Whirlpool DU1041XTXQ3 Dishwasher
■
The amount of detergent to use depends on:
1-hr Wash – Use for lightly soiled items. For fast results, 1-hr
Wash will clean the dishes using slightly more water and energy.
How much soil remains on the items - Heavily soiled loads
require more detergent.
Rinse Only – (no options apply to this cycle) Do not use detergent.
This is only a rinse that keeps food from drying on your dishes and
reduces odor buildup in your dishwasher until you are ready to
wash a full load.
The hardness of the water - If you use too little in hard water,
dishes won't be clean. If you use too much in soft water,
glassware will etch.
Soft to Medium Water (0-6 grains per U.S. gallon)
[typical water softener water and some city water]
Medium to Hard Water (7-12 grains per U.S. gallon)
[well water and some city water]
Select Options (options vary by model)
You can customize your cycles by pressing the options desired.
Repeatedly press the button until the
desired combination of options is
selected.
■
Depending on your water hardness, fill the Main Wash section
of the dispenser as shown. Fill the Pre-Wash section to the
level shown, if needed.
High Temp – (use only with Pots & Pans
and Normal wash cycles) Heats the water
during the wash portions of the cycle.
NOTE: Fill amounts shown
are for standard powdered
detergent. Follow instructions
on the package when using
other dishwasher detergent.
Hard Water
Soft Water
Hard Water
Soft Water
Sani Rinse – (use only with Pots & Pans
and Normal wash cycles) Select this
Main Wash
Pre-Wash
option to raise the water temperature in the final rinse to
approximately 155°F (68°C). Sani Rinse option adds heat and time
to the cycle. This high temperature rinse sanitizes your dishes and
glassware in accordance with NSF/ANSI Standard 184 for
Residential Dishwashers. Certified residential dishwashers are not
intended for licensed food establishments.
Add Rinse Aid
■
Your dishwasher is designed to use rinse aid for good drying
performance. Without rinse aid your dishes and dishwasher
interior will have excessive moisture. The heat dry option will
not perform as well without rinse aid.
Heated Dry – (use only with 1-hr Wash, Pots & Pans and Normal
wash cycles) Use for best drying results. When selected with the
1-hr Wash cycle, the time is increased by approximately
30 minutes.
■
Rinse aid keeps water from forming droplets that can
Full
dry as spots or streaks. They also improve drying by
allowing water to drain off of the dishes after the final
rinse.
4-hr Delay – (any cycle) Offers the choice to start the dishwasher
automatically at a later time. Select a wash cycle and options.
Press 4-hr Delay. Press START/RESUME. Close the door firmly.
■
■
■
Rinse aid helps to reduce excess moisture on the
dish racks and interior of your dishwasher.
Add
Lock – (on 4-hr Delay button) use to avoid
Check the rinse aid indicator. Add rinse aid when indicator
drops to “Add” level.
unintended use of your dishwasher. When Control
Lock is lit, all buttons are disabled. The dishwasher
door can be opened while the controls are locked.
To add rinse aid, turn the dispenser
cap to “Open” and lift off. Pour rinse
aid into the opening until the indicator
Lock
To turn on Lock:
Press and hold 4-hr Delay for at least 3 seconds. The
Control Lock light glows. If you press any pad while
your dishwasher is locked, the light flashes 3 times.
level is at “Full.” Replace the
dispenser cap and turn to “Lock.”
Make sure cap is fully locked.
Refill
To turn off Lock:
Press and hold 4-hr Delay for at least 3 seconds. The Control Lock
light turns off.
¹⁄₄ turn to lock
STEP 4
NOTE: For most water conditions, the
factory setting of 2 will give good
results. If you have hard water or notice
rings or spots, try a higher setting. Turn
the arrow adjuster inside the dispenser
by either using your fingers or inserting
a flat-blade screwdriver into the center
of the arrow and turning.
6
Start or Resume a Cycle
■
Run hot water at the sink nearest your dishwasher until the
water is hot. Turn off water.
■
Push door firmly closed. The door latches
automatically. Select the wash cycle and options
desired OR press START/RESUME to repeat the same
cycle and options as in the previous wash cycle.
STEP 3
■
■
You can add an item anytime before the main wash
starts. Open the door slowly and add the item. Close
the door firmly. Press START/RESUME.
Select a Cycle (cycles vary by model)
Press the Select Cycle button until the light below the desired cycle
is on.
Clean indicator glows when the cycle is finished.
Sanitized glows when Sani Rinse option is
selected and sanitization levels occur.
NOTE: Heavier cycles and options affect cycle length. Some
cycles and options will take up to 3¹⁄₂ hours to complete.
Pots & Pans – Use for heavily
soiled, hard-to-clean items.
Normal – Use for normal food
soil. The energy usage label is
based on this cycle.
Eco– Use for lightly soiled items.
It saves energy.
4
| General | Details |
|---|---|
| Name | Whirlpool DU1041XTXQ3 Dishwasher |
| Make | Whirlpool |
| Language | English |
| Filetype | PDF (Download) |
| File size | 1.58 MB |
(1 votes, average: 5.00 out of 5)
Loading...
Whirlpool 2B19 Dishwasher
Whirlpool WFO3O33PLAUS Standard Dishwasher
Whirlpool W11323304G Dishwasher
Whirlpool WH7IPC15BM60 Dishwasher
Whirlpool FINPUTSAD Dishwasher
Whirlpool W7U HS31 X Dishwasher
Whirlpool Thron Dishwasher
Whirlpool WDF332PAMS 24 Front Tall Tub Dishwasher
Whirlpool WRF540CWHZ Dishwasher
Whirlpool WDF130PAHB Dishwasher
BOSCH SHV9PCM3N 24 Custom Panel Dishwasher
NEFF SBV6EB800E Dishwasher
BOSCH SPS4HMI61E Dishwasher
Hotpoint W11635818 Dishwasher
FISHER PAYKEL DD60DDFB9 Double Dishwasher
BOSCH SHE3AEM5N Dishwasher
LG XD3A25UNS Dishwasher
Whirlpool W0I D741A S Fully Dishwasher
Whirlpool W8I HP42 L MaxiSpace Dishwasher
BOSCH SMV4ENX06E Dishwasher