Home > German > GERMAN DWH-121 Dishwasher

GERMAN DWH-121 Dishwasher

Installation Instruction  
Installation Instruction  
Dishwasher must be level for proper dish rack operation and wash performance.  
1. Place a spirit level on door and rack track inside the tub as shown to check that the dishwasher is  
level.  
2. Level the dishwasher by adjusting the three levelling legs individually.  
3. When level the dishwasher, please pay attention not to let the dishwasher tip over.  
WARNING!  
Improper connection of the equipment- grounding conductor can result in the risk of an electric shock.  
Check with a qualified electrician or service representative if you are in doubt whether the appliance is  
properly grounded. Do not modify the plug provided with the appliance, if it is not fit for the outlet. Have  
a proper outlet installed by a qualified electrician.  
Figure8】  
How to Connect the AQUASTOP Safety Supply Hose  
Illustration of feet adjustment  
The appliance must be connected to the water mains using new hose-sets.  
The old hose-sets should not be reused.  
NOTE:  
The maximum adjustment height of  
Water pressure must be between 0.04 MPa and 1 MPa. If the pressure is  
below the minimum, consult our Service Department for advice.  
1. Pull the safety supply hoses completely out from storage compartment  
located at rear of dishwasher.  
2. Tighter the screws of the safety supply hose to the faucet with thread  
3/4inch.  
the feet is 50 mm.  
Check level  
Front to Back  
Spirit level  
3. Turn water fully on before starting the dishwasher.  
Check level side to side  
ABOUT THE SAFETY SUPPLY HOSE.  
The safety supply hose consists of the double walls. The hose’s system guarantees its intervention by  
blocking the flow of water in case of the supply hose breaking and when the air space between the  
supply hose itself and the outer corrugated hose is full of water.  
About Power Connection  
WARNING!  
For personal safety:  
WARNING!  
Do not use an extension cord or an adapter plug with this appliance.  
Under any circumstances, do not cut or remove the earthing.  
Connection from the power cord.  
- A hose that attaches to a sink spray can burst if it is installed on the same water line as the  
dishwasher. If your sink has one, it is recommended the hose be disconnected and the hole plugged.  
- Ensure the Aquastop safety supply unit is in a vertical position once installed.  
Electrical Requirements  
How to Disconnect the Safety Supply Hose  
1 Turn off the water.  
2 Unscrew the safety supply hose from the faucet.  
Please look at the rating label to know the rating voltage and connect the dishwasher to the  
appropriate power supply. Use the required fuse 10 amp, time delay fuse or circuit breaker  
recommended and provide separate circuit serving only this appliance.  
Cold Water Connection  
Electrical Connection  
Ensure the voltage and frequency of the power being corresponds  
Insure proper ground  
exists before use  
Connect the cold water supply hose to a threaded 3/4(inch) connector and make sure that it is  
fastened tightly in place. If the water pipes are new or have not been used for an extended period of  
time, let the water run to make sure that the water is clear and free of impurities. If this precaution is  
not taken, there is a risk that the water inlet can get blocked and damage the appliance.  
to those on the rating plate. Only insert the plug into an electrical  
socket which is earthed properly. If the electrical socket to which the  
appliance must be connected is not appropriate for the plug, replace  
the socket, rather than using an adaptor or the like as they could  
cause overheating and burns.  
WARNING:  
Please close the hydrant after using.  
GROUNDING INSTRUCTIONS  
ALL ENTION After intsallation, please make sure to keep this manual for future reference. The content  
of this manual is very helpful to the user.  
This appliance must be earthed. In the event of a malfunction or breakdown, earthing will reduce the  
risk of electric shock by providing a path of least resistance for the electric current. This appliance is  
equipped with a cord having an equipment-earthing conductor and an earthing plug. The plug must be  
plugged into an appropriate outlet that is installed and earthed in accordance with all local standards  
and requirements.  
P.30  
P.31  
GeneralDetails
NameGERMAN DWH-121 Dishwasher
MakeGerman
LanguageEnglish
FiletypePDF (Download)
File size6.49 MB
Download PDF
1 Star2 Stars3 Stars4 Stars5 Stars (1 votes, average: 5.00 out of 5)
Loading...

GERMAN DWH-121 Dishwasher