Whirlpool W7I HT58 T Fully Integrated Dishwasher
Daily Reference Guide
CLEANING THE SPRAY ARMS
EN
The lower spray arm may be removed
by pulling it upwards and rotating it
anti-clockwise. Mounting back the
spray arm is by pulling it down and
rotating it clockwise.
On occasions, food residue
may become encrusted onto
the spray arms and block the
holes used to spray the wa-
ter. It is therefore recommen-
ded that you check the arms
from time to time and clean
them with a small non-me-
tallic brush.
The top spray arm may be removed
by pressing it up and then rotating it
anti-clockwise. Mounting back the
spray arm is by pulling it upwards and
rotating it clockwise.
To remove the upper spray
you must remove it together
with the manifold.
TROUBLESHOOTING
In case your dishwasher doesn’t work properly, check if the problem can be solved by going through the following list.
For other errors or issues please contact authorized After-sales Service whose contact details can be found in the warranty booklet.
Spare parts will be available for a period of either up to 7 or up to 10 years, according to the specific Regulation requirements.
PROBLEMS POSSIBLE CAUSES
SOLUTIONS
Refill the reservoir with salt (for more information - see FILLING THE SALT RESERVOIR). Check the
water hardness setting if necessary (see WATER HARDNESS TABLE).
The salt indicator
Salt reservoir is almost empty.
is lit
Refill the reservoir with salt as soon as possible. Using the appliance without salt may cause
damage to its internal components.
The salt indicator
Salt reservoir is empty.
is blinking
The rinse aid
indicator is lit
or blinking
Rinse aid dispenser is empty. (After refill the rinse
aid indicator may remain lit for a short time).
Refill the dispenser with rinse aid (for more information - see FILLING THE RINSE AID DISPENSER).
Descale the appliance immediately using the Self Clean program and a commercially available
descaling product (see OPTIONS AND FUNCTIONS). Refill the reservoir with salt. Check the water
hardness setting. If the appliance is not descaled, it will stop functioning.
Descale indicator
is lit or blinking;"dES"
alarm is displayed.
Limescale is accumulating on internal components
of the appliance.
The appliance has not been plugged in properly. Insert the plug into the socket.
For safety reasons, the dishwasher will not restart automatically when power returns.
Open dishwasher door, press START/Pause button and close the door within 4 seconds.
Power outage.
The dishwasher
won’t start or does
not respond to
commands.
The dishwasher door is not closed.
NaturalDry pin is not pulled in.
Vigorously push the door until you hear the “click”.
A cycle is interrupted by door opening for more
than 4 seconds.
Press START/Pause and close the door within 4 seconds.
Switch off the appliance by pressing the ON-OFF/Reset button, switch it back on after approxi-
mately one minute and restart the program. If the problem persists, unplug the appliance for 1
minute, then plug it back in.
The control panel does not respond or F6 E1 is
displayed.
The filter is clogged with food residues or lime-
scale
Clean the filter and descale the appliance (see CLEANING THE FILTER ASSEMBLY and DESCALE
INSTRUCTION).
The dishwasher
won’t drain.
Display shows:
F7 E3 or F9 E1
The drain hose is kinked.
Check the drain hose (see INSTALLATION INSTRUCTION).
Clean the sink drain pipe.
The sink drain pipe is blocked.
Dishes are rattling against each other.
Position the crockery correctly (see LOADING THE RACKS).
The detergent has not been measured out correctly or it is not suitable for use in dishwashers
(see FILLING THE DETERGENT DISPENSER). Restart the current cycle by switching OFF the dishwa-
sher, then switch it on again, select a new program, press START/Pause and close the door within
4 seconds. Please do not add any detergent.
An excessive amount of foam is present.
The dishwasher ma-
kes excessive noise.
Crockery has not been arranged properly.
Arrange the crockery correctly (see LOADING THE RACKS).
The filter is clogged with food residues or limescale. Clean the filter assembly (see CARE AND MAINTENANCE).
Crockery has not been arranged properly. Arrange the crockery correctly (see LOADING THE RACKS).
Spray arms cannot rotate freely, being hindered Arrange the crockery correctly (see LOADING THE RACKS). Check that the upper rack is in the
by the dishes.
correct position and adjust (lift up) if necessary.
The wash cycle is too gentle.
Select an appropriate wash cycle (see PROGRAMS TABLE).
The detergent has not been measured out correctly or it is not suitable for use in dishwashers (see
FILLING THE DETERGENT DISPENSER).
An excessive amount of foam is present.
The dishes are not
clean.
The cap on the rinse aid compartment has not
been closed correctly.
Make sure the cap of the rinse aid dispenser is closed.
The filter is clogged with food residues or limescale. Clean the filter and descale the appliance (see CLEANING THE FILTER ASSEMBLY).
The salt reservoir is empty. Fill the salt reservoir (see FILLING THE SALT RESERVOIR).
5
| General | Details |
|---|---|
| Name | Whirlpool W7I HT58 T Fully Integrated Dishwasher |
| Make | Whirlpool |
| Language | English |
| Filetype | PDF (Download) |
| File size | 6.17 MB |
(1 votes, average: 5.00 out of 5)
Loading...
Whirlpool 2B19 Dishwasher
Whirlpool WFO3O33PLAUS Standard Dishwasher
Whirlpool W11323304G Dishwasher
Whirlpool WH7IPC15BM60 Dishwasher
Whirlpool FINPUTSAD Dishwasher
Whirlpool W7U HS31 X Dishwasher
Whirlpool Thron Dishwasher
Whirlpool WDF332PAMS 24 Front Tall Tub Dishwasher
Whirlpool WRF540CWHZ Dishwasher
Whirlpool WDF130PAHB Dishwasher
BOSCH SMV6ZCX17E Dishwasher
BOSCH SPS2HKW58E Dishwasher
FISHER and PAYKEL DD60DCHX9, DD60DDFHB9 Dishwasher
FISHER and PAYKEL DW60UNT4B2 Contemporary Tall Built Under Dishwasher
VALBERG 14S40 B WAD929C Dishwasher
Amana ADB1400AGW Dishwasher
FISHER AND PAYKEL DD60SCHX9 Single DishDrawer Dishwasher
FISHER AND PAYKEL DD60STX6HI1-CN Tall Dishwasher
AEG FSB34707Z Dishwasher
BOSCH SMS24AI01A Free Standing Dishwasher