Haier QDP555 Series Dishwasher
TROUBLESHOOTING TIPS
Problem
Possible Cause
What To Do
Detergent left in
dispenser cups
Dishes or utensils are
blocking the detergent cup
Reposition the dishes, so the water from the lower spray arm
can flush the detergent cup. See the LOADING section.
Reposition the tall utensils or heavy silverware that may
be keeping the dispenser cup door from opening. See the
LOADING section.
Don’t place large bowls or pots directly under the detergent
dispenser.
Black or gray marks
on dishes
Aluminum utensils have
rubbed against dishes
Remove marks with a mild, abrasive cleaner.
Dishes don’t dry
Low inlet water temperature
Make sure inlet water temperature is at least 120°F.
Select Dry.
Use Temp.
Select a higher cycle, such as Sanitize.
Check the rinse agent dispenser and fill as required.
Rinse agent dispenser is
empty
Additional drying time is
needed
Leave door closed after the Clean light appears to allow the fan
to run an additional 90 minutes.
Note: If you open the door, this fan extension will be cancelled.
Make sure the door is firmly closed.
Control panel
Door may not be completely
closed
responded to inputs
but dishwasher never
filled with water
Water valve may be turned off Make sure water valve (usually located under the sink) is turned
on.
Flood float may be stuck
Remove Ultra-Fine filter and lightly tap the piece under the
ultra fine filter that looks like a salt shaker. Replace the filter.
Stained tub interior
White film on inside surface— Haier Appliances recommends high quality rinse agents such as
hard water minerals Cascade Platinum™ Power Dry™ Rinse Aid or Finish Jet-Dry
Rinse Aid to help prevent hard water mineral deposits from
forming
®
®
®
.
Run dishwasher with citric acid to remove mineral deposits. Citric acid
(Part number: WD35X151) can be ordered through Haier Appliances
Parts. See back cover for ordering information. Alternatively,
purchase Cascade® Platinum™ Dishwasher Cleaner or Finish®
Dishwasher Cleaner and follow the directions on the label
.
Dishwasher won’t run Fuse is blown or circuit
breaker is tripped
Replace fuse or reset circuit breaker. Remove any other
appliances from the circuit.
Power is turned off
In some installations, the power to the dishwasher is provided
through a wall switch, often located next to the disposer
switch. Make sure it is on.
Control panel is locked
Unlock control panel. See the Getting started section.
Proper Start sequence was
not followed
See the Using the dishwasher section.
Control panel lights
go off when you’re
setting controls
Time too long between
touching of selected pads
Each pad must be touched within 30 seconds of the others. To
relight, touch any pad again or open the door and unlock.
Water standing in the Air gap is clogged
bottom of the tub
Clean the air gap. See the CARE AND CLEANING section.
High drain loop or air gap not
Refer to the Installation Instructions for proper drain line
installation.
installed
Water won’t pump
out of the tub
Drain is clogged
If you have an air gap, clean it. See the CARE AND CLEANING
section.
If the dishwasher drains into a disposer, run disposer clear.
Check to see if your kitchen sink is draining well. If not, you may
need a plumber.
49-4000269 Rev 0
21
| General | Details |
|---|---|
| Name | Haier QDP555 Series Dishwasher |
| Make | Haier |
| Language | English |
| Filetype | PDF (Download) |
| File size | 7.29 MB |

Haier HDW13V1S1 Dishwasher

Haier HDW15V3S1 Satina Dishwasher

Haier HDW10F1S1 300 Series Compact Dishwasher

Haier HDW15V2B2 Dishwasher

Haier HDW13G1W Dishwasher

Haier HDW15V2S1 Dishwasher

Haier HDW13G1X Dishwasher

Haier HDW10F1S1 Compact Dishwasher

Haier HDW13F0W1 Hygiene Dishwasher

Haier HDW13F0B1 Dishwasher





















































































