GERMAN DWH-121 Dishwasher
Installation Instruction
Troubleshooting
Positioning the Appliance
Before Calling for Service
Review the charts on the following pages may save you from calling for service.
Position the appliance in the desired location. The back should rest against the wall behind it, and the
sides, along the adjacent cabinets or walls. The dishwasher is equipped with water supply and drain
hoses that can be positioned either to the right or the left sides to facilitate proper installation.
Problem
Possible Causes
What To Do
Fuse blown, or the
circuit breaker acted
Replace fuse or reset circuit breaker.
Remove any other appliances sharing
the same circuit with the dishwasher
How to Drain Excess Water From Hoses
If the sink is 1000mm higher from the floor, the excess water in hoses cannot be drained directly into
the sink. It will be necessary to drain excess water from hoses into a bowl or suitable container that is
held outside and lower than the sink.
Make sure the dishwasher is turned
on and the door is closed securely.
Make sure the power cord is properly
plugged into the wall socket.
Power supply is not
turned on
Dishwasher
doesn’t start
Water Outlet
Connect the water drain hose. The drain hose must be correctly fitted to avoid water leaks. Ensure that
the water inlet hose is not kinked or squashed.
Water pressure is low
Check that the water supply is
connected properly and water is turned
on.
Technical
problems
Extension Hose
If you need a drain hose extension, make sure to use a similar drain hose.
It must be no longer than 4 metres; otherwise the cleaning effect of the dishwasher could be reduced.
Door of dishwasher
not properly closed.
Make sure to close the door properly
and latch it.
Kink in drain hose
Filter clogged
Check drain hose.
Syphon Connection
Insert the drain hose into a drain pipe with a minimum diameter of 40mm, or let it run into the sink,
making sure to avoid bending or crimping it. The top of the hose must be less than 1000mm.
Check coarse the filter
(see section titled “ Cleaning The Filter “)
Water not
pumped from
dishwasher
Kitchen sink clogged
Check the kitchen sink to make sure it is
draining well.
If the problem is the kitchen sink not
draining, you may need a plumber rather
than a serviceman for dishwashers.
Start of Dishwasher
The following things should be checked before starting the dishwasher.
1. The dishwasher is level and fixed properly
2. The inlet valve is open
3. There is a leakage at the connections of the conducts
4. The wires are tightly connected
5. The power is switched on
6. The inlet and drain hoses are knotted
7. All packing materials and printings should be taken out from the dishwasher
Suds in the tub
Improper detergent
Use only the special dishwasher
detergent to avoid suds. If this occurs,
open the dishwasher and let suds
evaporate. Add 1 gallon of cold water to
the tub. Close and latch the dishwasher,
then select any cycle. Dishwasher will
drain out the water at the first step. Open
the door after draining is stop and check
if the suds are disappeared.
Attention: After installation, please make sure to keep this manual. The content of this manual is
very helpful to the users.
General
problems
Repeat if necessary.
Spilled rinse-aid
Always wipe up rinse-aid spills
immediately.
Stained tub
interior
Detergent with
colourant was used
Make sure that the detergent is the
one without colourant.
White film on
inside surface
Hard water minerals
To clean the interior, use a damp
sponge with dishwasher detergent
and wear rubber gloves.
Never use any other cleaner than
dishwasher detergent for the risk of
foaming or suds.
P.32
P.33
General | Details |
---|---|
Name | GERMAN DWH-121 Dishwasher |
Make | German |
Language | English |
Filetype | PDF (Download) |
File size | 6.49 MB |
