Home > MDW > MDW 14-BS10TFT Dishwasher

MDW 14-BS10TFT Dishwasher

• Make sure that the power sup- • If your appliance has any mal-  
ply cable is not crushed under  
the appliance.  
function, do not attempt to  
repair the appliance yourself.  
Do not dismantle the appli-  
ance; it may cause the risk of  
electric shock when using if it  
is reinstalled improperly. The  
appliance has no user-service-  
able parts.  
• If the power cable is damaged,  
it must be replaced by an au-  
thorised service recommended  
by the manufacturer to prevent  
possible dangers. Please con-  
tact an authorised service or a  
customer contact centre.  
• Switch off the fuse or unplug  
the appliance before perform-  
ing any repair on the appliance.  
Never forget to turn off the  
water tap.  
• Do not use your appliance in  
the following situations:  
-If the appliance, the plug or the  
power cable is damaged,  
• Using accessories and replace-  
ment parts not recommend-  
ed by the manufacturer may  
cause appliance damage and  
injuries.  
-If the appliance is dropped, if it  
has signs of visible damage or it  
does not work properly,  
-If the appliance and the electrical  
parts are visibly damaged,  
• This appliance can be used  
by children at the age of 8 or  
above and people with limited  
physical, hearing or mental  
abilities or experience and  
knowledge only when they are  
supervised or when relevant  
instructions are provided and  
the dangers are understood.  
-If the appliance is wet, has been  
dropped in water or other liquids,  
subjected to flood and if its elec-  
trical parts have contacted water,  
-If a strange noise, smoke or odour  
is observed.  
If one of the above conditions is  
detected, turn off your appliance,  
disconnect the power immediately  
and contact an authorised service.  
A damaged appliance or its parts  
can cause severe injuries or fire.  
• Children should not play with  
the appliance. Do not allow  
children to operate the appli-  
ance.  
2
• Cleaning or user maintenance  
should not be performed by  
children without supervision.  
extension cord.  
• Do not use plugs that have  
damaged, torn or worn cables.  
Never pull, bend or damage  
the cable.  
• Keep the detergent and rinse  
aid away from your children.  
• Keep your children away from • Do not climb, sit or place loads  
the appliance when it is open  
since there might be residues  
of cleaning agents.  
on the appliance door when it  
is open.  
• Do not plug or unplug the  
plug with wet hands to avoid  
electric shock.  
• Make sure your old appliances  
do not pose any risks for your  
children. It is a known fact that  
children were locked in old ap-  
pliances before. Break the lock  
of your old appliances, cut the  
power cable and remove the  
plug from the cable to avoid  
such situations.  
WARNING: Packaging materials  
are dangerous for children. Store  
all packing material away from  
children.  
• Check your appliance and its  
packaging for damages. Never  
operate an appliance with any  
kind of damage. Consult an  
authorised service immedi-  
ately.  
• Do not use your appliance  
outdoors or on wet surfaces  
to prevent the risk of electric  
shock.  
• Open the packaging mate-  
rial as stated and dispose as  
described in the packaging  
information section.  
• Hold the plug when unplug-  
ging your device and pull out.  
Do not pull the cable.  
• The appliance must be sup-  
plied through a residual current  
device (RCD) with a rated  
residual operation current not  
exceeding 30 mA.  
• Unplug the appliance if it will  
not be used for a long time.  
• Make sure you have unplugged  
the appliance and disconnect-  
ed it from the power supply in  
the following cases:  
• Do not use a multiple outlet or  
3
- Before installation,  
internal body of your appliance  
occurred as a result of basket  
movements.  
- Before cleaning and mainte-  
nance,  
• When the appliance is running,  
do not open its door since hot  
water may splash out. The  
safety system will stop your  
appliance if you open the door.  
- Before repairing.  
• Do not fill detergent and rinse  
aid sections with substances  
other than detergents and  
rinse aid produced specifically  
for dishwashers. Otherwise,  
the manufacturer will not be  
responsible for any damages  
that may occur on your appli-  
ance.  
• Do not leave the door of your  
appliance open. Leaving the  
door open may cause acci-  
dents.  
• Do not install other appliances  
emitting heat, such as stove,  
on or near the appliance. Heat  
emitted from the stove or simi-  
lar appliances may damage the  
dishwasher.  
• Water in the washing section  
is not drinking water. Do not  
drink it.  
• Do not place solvent chemi-  
cals in the washing section of  
your appliance as there is a risk  
of explosion.  
• Place dishes such as bowls,  
glasses and pots in the dish-  
washer with their openings  
facing down.  
• Before washing plastic objects  
in your appliance, check if they  
are suitable for washing in  
dishwashers.  
• Do not load your appliance  
with dishes different or more  
than those specified.  
• Do not place objects that are  
not suitable for washing in  
dishwasher in your appliance.  
Also, do not overload the bas-  
• For safety reasons, unplug  
the device when the washing  
programme is over.  
kets. Otherwise, the manufac- Your dishwasher is not suitable  
turer will not be responsible for  
scratches and corrosion on the  
for use by people with limited  
physical and mental abilities,  
4
children and people with insuf- Safety Information to be Fol-  
ficient knowledge and experi- lowed During Installation  
ence on using the appliance  
• Installation and repair pro-  
without supervisors that can  
cedures must always be per-  
ensure their safety.  
formed by an Authorised Ser-  
• Sheet surfaces of the appliance  
are sensitive. They need to be  
cleaned with special cleaning  
substances. Sheet surfaces  
cleaned with unsuitable clean-  
ers can be scratched, damaged  
or their appearance may go  
bad in time. Use cleaning sub-  
stances recommended by our  
Authorised Service to avoid  
such situations.  
vice. Manufacturer will not be  
responsible for damages that  
may occur due to operations  
performed by unauthorised  
people. The power plug must  
be easily accessible after in-  
stallation.  
You can call the call centre  
before starting to use your  
appliance to reach the closest  
authorised service and request  
assistance for installation, op-  
eration and usage of your  
device.  
• If the energy saving option is on,  
the door will automatically open  
at the end of the programme. In  
order not to damage automatic  
door opening mechanism, do  
not attempt to close the door  
for a minute. The door must be  
open for 30 min. for an effec-  
tive drying performance (only  
in products with an automatic  
door opening mechanism).  
WARNING: Do not stand in  
front of the door after hearing  
the automatic door opening  
signal.  
• Select a suitable, safe and level  
spot for the installation.  
• Make sure the installation  
and electricity and water con-  
nections of the appliance are  
performed according to the  
instructions.  
• Consult an expert electrician  
to make sure that the fuse  
system in your house is in com-  
pliance with the regulations.  
• The appliance must only be  
5
connected and operated in  
accordance with the details  
on the type plate. Check if the  
voltage value of your electric-  
ity network is compliant with  
the value stated on rated value  
plate of the appliance before  
using the appliance.  
appliance will decrease in low  
voltage.  
• While determining the location  
to install your appliance, make  
sure that it is a location where  
you can easily load and unload  
your dishes after washing.  
• Do not install your appliance  
in spaces where temperature  
might drop below 0°C.  
• Manufacturer will not be re-  
sponsible for any damages that  
may occur due to unsuitable  
connections and/or failure to  
provide grounding.  
• Operate your appliance emp-  
ty during the initial use after  
installing it at a suitable place.  
• Never use extension cables or  
multiple sockets to connect  
your appliance to the electrici-  
ty network. These connections  
may result in overheating.  
• Place this appliance in a suit-  
able place to protect from hu-  
midity, oil, dust, direct sunlight  
or exposure to water/humidity.  
Do not use the device out-  
doors, in humid environments  
or under rain.  
• The fuse current value in your  
house must be 10-16 Amps.  
Your appliance is set to 220 –  
240 Volts. If the mains voltage  
in your area is 110 Volts, have a  
110/220 Volts and 3000 Watts  
transformer connected on the  
line. The appliance must not  
be plugged in during instal-  
lation.  
• Before installation, unpack  
your appliance according to  
the warnings on the cardboard.  
• Place the appliance near the  
tap and waste water outlet.  
Consider that the location  
cannot be changed after the  
connections have been made.  
• Always use the covered plug  
supplied with the appliance.  
• Do not hold the door or the  
control panel to move the  
appliance.  
• Washing efficiency of your  
6
• Make sure there is enough  
clearance around the appli-  
ance to easily move the appli-  
ance forward-backward during  
cleaning.  
etc.) that may come from the  
city mains or your water instal-  
lation at times and to avoid  
complaints such as yellowing,  
sediment, etc. as a result of  
washing.  
• Make sure the water inlet-out-  
let hoses do not get crushed  
when placing the appliance.  
Also, make sure that the power  
cable does not get stuck under  
the appliance.  
• Adjust the feet for the appli-  
ance to be level and stable.  
The door can be opened and  
closed with not problems if the  
appliance is installed correctly.  
Water Inlet Hose  
• If the door of the appliance  
cannot be closed correctly,  
check if the appliance is level  
on the floor. If not, use the  
adjustable feet to balance it.  
• Do not use the water inlet hose  
of your old appliance (if any).  
Instead, use the new water  
inlet hose supplied with your  
appliance.  
• Run some water inside the  
hose if your are going to use  
a new hose or a hose not used  
for a long time.  
Water Connections  
• Make sure that the water in-  
stallation in your house is com-  
pliant with the dishwasher. We  
recommend you to install a  
filter to the entrance of your  
house or building to prevent  
damage to the appliance by  
contamination (sand, clay, rust,  
• Connect the water inlet hose  
directly to the water inlet tap.  
• Pressure from the tap must be  
0.03 MPa (0.3 bar) minimum,  
and 1 MPa (10 bar) maximum.  
If the water pressure is above  
7
GeneralDetails
NameMDW 14-BS10TFT Dishwasher
MakeMDW
LanguageEnglish
FiletypePDF (Download)
File size2.36 MB
Download PDF
1 Star2 Stars3 Stars4 Stars5 Stars (1 votes, average: 5.00 out of 5)
Loading...

MDW 14-BS10TFT Dishwasher