COMFEE FD1435E-W Slimline Dishwasher

1

2

3

4

TROUBLESHOOTING TIPS  

Before Calling For Service  

Reviewing the charts on the following pages may save you from calling for service.  

Problem  

Possible Causes  

What To Do  

Dishwasher doesn't  

start  

Fuse blown, or the  

Replace fuse or reset circuit breaker.  

Remove any other appliances sharing  

the same circuit with the dishwasher.  

circuit break tripped.  

Power supply is not  

turned on.  

Make sure the dishwasher is turned  

on and the door is closed securely.  

Make sure the power cord is  

properly plugged into the wall socket.  

Water pressure is low  

Check that the water supply is  

connected properly and the water  

is turned on.  

Door of dishwasher  

not properly closed.  

Make sure to close the door  

properly and latch it.  

Twisted or trapped  

drain hose.  

Check the drain hose.  

Water not pumped  

form dishwasher  

Filter clogged.  

Check the filter system.  

Kitchen sink clogged.  

Check the kitchen sink to make sure  

it is draining well. If the problem is  

the kitchen sink that is not draining ,  

you may need a plumber rather than  

a serviceman for dishwashers.  

Use only the special dishwasher  

detergent to avoid suds. If this occurs,  

open the dishwasher and let suds  

evaporate. Add 1 liter of cold water  

to the bottom of the dishwasher.  

Close the dishwasher door, then select  

any cycle. Initially, the dishwasher will  

drain out the water. Open the door  

after draining stage is complete and  

check if the suds have disappeared.  

Repeat if necessary.  

Foam in the tub  

Wrong detergent.  

26  

VIEW FULL SCREEN PDF MANUAL

General	Details
Name	COMFEE FD1435E-W Slimline Dishwasher
Make	comfee
Language	English
Filetype	PDF (Download)
File size	0.04 MB

Download PDF

(1 votes, average: 5.00 out of 5)

Loading...

• ALL DISHWASHER INSTRUCTIONS & USER MANUALS
• comfee

COMFEE FD1435E-W Slimline Dishwasher Overview

Summary of Contents

• Page 1: Troubleshooting tips can help avoid unnecessary service calls. Check for a blown fuse or tripped circuit breaker if the dishwasher doesn't start. Ensure the power supply is turned on and the dishwasher door is securely closed. Verify that the power cord is properly plugged into the wall socket. Low water pressure may indicate improper connection or that the water is turned off. Make sure the dishwasher door is properly closed and latched. Inspect the drain hose for twists or traps that could impede drainage. A clogged filter can prevent water from being pumped out of the dishwasher. If the kitchen sink is clogged, it may require a plumber's assistance. Using the wrong detergent can cause foam in the tub; use only special dishwasher detergent.
• Page 2: Problem Possible causes What to do Spilled rinse aid. Always wipe up rinse aid spills immediately. Stained tub interior. Detergent with colourant may have been used. Make sure that the detergent has no colourant. White film on inside surface. Hard water minerals. To clean the interior, use a damp soft cloth with dishwasher detergent and wear rubber gloves. There are rust stains on cutlery. The affected items are not corrosion resistant. Avoid washing items that are not corrosion resistant in the dishwasher. A program was not run after dishwasher salt was added. Always run a wash program without any crockery after adding salt. The lid of the softener is loose. Check the softener lid is secure. A spray arm is knocking against an item in a basket. Interrupt the program and rearrange the items which are obstructing the spray arm. Rattling noise in the dishwasher. Items of crockery are loose in the dishwasher. Interrupt the program and rearrange the items of crockery. Knocking noise in the water pipes. This may be caused by on-site installation or the cross-section of the piping. The dishes are not clean. The dishes were not loaded correctly. See PART II “Preparing And Loading Dishes”.
• Page 3: Problem: The dishes are not clean. Possible Causes: Not enough detergent was dispensed. What To Do: Use more detergent, or change your detergent. Items are blocking the movement of the spray arms. Rearrange the items so that the spray can rotate freely. The filter combination is not clean or is not correctly fitted in the base of the wash cabinet. Clean and/or fit the filter correctly. Clean the spray arm jets. Combination of soft water and too much detergent. Use less detergent if you have soft water and select a shorter cycle to wash the glassware. Cloudiness on glassware. Hard water area can cause limescale deposits. White spots appear on dishes and glasses. Aluminium utensils have rubbed against dishes. Black or grey marks on dishes. Use a mild abrasive cleaner to eliminate those marks. Detergent left in dispenser. Improper loading can cause issues. Dishes are removed too soon. Open the door slightly so that the steam can come out. Unload the lower basket first to prevent water from the upper basket.
• Page 4: The dishes aren't drying. Wrong program has been selected. Choose a program with a long washing time. Use of cutlery with a low-quality coating. Self-repair or non-professional repair may cause serious risks to the safety of the user. Availability of spare parts for seven years after placing the last unit of the model on the market. Spare parts include motor, circulation and drain pump, heaters, and heating elements. Ten years after placing the last unit of the model on the market for door hinge and seals. Spare parts include spray arms, drain filters, and interior racks. Software and firmware including reset software are available for seven years.