Home > Hotpoint > Hotpoint W11518627 Dishwasher

Hotpoint W11518627 Dishwasher

DAILY USE  
1. CHECK WATER CONNECTION  
The machine will switch off automatically during certain extended  
periods of inactivity, in order to minimise electricity consumption.  
If the crockery is only lightly soiled or if it has been rinsed with  
water before being placed in the dishwasher, reduce the amount  
of detergent used accordingly.  
Check that the dishwasher is connected to the water supply  
and that the tap is open.  
2. SWITCH ON THE DISHWASHER  
Press the ON/OFF button.  
3. LOAD THE RACKS (see LOADING THE RACKS)  
MODIFYING A RUNNING PROGRAM  
4. FILLING THE DETERGENT DISPENSER  
If a wrong program was selected, it is possible to change it, provid-  
ed that it has only just begun: press and hold the ON/OFF button,  
the machine will switch off. Switch the machine back on using the  
ON/OFF button and select the new wash cycle and any desired  
options; start the cycle by pressing the START/PAUSE button.  
5. CHOOSE THE PROGRAM AND CUSTOMISE THE CYCLE  
Select the most appropriate program in accordance with the type  
of crockery and its soiling level (see PROGRAMS DESCRIPTION) by  
pressing the P button.  
Select the desired options (see OPTIONS AND FUNCTIONS).  
6. START  
ADDING EXTRA CROCKERY  
Start the wash cycle by pressing the START/PAUSE button.  
When the program starts you hear a beep.  
Without switching off the machine, open the door (be ware of HOT  
steam!) and place the crockery inside the dishwasher. Close the door  
and press the START/PAUSE button the cycle will begin from  
the point at which it was interrupted.  
7. END OF WASH CYCLE  
The end of the wash cycle is indicated by beeps and by the flashing  
of the wash cycle indicator on the panel. Open the door and switch  
off the appliance by pressing the ON/OFF button.  
Wait for a few minutes before removing the crockery - to avoid  
burns. Unload the racks, beginning with the lower one.  
ACCIDENTAL INTERRUPTIONS  
If the door is opened during the wash cycle, or if there is a power cut,  
the cycle stops. Once the door has been closed or the electricity sup-  
ply is restored, to start again the cycle from where it was interrupted,  
press the START/PAUSE button.  
ADVICE AND TIPS  
TIPS  
Before loading the baskets, remove all food residues from the crockery  
and empty the glasses. You do not need to rinse beforehand under  
running water.  
Arrange the crockery so that it is held in place firmly and does not tip  
over; and arrange the containers with the openings facing downwards  
and the concave/convex parts placed obliquely, thus allowing  
the water to reach every surface and flow freely.  
Warning: lids, handles, trays and frying pans do not prevent  
the sprayer arms from rotating.  
DAMAGE TO GLASS AND CROCKERY  
• Only use glasses and porcelain guaranteed by the manufacturer  
as dishwasher safe.  
• Use a delicate detergent suitable for crockery  
• Collect glasses and cutlery from the dishwasher as soon as the wash  
cycle is over.  
TIPS ON ENERGY SAVING  
• When the household dishwasher is used according  
to the manufacturer’s instructions, washing tableware  
in a dishwasher usually consumes less energy and water than  
hand dishwashing.  
Place any small items in the cutlery basket.  
Very soiled dishes and pans should be placed in the lower basket  
because in this sector the water sprays are stronger and allow a higher  
washing performance.  
• In order to maximize dishwasher efficiency it is recommended  
to initiate the wash cycle once dishwasher is fully loaded.  
Loading the household dishwasher up to the capacity indicated  
by the manufacturer will contribute to energy and water savings.  
Information on correct loading of tableware can be found  
in Loading chapter.  
After loading the appliance, make sure that the sprayer arms can  
rotate freely.  
UNSUITABLE CROCKERY  
• Wooden crockery and cutlery.  
In case of partial loading it is recommended to use dedicated wash  
options if available (Half load/ Zone Wash, Multi Zone), fiilling up only  
selected racks. Incorrect loading or overloading the dishwasher may  
increase resources usage (such as water, energy and time, as well  
as increase noise level), reducing cleaning and drying performance.  
• Manual pre-rinsing of tableware items leads to increased water  
and energy consumption and is not recommended.  
• Delicate decorated glasses, artistic handicraft and antique crockery.  
Their decorations are not resistant.  
• Parts in synthetic material which do not withstand high temperatures.  
• Copper and tin crockery.  
• Crockery soiled with ash, wax, lubricating grease or ink.  
The colours of glass decorations and aluminium/silver pieces can  
change and fade during the washing process. Some types of glass (e.g.  
crystal objects) can become opaque after a number of wash cycles too.  
HYGIENE  
To avoid odour and sediment which can be accumulated  
in the dishwasher please run a high temperature program at least  
one a month. Use a tea spoon of detergent and run it without  
the loading to clean your appliance.  
6
GeneralDetails
NameHotpoint W11518627 Dishwasher
MakeHotpoint
LanguageEnglish
FiletypePDF (Download)
File size2.05 MB
Download PDF
1 Star2 Stars3 Stars4 Stars5 Stars (1 votes, average: 5.00 out of 5)
Loading...
Hotpoint H7F HS41 UK Full Size Dishwasher
Hotpoint H7F HS41 UK Full Size Dishwasher
Hotpoint H8I HT59 LS UK Dishwasher
Hotpoint H8I HT59 LS UK Dishwasher
Hotpoint H7I HP42 L UK Dishwasher
Hotpoint H7I HP42 L UK Dishwasher
Hotpoint H7F HP33 UK Dishwasher
Hotpoint H7F HP33 UK Dishwasher
Hotpoint H7F HS51 Dishwasher
Hotpoint H7F HS51 Dishwasher
Hotpoint H7FHS41 Dishwasher
Hotpoint H7FHS41 Dishwasher
Hotpoint HA3FC10BS7A0S Dishwasher
Hotpoint HA3FC10BS7A0S Dishwasher
Hotpoint H7F HS41 X Dishwasher
Hotpoint H7F HS41 X Dishwasher
Hotpoint 869991662940 Dishwasher
Hotpoint 869991662940 Dishwasher
Hotpoint H7I HT59 L Dishwasher
Hotpoint H7I HT59 L Dishwasher

Hotpoint W11518627 Dishwasher