VIKING VDWU724SS Dishwasher
6.4 AUXILIARY FUNCTIONS
Washing programs of your dishwasher are designed to obtain the best
cleaning effect, considering the type of the soiling, soiling degree and
properties of the dishes to be washed.
On/Off Key
When you press the On/Off key, the indicator lights illuminate on the
display for ON position. The lights turn off in OFF position.
Auxiliary functions allow you save from time, water and power.
PROGRAM SELECTION / PROGRAM CANCEL KEY
Auxiliary functions may cause changes in the program
duration.
Select the desired program using the “program selection keys”and
press the button.
C
To cancel the running program, open the door of the machine and
press and hold the Program Start/Pause/Cancel key for 3 seconds.
After the 3 - 2 - 1 countdown, 0:01 is displayed, close the door of
the product and wait for the draining process complete. Draining is
completed in 2 minutes and the machine gives an audible warning
when it is completed.
Auxiliary functions are not suitable for all washing
programs. Indicator of the auxiliary function that is not
C compatible with the program will not be active.
Half Load function
It is used to operate the machine without loading it completely.
1. Load your dishes in the machine as you like. You can use both
upper and lower racks.
6.1 FUNCTION KEYS
If you press any of the Function keys during program selection or time
delay selection, an affirmative key signal will be heard provided that
the relevant function is supported by the selected program. Function
will be deemed selected when the indicator of the selected function
is lit.
2. Turn the machine on with On/Off key.
3. Select the desired program and press the Half Load key. The Half
Load indicator will light on the display in the Function Selected
indicator.
To cancel the selected function, keep the function key pressed until
the function indicator disappears.
4. Close the door of the machine to start the program.
6.2 PREPARING THE MACHINE
1. Open the door of the dishwasher.
Express Function
It shortens the time of the washing cycle selected and decreases
water consumption by enabling washing under higher pressure.
2. Place the dishes in accordance with the instructions in the user
manual.
3. Make sure that the upper and lower impellers rotate freely.
4. Put adequate amount of detergent into the detergent dispenser.
HighGloss Function
It provides superior drying performance by increasing rinsing
temperature and drying time.
6.3 PROGRAM SELECTION
1. Press the On/Off button to turn on your machine.
2. Check the Rinse Aid indicator and add rinse aid if needed.
Sanitized indicator
3. Refer to the table of "Program data and average consumption
values" to determine a washing program suitable for your dishes.
Sanitize Function
Sanitize function raises the water temperature in the final rinse to
meet the requirements of NSF/ANSI STANDARD 184 for Residential
Dishwashers. Certified residential dishwashers are not intended for
licensed food establishments.
4. Selected program will start when you close the door of your
machine.
At the end of a succesfull sanitization “SAN“ is
displayed on the display. “SAN”is not displayed on the
C display if the cycle is interrupted or the water could not
The Energy Guide label and all offical certifications
are based on ‘Normal’soil-sensing cycle as follows:
C If available on the unit, the automatic detergent
be heated to the required temperature.
detection feature should be deactivated. Dishes should
be loaded with the upper rack on its 2nd position and
if available third basket should be removed. Tests
should be done without any rinse aid in the rinse aid
dispenser. Depending on the amount of water taken in
preconditioning cycle, calculated amount of detergent
according to the definitions in the test procedure should
be inserted into the detergent dispenser, without
detergent in prewash. For optimal performance with
minimum energy consumption, it is recommended to
disable all other auxilary options.
Available programs are indicated on Program Table
chart.
C
Note: Only sanitizing cycles have been designed to
meet the requirements of NSF/ANSI Standard 184 for
C soil removal and sanitization efficacy.
There is no intention, either directly or indirectly, that
all cycles have passed sanitization performance tests.
11 USA
| General | Details |
|---|---|
| Name | VIKING VDWU724SS Dishwasher |
| Make | VIKING |
| Language | English |
| Filetype | PDF (Download) |
| File size | 3.26 MB |

VIKING FDW102WS Dishwasher

VIKING 3 Series Dishwasher

VIKING VDWU324SS Dishwasher





































