Home > ggmgastro > ggmgastro DSHI1080WD Dishwasher

ggmgastro DSHI1080WD Dishwasher

DRAINING: Wait for about 5 seconds. (Heating  
is active)  
FINISHED: START LED flashes. (Heating is  
active for the next washing)  
PROTECTIVE GLOVES IF NECESSARY.  
AVOID CONTACT WITH SOAPY WATER  
IN YOUR EYES.  
1. SHUTTING DOWN  
MANUAL DRAINING: Press the draining  
button while the device is on, remove the plastic  
plug inside the tank, and the draining process will  
be completed when the draining buttons light  
goes off.  
• Press and hold the ON/OFF button for 2 seconds  
to turn off the device. • Turn off the power supply  
switch connected to the device.  
• Lift the top cover, take out the washed items,  
and close the cover.  
• Close the water inlet valve.  
6.2- Usage  
2. SAFETY MEASURES  
The device is designed for washing trays,  
• If the lid is opened while the device is running or  
if the lid is not fully closed when the start  
command is given, the operation stops. When the  
lid is closed, the device will continue running.  
plates, cups, forks, spoons, etc., placed in  
specially designed cassettes, in medium-sized  
establishments that serve mass meals and facilities  
such as cafeterias. • The device should only be  
operated by a qualified person dedicated to this  
task. • The device has three different washing  
programs.  
WARNING: If there is any damage to the power  
input cable of the device or if there is a water leak  
in the drainage hose, the device must be turned off  
immediately, and the authorized service must be  
notified.  
Short Wash (100 sec.): For slightly soiled  
dishes.  
Medium Wash (150 sec.): For moderately  
soiled dishes.  
Long Wash (210 sec.): For greasy and  
heavily soiled dishes. • For good washing  
quality, make sure to pre-wash the dishes  
before loading them into the machine.  
Otherwise, food residues, lemon peels,  
toothpicks, etc., can clog the drain pipe  
and compromise washing quality. • The  
device can be integrated into a  
3. DAILY MAINTENANCE  
• Replace the washing water at least twice a day or  
when the cleaning ability of the water is  
compromised due to dirty particles. Washing with  
dirty water can result in wasted detergent, rinse  
aid, and electricity, leading to poor washing  
results.  
• Always turn off the power switch before starting  
maintenance activities.  
dishwashing system by installing units  
such as scraping unit, waste bin, sink unit,  
and exit counter.  
• Make sure that debris does not clog the drain  
outlet.  
• Check if the washing and rinsing arms rotate  
freely. Clean the nozzles with a thin stick if they  
are clogged.  
• Use liquid and low-foaming detergent for  
washing. The amount of detergent to be used  
should be determined by the detergent  
manufacturer. The amount of rinse aid to be used  
in the device should also be determined by the  
manufacturer. Detergent and rinse aid dosing units  
are provided by the manufacturers.  
• Select the most suitable program according to  
the type and degree of soiling of the dishes.  
• The device comes with standard accessories: 1  
tray for plates (500x500 mm), 1 tray for cutlery,  
and 1 tray for glasses.  
• Choose the appropriate tray for the dishes to be  
washed and load them according to the capacities  
specified in the table. To save detergent and  
electricity, do not run the machine unless the tray  
is fully loaded.  
• Never move the device while it is running.  
• Make sure the water inlet valve is open before  
starting the device.  
• After cleaning the device, leave the cover open.  
4. PERIODIC MAINTENANCE  
(approximately every 2-3 days)  
• Never perform maintenance while the device is  
connected to electricity.  
• As shown in Figure 1, remove the nozzles of the  
water sprayers and clean them from any debris  
that may cause blockages.  
• Clean the outer surfaces of the device with a  
cloth soaked in soapy water. When cleaning the  
devices surface, do not use abrasive detergents,  
wire brushes, or other materials that may scratch  
the surfaces.  
• Clean the heating elements with a descaling  
agent once a week.  
• Remove and clean the pumps pre-filter at  
regular intervals.  
• If the device will not be used for an extended  
period and there is a risk of freezing, drain the  
washing pump and the boiler.  
• If any hazardous condition is observed in the  
machine, notify the authorized service. Do not  
CAUTION!!! NEVER PUT YOUR BARE  
HAND INTO THE WASHING WATER. USE  
12  
allow unqualified individuals to interfere with the  
machine.  
sensory, or mental disabilities, or lack of  
experience and knowledge to use the device  
without supervision.  
• Playing with the device by children is  
dangerous.  
• Over time, calcium and magnesium in the water  
can cause limescale formation inside the washing  
tank, boiler, and water pipes, affecting the devices  
performance. Therefore, it is necessary to have a  
qualified technician periodically clean the  
limescale.  
• Cleaning and maintenance should not be done by  
children without supervision.  
5. Child Safety  
• It is dangerous and forbidden for children under  
8 years of age or individuals with physical,  
POTENTIAL PROBLEMS - CAUSES - SOLUTIONS  
PROBLEM  
1-Dishes are not clean.  
CAUSE  
-Washing arms may be stuck.  
SOLUTION  
-Check whether the dishes prevent arms from rotating.  
-Clean the water sprays by removing the washing arm.  
-Clean the water sprays by removing the rinsing arm.  
-Check the hardness of water.  
-Washing water sprays may be  
blocked.  
-Rinsing water sprays may be  
blocked.  
-Check the detergent amount.  
-Detergent concentration may be  
very high or insufficient.  
-Filter may be blocked.  
-Remove and clean the filter.  
-Washing time may be insufficient. -Select a longer wash period or repeat the same period.  
2-Dishes are getting broken. -Proper tray may not have been -Be careful when selecting the tray.  
used.  
-Comply with its capacity.  
-Machine  
overloaded.  
may  
have  
been  
3-The device does not take -Water inlet valve may be closed. -Check/Open  
water. -Cover may not be closed -Check/Close  
completely.  
-Notify the authorized service.  
-Solenoid valve may be broken.  
4-The device continuously -Pressure stat may be defective.  
-Notify the authorized service.  
takes water.  
-Pressure stat hose may have taken -Empty the water inside the tank and restart the device.  
in air.  
5-There is rusting on the -Improper chemical materials  
device surface may have been used.  
-Clean the device according to the instructions for use  
13  
GeneralDetails
Nameggmgastro DSHI1080WD Dishwasher
Makeggmgastro
LanguageEnglish
FiletypePDF (Download)
File size0.79 MB
Download PDF
1 Star2 Stars3 Stars4 Stars5 Stars (1 votes, average: 5.00 out of 5)
Loading...
ggmgastro GLOZ50 Undercounter Dishwasher
ggmgastro GLOZ50 Undercounter Dishwasher

ggmgastro DSHI1080WD Dishwasher