UGP-24CR Classic Retro By Unique Dishwasher
INSTALLING THE DISHWASHER Cont'd
Connecting the water line to the water supply
1. Turn off the water supply.
2. Install a hand shut-off valve in an accessible location, such as under the sink. This is optional,
but strongly recommended, and may be required by local codes.
3. Install the hot water inlet line, using at least 3/8 in. O.D. copper tubing. Route the line as
shown in the figure above and extend it forward at least 18 in. (45.72 cm) from the rear wall
of the enclosure.
4. Adjust the water heater to a temperature of 120° F to 150° F (49° C to 65° C).
5. Flush the water line to clean out any debris.
Note: The hot water pressure must be between 20 and 120 psi (138 and 827 kPa).
Step 1: Check the door balance
Caution:
• Opening the door of your dishwasher before it is installed will cause it to tip forward. Do not
open the door until you are ready to install your dishwasher.
• If it is necessary to open the door, hold the top of the dishwasher securely with one hand and
hold the door with the other hand.
1 Hold the top of the dishwasher firmly.
2 Open the door slowly, then release it. If the door drops, increase the spring tension.
If the door closes, decrease the spring tension.
3 Continue moving the spring pin until the door is balanced. Adjust both springs to the
same tension.
Note: If you choose the mood decoration door (about 3.5KG), you can choose the fifth groove
counting from the top groove. If you choose the metal decoration door (about 7.5KG), you need
fix the springs to the third groove in the same method.
Increase
Decrease
10
| General | Details |
|---|---|
| Name | UGP-24CR Classic Retro By Unique Dishwasher |
| Make | UNIQUE |
| Language | English |
| Filetype | PDF (Download) |
| File size | 0.96 MB |

UNIQUE Classic Retro Dishwasher









































