Whirlpool W7I HT58 T Fully Integrated Dishwasher
EN
Adjusting the dosage of rinse aid
FILLING THE DETERGENT DISPENSER
If you are not completely satisfied with the drying results, you can adjust To open the detergent dispenser use the opening device C. Introduce
the quantity of rinse aid used.
the detergent into the dry dispenser D only. Place the amount of
detergent for pre-washing directly inside the tub.
To change, follow instructions in the section “SETTING MENU”.
If the rinse aid level is set to ZERO, no rinse aid will be supplied. The LOW
RINSE AID indicator light will not be lit if you run out of rinse aid.
A maximum of 6 levels can be set according to the dishwasher model.
• If you see bluish streaks on the dishes, set a low number (0-3).
• If there are drops of water or limescale marks on the dishes, set
a mid-range number (4-5).
1. When measuring out the detergent refer to the
mentioned earlier information to add the proper
quantity. Inside the dispenser D, there are indica-
D
tions to help the detergent dosing.
C
2. Remove detergent residues from the edges of the
dispenser and close the cover until it clicks.
3. Close the lid of the detergent dispenser by pulling
it up until the closing device is secured in place.
The detergent dispenser automatically opens up at the right time accord-
ing to the program.
Usage of detergent not designed for dishwashers may cause
malfunction or damage to the appliance.
DAILY USE
1. CHECK WATER CONNECTION
MODIFYING A RUNNING PROGRAM
Check that the dishwasher is connected to the water supply and that
the tap is open.
If a wrong program was selected, it is possible to change it, provided that it
has only just begun. RESET the machine: press and hold the ON/OFF button
for more than 3. sec., and the machine will switch off. The dashboard will
show “0:01”. Switch the machine back on using the ON/OFF button and
select the new wash cycle and any desired options. Start the cycle by
pressing the START/Pause button and closing the door within 4 sec.
2. SWITCH ON THE DISHWASHER
Open the door and press the ON/OFF button.
3. LOAD THE RACKS (see LOADING THE RACKS).
4. FILL THE DETERGENT DISPENSER
5. CHOOSE THE PROGRAM AND CUSTOMISE THE CYCLE
Select the most appropriate program in accordance with the type of
crockery and its soiling level (see PROGRAMS DESCRIPTION) by pressing
the selected PROGRAM button.
ADDING EXTRA CROCKERY
Without switching off the machine, open the door first slightly to avoid water
splashing out (START/Pause led starts blinking) (Caution!: Hot steam!) and
place the crockery inside the dishwasher. Press the START/Pause button and
close the door within 4 sec., the cycle will resume from the point at which it
was interrupted.
Select the desired options (see OPTIONS AND FUNCTIONS). Not all
options are compatible with all programs.
6. START
Start the wash cycle by pressing START/Pause button (led is lit) and
closing the door within 4 sec. When the program starts you hear a sin-
gle beep. If the door was not closed within 4sec., the alarm sound will
be played. In this case, open the door, press START/Pause button and
close the door again within 4 sec.
ACCIDENTAL INTERRUPTIONS
If the door is opened during the wash cycle, or if there is a power cut, the
cycle stops. ONLY IF YOU PRESS the START/Pause button and close the
door within 4 sec., the cycle will resume from the point at which it was
interrupted.
7. END OF WASH CYCLE
The end of the wash cycle is indicated by beeps and by the flashing of
the wash cycle number on the display. Open the door and switch off
the appliance by pressing the ON/OFF button.
Wait for a few minutes before removing the crockery - to avoid burns.
Unload the racks, beginning with the lower one.
ADVICE AND TIPS
TIPS
TIPS ON ENERGY SAVING
Before loading the baskets, remove all food residues from the crockery and
empty the glasses. You do not need to rinse beforehand under running
water.
Arrange the crockery so that it is held in place firmly and does not tip over;
and arrange the containers with the openings facing downwards and the
concave/convex parts placed obliquely, thus allowing the water to reach
every surface and flow freely.
Warning: lids, handles, trays and frying pans should not prevent the
sprayer arms from rotating.
Place any small items in the cutlery basket.
Very soiled dishes and pans should be placed in the lower basket because
in this sector the water sprays are stronger and allow a higher washing
performance.
After loading the appliance, make sure that the sprayer arms can rotate
freely.
• When the household dishwasher is used according to the manufactur-
er’s instructions, washing tableware in a dishwasher usually con-
sumes less energy and water than hand dishwashing.
• In order to maximize dishwasher efficiency, it is recommended to
initiate the wash cycle once the dishwasher is fully loaded. Loading
the household dishwasher up to the capacity indicated by the manu-
facturer will contribute to energy and water savings. Information on the
correct loading of tableware can be found in the Loading chapter.
In case of partial loading, it is recommended to use a dedicated wash op-
tions if available (Half load/ Zone Wash/ Multizone), filling up only select-
ed racks. Incorrect loading or overloading of the dishwasher may increase
resources usage (such as water, energy and time, as well as increase noise
level), reducing cleaning and drying performance.
• Manual pre-rinsing of tableware items leads to increased water and
energy consumption and is not recommended.
UNSUITABLE CROCKERY
• Wooden crockery and cutlery.
• Delicately decorated glasses, artistic handicrafts and antique crockery.
Their decorations are not resistant.
• Parts in synthetic material which do not withstand high temperatures.
• Copper and tin crockery.
HYGIENE
To avoid odour and sediment which can be accumulated in the dishwasher
please run a high-temperature program at least once a month. Use a
teaspoon of detergent and run it without loading to clean your appliance.
• Crockery soiled with ash, wax, lubricating grease or ink.
The colours of glass decorations and aluminium/silver pieces can change
and fade during the washing process. Some types of glass (e.g. crystal
objects) can become opaque after a number of wash cycles too.
RESISTANCE TO FROST
If the appliance is placed in surroundings exposed to the risk of frost, it
must be drained completely. Turn off the water tap, remove the inlet and
outlet hoses, and let all the water drain away. Make sure that the water
softener is full of dissolved regeneration salt in the salt container, to
protect the appliance from temperatures of up to -20°C.
DAMAGE TO GLASS AND CROCKERY
• Only use glasses and porcelain guaranteed by the manufacturer as
dishwasher safe.
• Use a delicate detergent suitable for crockery
• Collect glasses and cutlery from the dishwasher as soon as the wash
cycle is over.
If the appliance was stored in frost conditions the appliance must remain at
an ambient temperature of min. 5°C for at least 24 hours before the first run.
2
| General | Details |
|---|---|
| Name | Whirlpool W7I HT58 T Fully Integrated Dishwasher |
| Make | Whirlpool |
| Language | English |
| Filetype | PDF (Download) |
| File size | 6.17 MB |
(1 votes, average: 5.00 out of 5)
Loading...
Whirlpool 2B19 Dishwasher
Whirlpool WFO3O33PLAUS Standard Dishwasher
Whirlpool W11323304G Dishwasher
Whirlpool WH7IPC15BM60 Dishwasher
Whirlpool FINPUTSAD Dishwasher
Whirlpool W7U HS31 X Dishwasher
Whirlpool Thron Dishwasher
Whirlpool WDF332PAMS 24 Front Tall Tub Dishwasher
Whirlpool WRF540CWHZ Dishwasher
Whirlpool WDF130PAHB Dishwasher
BOSCH SMH4ECX14E Dishwasher
Miele PFD 100 SmartBiz Free-Standing Dishwasher
BOSCH SPI6ZDS006 Dishwasher
BOSCH DF480100 Dishwasher
BOSCH SGV4HCX40G Dishwasher
smeg PL254CX Universal Partially Dishwasher
BOSCH SMT6EB801E Dishwasher
IKEA OSTVEDA Dishwasher
BOSCH SMH6ZDX00E Dishwasher
BOSCH SMV6ZCX42E Dishwasher