Home > HEINNER > Heinner HDW-FS6062WE Dishwasher

Heinner HDW-FS6062WE Dishwasher

Filling the detergent  
Push the latch to open the dispenser and pour in the detergent.  
Close the lid and press it until it locks in place. The dispenser should be refilled just before the  
start of each programme. If the dishes are heavily soiled, place additional detergent in the  
pre-wash detergent chamber.  
Using combined detergents  
These products should be used according to the manufacturer’s instructions.  
Never put combined detergents into the interior section or the cutlery basket.  
Combined detergents contain not only the detergent but also rinse-aid, salt replacement  
substances and additional components depending on the combination. We recommend you do  
not use combined detergents in short programmes.  
Please use powder detergents in such programmes.  
If you encounter problems when using combined detergents, please contact the detergent  
manufacturer.  
When you stop using combined detergents, make sure that water hardness and rinse aid  
settings are set to the correct level.  
Rinse-aid usage  
The rinse aid helps to dry the dishes without streaks and stains. Rinse-aid is required for  
stain-free utensils and clear glasses. The rinse aid is automatically released during the hot rinse  
phase. If rinse aid dosage setting set too low, whitish stains remains on dishes and dishes do  
not dry and washed clean.  
If rinse aid dosage setting set too height, you can see bluish layers on glass and dishes.  
Filling The rinse-aid and setting  
To fill the rinse aid compartment, open the rinse-aid compartment cap. Fill the compartment  
with rinse aid to the MAX level and then close the cap. Be careful not to overfill the rinse aid  
compartment and wipe up any spills.  
In order to change the rinse aid level, follow the below steps before turning on the machine:  
Push the programme button and hold it down.  
Turn on the machine.  
Hold down the programme button until the LEDs flash twice. Rinse aid set follows  
water hardness set.  
The machine will display the last setting.  
Set the level by pushing the programme v button.  
Switch off the machine to save the setting.  
The factory setting is “4”.  
If the dishes are not drying properly or are spotted, increase the level. If blue stains form on  
your dishes, decrease the level.  
11  
GeneralDetails
NameHeinner HDW-FS6062WE Dishwasher
MakeHEINNER
LanguageEnglish
FiletypePDF (Download)
File size1.03 MB
Download PDF
1 Star2 Stars3 Stars4 Stars5 Stars (1 votes, average: 5.00 out of 5)
Loading...
HEINNER HDW-BI6006IE++ Free Standing Dishwasher
HEINNER HDW-BI6006IE++ Free Standing Dishwasher
HEINNER HWDM-V9614D Front Load Dishwasher
HEINNER HWDM-V9614D Front Load Dishwasher
HEINNER HDW-BIM60514E Dishwasher
HEINNER HDW-BIM60514E Dishwasher
HEINNER HDW-FSM60714AWD Series Dishwasher
HEINNER HDW-FSM60714AWD Series Dishwasher
HEINNER HG-150SS Free Standing Dishwasher
HEINNER HG-150SS Free Standing Dishwasher
HEINNER HDW-BI4505IE++ Dishwasher
HEINNER HDW-BI4505IE++ Dishwasher

Heinner HDW-FS6062WE Dishwasher