning on
the machine:
Close the lid and press it until it locks in
place. The dispenser should be refilled just
before the start of each programme. If the
dishes are heavily soiled, place additional
detergent in the pre-wash detergent
chamber.
•
Turn on the machine by pressing the
On/Off button.
•
Press the Up button for at least 5
seconds immediately after the machine
is turned on.
•
Release the Up button when all leds
blinks twice. The last setting level is
displayed.
DETERGENT
•
•
Press Up or Down button to increase or
decrease the hardness level.
Turn off the machine to save the setting.
4.10. Using combined detergents
These products should be used according
to the manufacturer’s instructions.
Never put combined detergents into the
interior section or the cutlery basket.
The factory setting is “4”.
If the dishes are not drying properly or are
spotted, increase the level. If blue stains
form on your dishes, decrease the level.
Combined detergents contain not only
the detergent but also rinse-aid, salt
replacement substances and additional
components depending on the combination.
We recommend you do not use combined
detergents in short programmes. Please
use powder detergents iinstead. If you
encounter problems when using combined
detergents, please contact the detergent
manufacturer.
When you stop using combined detergents,
make sure that water hardness and rinse
aid settings are set to correct level.
Level
Brightener Dose
Indicator
1
Rinse-aid not
dispensed
Wash LED is on.
4.11 Rinse-aid usage
2
3
4
5
1 dose is
Dry LED is on.
End LED is on.
The rinse aid helps to dry the dishes without
streaks and stains. Rinse-aid is required for
stain-free utensils and clear glasses. The
rinse aid is automatically released during
the hot rinse phase. If rinse aid dosage
setting set too low, whitish stains remains
on dishes and dishes do not dry and
washed clean.
dispensed
2 doses are
dispensed
3 doses are
dispensed
Wash and Dry LEDs
are on.
4 doses are
dispensed
Wash and End
LEDs are on.
If rinse aid dosage setting set too height,
you can see bluish layers on glass and
EN - 11
| General | Details |
|---|---|
| Name | aspes ALV1047 Dishwasher |
| Make | aspes |
| Language | English |
| Filetype | PDF (Download) |
| File size | 1.25 MB |
(1 votes, average: 5.00 out of 5)
Loading...
aspes AJI12600E Dishwasher
aspes AJ14600BD Dishwasher
Honeywell HCTDS1W Dishwasher
BOSCH SMS6ZCI16E Dishwasher
FISHER and PAYKEL DD60ST4HNB9 Contemporary Tall Dishwasher
Honeywell HDS18SS Dishwasher
Thermador DWHD640EFM Dishwasher
Hisense HS693C60XAD Dishwasher
BOSCH SMV4HTX31E Dishwasher
FISHER PAYKEL DD24DCTW9 N Drawer Dishwasher
AEG FFB74707PM Dishwasher
SIEMENS SN45ZS55CS Dishwasher