FORZA FD24DI Dishwasher
Installation Instructions
CAUTION
PREPARE HOT WATER LINE
•
The line may enter from either side, rear or floor
within the shaded area shown in Figure F.
The line may pass through the same hole as the
Opening the door will cause
•
the dishwasher to tip forward.
Do not open the door until
you are ready to install the
dishwasher. If it is necessary
to open the door, hold the top
of the dishwasher securely
with one hand and hold the
door with the other hand.
electival cable and drain hose. Or, cut an additional
1-1”dia. hole to accomodate the water line. If power
cord with plug is used, water line must not pass
through cord hole.
BEFORE YOU BEGIN
Locate and set aside the package
containing 2 phillips head countertop
mounting screws and 2 additional
toekick screws (located in the litera-
ture package.)
STEP 1: Check Door Balance
To check the door balance, hold the top of the dish-
washer firmly.
WATER LINE CONNECTION
•
Turn off water supply.
•
Install a hand shut-off valve in an accessible loca-
tion, such as under the sink. (Optional, but strongly
recommended and may be required by local codes.)
•
Water connection is on the left side of the dish-
washer. Install the hot water inlet line, using no less
than 3” O.D. copper tubing. Route the line as shown
in Figure F and extend forward at least 18” from rear
wall.
•
Open the door slowly, if the door drops when
released increase spring tension. If the door closes
when released decrease tention.
•
•
•
Adjust water heater for 120° F to 150° F temperature.
Flush water line to clean out debris.
•
•
Adjust both door springs to the same tension.
The hot water supply line pressure must be
Continue moving the spring pin until door is balanced.
20-120PSI.
7
| General | Details |
|---|---|
| Name | FORZA FD24DI Dishwasher |
| Make | forza |
| Language | English |
| Filetype | PDF (Download) |
| File size | 0.33 MB |



























