Home > Frigidaire > FRIGIDAIRE FDHP4336AS 24 Tall Tub Dishwasher
FRIGIDAIRE FDHP4336AS 24 Tall Tub Dishwasher
16
CARE AND CLEANING
Rinse Aid
WARNING
RRiinnsseeaaiiddggrreeaattllyyiimmpprroovveessddrryyiinnggaanndd
rreedduucceesswwaatteerrssppoottss.. With it water
“sheets” off dishes rather than forming
water droplets that cling and leave spots.
Do not fill the reservoir above the full
level indicator. Excess rinse aid can
overflow during the wash cycle.
A dispenser, located next to the
detergent cup, automatically releases a
measured amount of rinse aid during the
last
3. Press the rinse aid cover down
firmly to close.
rinse. If spotting and poor drying are
problems, increase the amount of rinse
aid dispensed by below steps:
1.Open the door when dishwasher is in
standby mode.
2.Within 60 seconds after opening the
door, press and hold Quick button for
more than 5 seconds to enter the set
mode. The rinse aid indicator blinks.
Water Pressure
3.Press Quick button again to select the
proper set according to your using habits,
the setting will change in the following
sequence: 3→4→5 →1 →2 →3. The higher
the number, the more rinse aid the
dishwasher uses.
The hot water line to dishwasher must
provide water pressure between 20 and
80 psi.
Low Water pressure may occur when
laundry or showers are in operation. If
you experience poor wash performance
you may need to wait until water use is
reduced before starting dishwasher.
4.Without operation in 5 seconds to
complete the setup and exit the setting
mode.
Water Temperature
Under normal conditions, you will need to
fill the rinse aid dispenser approximately
once a month. Rinse aid is released
through an opening in the dispenser. You
do not need to wait until the dispenser is
empty to refill it. Try to keep it full, but be
careful not to overfill it.
Hot water is needed for best
dishwashing and drying results. Water
entering dishwasher should be at least
120°F to 150°F(49℃ to 66℃)to give
satisfactory results.
To check water temperature entering
dishwasher:
To refill the rinse
aid dispenser
•
•
•
Turn on hot water faucet nearest
dishwasher for several minutes to
clear cool water from pipes.
1. Lift up the end tab
of rinse aid cover to
open.
Hold a candy or meat thermometer
in the water stream to check the
temperature.
If temperature is below 120° F (49°
C), have a qualified person raise the
hot water heater thermostat setting.
2. Fill the rinse aid
dispenser with liquid
rinse aid until full.
DO NOT overfill.
IMPORTANT
Before starting a cycle, run hot water to
clear cool water from pipe.
NOTE:
Use the viewing port when filling the rinse
aid reservoir.
| General | Details |
|---|---|
| Name | FRIGIDAIRE FDHP4336AS 24 Tall Tub Dishwasher |
| Make | Frigidaire |
| Language | English |
| Filetype | PDF (Download) |
| File size | 4.06 MB |
(1 votes, average: 5.00 out of 5)
Loading...
FRIGIDAIRE GDPH4525SS Dishwasher
FRIGIDAIRE GDPP4517A Gallery Series Dishwasher
FRIGIDAIRE FDPC4314AS Dishwasher
FRIGIDAIRE GDPH4515AF Gallery Dishwasher
FRIGIDAIRE FFBD2406NB Full Console Dishwasher
FRIGIDAIRE GDPH4525AF Gallery Dishwasher
FRIGIDAIRE FDHP4336AS Dishwasher
FRIGIDAIRE FDSR4501AP Panel Ready Dishwasher
FRIGIDAIRE FFBD1821MS Dishwasher
FRIGIDAIRE FGHD2455LF Dishwasher
FISHER PAYKEL DD60DDFX9 Double Sanitise DishDrawer Dishwasher
NEFF S187ECX23G Dishwasher
Danby DDW18D1EW Dishwasher
BLACK Plus DECKER BDW200M Dishwasher
FISHER and PAYKEL DW24UNT4X2 Dishwasher
AEG FFB64607ZM Dishwasher
GE APPLIANCES PDT755SYV/BTV UltraFresh System Dishwasher with Interior
UGP-24CR Classic Retro By Unique Dishwasher
BOSCH SMV4ENX06E Dishwasher
BOSCH SMS23DW01T Dishwasher