UGP-24CR Classic Retro By Unique Dishwasher
INSTALLING THE DISHWASHER Cont'd
4 If connecting the drain line to a garbage disposal, make sure that the drain plug has been
removed. Your dishwasher will not drain if the plug is left in place.
Remove
the Plug
You'll need:
Coupler for
extending drain line
(if applicable)
Screw-type
hose clamps
Phillips screwdriver
Step 14: Performing a pre-test check
Review this list after installing your dishwasher to avoid problems or charges for a service call
not covered by your warranty.
• Make sure that power is turned OFF.
• Open the door and remove all foam and paper packaging.
• Locate the User Guide in the literature package.
• Read the User Guide for operating instructions.
• Check the door opening and closing. If the door does not open and close freely, or tends to
fall, check the spring adjustments. See Step 1: Check the door balance
• Make sure that the wiring is secure under the dishwasher and not pinched or in contact with
door springs or other components. See Step 9: Position the dishwasher under the countertop.
• Check the door alignment with the tub. If the door hits the tub, level the dishwasher. See
Step 10: Level the dishwasher
• Pull the lower rack out about half way. Make sure that it does not roll back or forward on the
door. If the rack moves, adjust the leveling legs. See Step 10: Level the dishwasher.
• Check the door alignment with the cabinet. If the door hits the cabinet, reposition or relevel
the dishwasher. See Step 10: Level the dishwasher
• Make sure that water supply and drain lines are not kinked or in contact with other
components. Any contact with the motor or dishwasher frame could cause a noise.
See Step 8: Slide the dishwasher partially into the cabinet.
• Turn on the sink hot water faucet and verify the water temperature. Incoming water
temperature must be between 120°F and 150°F. A minimum of 120°F temperature is required
for best wash performance. See Preparing the hot water line
• Add a half gallon (2 l) of water to the bottom of the dishwasher to lubricate the pump seal.
• Turn on the water supply. Check for leaks. Tighten connections if needed.
• Remove any protective film (if present) from the control panel and door.
23
| General | Details |
|---|---|
| Name | UGP-24CR Classic Retro By Unique Dishwasher |
| Make | UNIQUE |
| Language | English |
| Filetype | PDF (Download) |
| File size | 0.96 MB |
(1 votes, average: 5.00 out of 5)
Loading...
UNIQUE Classic Retro Dishwasher
JENNAIR JDPSS24 Series Dishwasher
FISHER PAYKEL DW60UC2X2 Built-Under Dishwasher
FISHER PAYKEL DD24DTX6PX1 Tall
Haier HDW13F0B1 Hygiene Dishwasher
INALTO DW42CS 45cm Compact Dishwasher
FISHER AND PAYKEL DD24STX6I Tall Dishwasher
Thermador DWHD660EFP Sapphire Dishwasher
Miele PFD 104 SCVI XXL Dishwasher
BOSCH SMS4IKC62T Dishwasher
ETA 238090000C Dishwasher