Whirlpool WDT550SAPW with 3rd Rack Dishwasher

1

2

3

4

5

6

7

8

9

Undercounter Dishwasher  

■ Included water inlet hose with Leak Detection System for some  

models.  

PRODUCT MODEL NUMBERS  

WDT550SAPW  

WDT550SAPZ  

WDT550SAPB  

■ Included 3/8" (9.5 mm) Compression x 3/4" (19 mm) Water inlet  

adapter (only for models with Leak Detection System).  

■ If installed in new construction, make sure the house water  

supply lines have been flushed prior to connecting the  

dishwasher to remove any debris that may exist in the supply  

line.  

DRAIN REQUIREMENTS  

■ A new drain hose is supplied with your dishwasher. If drain  

hose is not long enough, use a drain hose extension with a  

maximum length of 12 ft (3.7 m).  

ELECTRICAL REQUIREMENTS  

■ Make sure to connect drain hose to waste tee or disposer  

inlet above drain trap in house plumbing and 20" (508 mm)  

minimum above the floor. It is recommended that the drain  

hose either be looped up and securely fastened to the  

underside of the counter or be connected to an air gap.  

Be sure that the electrical connection and wire size are adequate  

and in conformance with the National Electrical Code,  

ANSI/NFPA 70 - latest edition, and all local codes and  

ordinances.  

IMPORTANT: This product is not equipped with a high loop on  

the side of the dishwasher. The installer is responsible for adding  

a high loop in the adjacent cabinet. A high loop is required if  

the dishwasher will drain into a floor drain. This prevents water  

draw off from the dishwasher during operation. When the drain  

is connected to a sink drain, counter-top air-gap or disposer, the  

high loop is generally not required. An check valve internal to the  

drain prevents back-flow into the dishwasher.  

For a fee, a copy of the above code standards can be obtained  

from:  

National Fire Protection Association  

1 Batterymarch Park  

Quincy, MA 02169-7471  

You Must Have:  

■ 120 V, 60 Hz, AC only, 15 A or 20 A, fused electrical supply.  

■ Copper wire only.  

■ Make sure to use an air gap if the drain hose is connected to  

house plumbing lower than 20" (508 mm) above subfloor or  

floor.  

■ A maximum of 2 field wiring supply conductors (12 AWG  

largest size) plus 1 grounding conductor are permitted in the  

terminal box.  

Use of air gap  

We Recommend:  

■ Install the dishwasher on a circuit with appropriate interrupte  

per your local code. The dishwasher is compatible with tim  

delay fuses, standard circuit breakers, and GFCI and AFCI  

circuit breakers.  

Air gap  

Circuit Requirement:  

■ The dishwasher may be installed on the same circuit as a  

garbage disposal providing that the branch circuit cannot  

exceed rated circuit load and must comply with all governing  

codes and regulations such as but not limited to National  

Electrical Code, ANSI/NFPA 70 - latest edition.  

■ No electrical connections other than the dishwasher power  

and ground connections can be made inside of the dishwasher  

junction box.  

■ If required, the air gap should be installed in accordance with  

the air gap installation instructions. When you are connecting  

the air gap, a rubber hose (not provided) will be needed to  

connect to the waste tee or disposer inlet.  

If Connecting Dishwasher with a Power Cord:  

■ Use UL Listed power cord kit marked for use with  

dishwasher. See the “Tools and Parts” section at  

the front of the Owner’s manual for part details and  

orders.  

■ Use 1/2" (13 mm) minimum I.D. drain line fittings.  

■ Plug into a grounded 3 prong outlet. Outlet must meet  

all local codes and ordinances.  

WATER SUPPLY REQUIREMENTS  

■ This dishwasher maybe fitted with a smart inlet hose with a  

water cut off valve. Do not cut the water inlet hose for any  

reason, to install, adapt or shorten.  

If Connecting Dishwasher with Direct Wiring:  

■ Use flexible, armored, or nonmetallic  

sheathed copper wire with grounding wire  

that meets the wiring requirements for your  

home and local codes and ordinances.  

■ This dishwasher has a water heating feature and also requires  

a connection to a hot water supply line.  

■ Use only the supplied plastic cable fittings for flexible and  

non-metallic sheathed wiring (Romex, etc.). Do not use metallic  

strain reliefs for these wire constructions.  

■ A hot water line with 20 psi to 120 psi (138 kPa to 862 kPa)  

water pressure can be verified by a licensed plumber.  

■ 120°F (49°C) water at dishwasher.  

■ Use a UL-listed/CSA-approved metallic strain relief for armored  

cable installations (21 mm diameter), Using the strain relief’s  

manufacturer installations instructions.  

■ 3/8" (95 mm) O.D. copper tubing with compression fitting or  

flexible braided water supply line.  

Dimensions are for planning purposes only. For complete details, see  

Installation Instructions packed with product. Specifications subject to  

change without notice.  

Because Whirlpool Corporation policy includes a continuous commitment  

to improve our products, we reserve the right to change materials and  

specifications without notice.  

W11562389A  

1

VIEW FULL SCREEN PDF MANUAL

General	Details
Name	Whirlpool WDT550SAPW with 3rd Rack Dishwasher
Make	Whirlpool
Language	English
Filetype	PDF (Download)
File size	0.23 MB

Download PDF

(1 votes, average: 5.00 out of 5)

Loading...

• ALL DISHWASHER INSTRUCTIONS & USER MANUALS
• Whirlpool

Whirlpool WDT550SAPW with 3rd Rack Dishwasher Overview

Summary of Contents

• Page 1: Undercounter dishwasher includes a water inlet hose with a leak detection system for some models. Product model numbers include WDT550SAPW, WDT550SAPZ, and WDT550SAPB. A new drain hose is supplied, and if it's not long enough, a drain hose extension with a maximum length of 12 ft is recommended. The electrical connection must conform to the National Electrical Code and local codes. A high loop is required if the dishwasher drains into a floor drain to prevent water draw off during operation. The dishwasher requires a 120 V, 60 Hz, AC only, 15 A or 20 A, fused electrical supply. An air gap should be used if the drain hose is connected to plumbing lower than 20 inches above the floor. The dishwasher may be installed on the same circuit as a garbage disposal, provided the branch circuit does not exceed the rated load. If connecting with a power cord, use a UL Listed power cord kit and plug into a grounded 3 prong outlet. The dishwasher requires a connection to a hot water supply line with water pressure between 20 psi to 120 psi.
• Page 2: Product dimensions include various measurements for different components. Dimensions for panel ready models are also provided, with specific measurements for each part. If a custom toe kick is desired, the thickness of the custom panel must be adjusted to align with the cabinet toe kick. The original metal toe kick must remain in place even if a custom toe kick is installed. Dimensions are intended for planning purposes only. For complete details, refer to the installation instructions included with the product. Specifications are subject to change without notice. Whirlpool Corporation reserves the right to change materials and specifications as part of its commitment to product improvement.
• Page 3: Cabinet opening dimensions are provided for installation. A dimension of 32 1/4-35 7/16 (820-900 mm) is measured from the lowest point on the underside of the countertop. A minimum width of 24 (609.6 mm) is required. A dimension of 23 5/8-24 1/4 (600-616 mm) is measured from the narrowest point of the opening. Dimensions are for planning purposes only. For complete details, refer to the installation instructions packed with the product. Specifications are subject to change without notice. Whirlpool Corporation reserves the right to change materials and specifications without notice.
• Page 4: Lave-vaisselle sous comptoir Tuyau d’arrivée d’eau inclus avec le système de détection des fuites pour certains modèles. Un tuyau d’évacuation neuf est fourni avec le lave-vaisselle. Veiller à raccorder le tuyau d’évacuation à la canalisation d’égout en T ou au raccord de broyeur à déchets. S’assurer que le raccordement électrique est adéquat et conforme au Code National de l’Électricité. Ce produit n’est pas équipé d’une boucle surélevée sur le côté du lave-vaisselle. Alimentation de 120 V CA à 60 Hz et protégée par un fusible de 15 ou 20 A. Utiliser un dispositif de brise-siphon si le tuyau d’évacuation est raccordé à moins de 20 po au-dessus du sous-plancher. Ce lave-vaisselle peut être équipé d’un tuyau d’arrivée intelligent avec une vanne de coupure d’eau. Température de 120 °F (49 °C) à l’entrée du lave-vaisselle. Les dimensions sont indiquées à des fins de planification uniquement.
• Page 5: Dimensions du produit A. 32 1/4 po-35 7/16 po (820-900 mm) E. 14 1/16 po (358 mm) C. 23 9/16 po (599 mm) B. 22 5/8 po (574 mm) D. 28 3/8 po (721 mm) F. 18 3/4 po (477 mm) Dimensions du produit (pour les modèles avec panneau prêt-à-installer) A. 32 1/4 po-35 7/16 po (820-900 mm) E. E = A - G C. 23 9/16 po (599 mm) B. 21 7/8 po (555 mm) D. 18 3/4 po (477 mm) F. 1 1/16 po-1 3/4 po (18-45 mm) G. 28 3/8 po-29 15/16 po (720-760 mm) Remarque : Pour installer une plinthe personnalisée, ajuster l’épaisseur du panneau personnalisé pour qu’il soit au même niveau que la plinthe du meuble. Les dimensions sont indiquées à des fins de planification uniquement. Pour des détails complets, voir les Instructions d’Installation fournies avec le produit. Spécifications indiquées sous réserve de modifications.
• Page 6: Dimensions de l'ouverture de l'armoire A. 32 1/4 po à 35 7/16 po (820 à 900 mm) depuis le point le plus bas de la face inférieure du plan de travail. B. Minimum de 24 po (609,6 mm) C. 23 5/8 po-24 1/4 po (600-616 mm) minimum mesuré au point le plus étroit de l'ouverture. Les dimensions sont indiquées à des fins de planification uniquement. Pour des détails complets, voir les instructions d'installation fournies avec le produit. Spécifications indiquées sous réserve de modifications. La politique de Whirlpool Corporation, c’est aussi notre engagement à travailler sans relâche à l’amélioration de nos produits.
• Page 7: Lavavajillas para instalarse debajo del mostrador Manguera de entrada de agua incluida con sistema de detección de fugas para algunos modelos. Incluye el adaptador de entrada de agua de 3/8 (9,5 mm) con compresión x 3/4 (19 mm) (solo para modelos con sistema de detección de fugas). Si la instalación se realiza en una construcción nueva, asegúrese de enjuagar las tuberías de suministro de agua domésticas antes de conectar la lavavajillas. Se provee una manguera nueva de desagüe con su lavavajillas. Asegúrese de conectar la manguera de desagüe al conector de residuos en “T” o a la entrada del colector de residuos sobre el sifón de desagüe. Asegúrese de que la conexión eléctrica y el tamaño del cable sean adecuados y cumplan con el Código Nacional Eléctrico. Este producto no está equipado con un circuito alto en el lateral del lavavajillas. Se requiere un circuito alto si el lavavajillas va a vaciar en un desagüe de piso. Este lavavajillas puede estar equipado con una manguera de entrada inteligente con válvula de corte de agua.
• Page 8: Dimensiones del producto A. 32 1/4-35 7/16 (820-900 mm) B. 22 5/8 (574 mm) C. 23 9/16 (599 mm) D. 28 3/8 (721 mm) E. 14 1/16 (358 mm) F. 18 3/4 (477 mm) Dimensiones del producto (para modelos listos para panel) A. 32 1/4-35 7/16 (820-900 mm) B. 21 7/8 (555 mm) C. 23 9/16 (599 mm) D. 18 3/4 (477 mm) E. E = A - G F. 1 1/16-1 3/4 (18-45 mm) G. 28 3/8-29 15/16 (720-760 mm) Nota: Si se desea instalar un zócalo a medida, ajuste el grosor del panel a medida para que quede enrasado con el zócalo del gabinete. Las dimensiones son solo para fines de planificación. Para obtener los detalles completos, vea las instrucciones de instalación incluidas con el producto. Las especificaciones están sujetas a cambio sin previo aviso.
• Page 9: Dimensiones de la abertura del gabinete A. 32 1/4-35 7/16 (820-900 mm) medido desde el punto más bajo de la parte inferior del mostrado. B. 24 (609,6 mm) mínimo. C. 23 5/8-24 1/4 (600-616 mm) mínimo, medido desde el punto más estrecho de la abertura. Las dimensiones son solo para fines de planificación. Para obtener los detalles completos, vea las instrucciones de instalación incluidas con el producto. Las especificaciones están sujetas a cambio sin previo aviso. Whirlpool Corporation se reserva el derecho de cambiar los materiales y las especificaciones sin previo aviso.