Whirlpool WDF341PAPB Dishwasher
NOTE: If using a flexible braided hose, replace inlet hose after
5 years to reduce the risk of hose failure. Record hose installation
or replacement dates on the hose for future reference.
� A level floor.
Helpful Hint: If floor at front of opening is not level with floor at
rear of opening, shims may be used to level dishwasher.
NOTE: To avoid shifting during dishwasher operation, shims must
be securely attached to the floor.
For Direct Wire
For Power Cord
� The location where the dishwasher will be installed must
provide clearance between motor and flooring. Motor should
not touch the floor.
� Do not install dishwasher over carpeted flooring.
Cabinet Opening Dimensions
Clearances
Check that all surfaces have no protrusions that would prohibit
dishwasher installation.
Cabinet Grommet
Power Cord Kit
For 11/2" (38 mm) hole in
cabinet
NOTE: Required for metal
Kit typically includes power
cord, metallic strain relief,
grommet, and twist-on wire
connectors (Straight: Whirlpool
Part Number 4317824, 90°:
Whirlpool Part Number
cabinets
34"
(864 mm)
A
10½"
(267 mm)
4"
(102 mm)
6¾"
(172 mm)
6¼"
W10278923RP). For proper
installation, refer to the
installation instructions
(159 mm)
3"
(76 mm)
2¼"
(64 mm)
24"
(620 mm)
1¾"
(44 mm)
provided with the kit.
2"
(51 mm)
NOTE: Be sure to purchase only Whirlpool factory-certified parts
and accessories for your appliance. Your installation may require
additional parts. To order, refer to the contact information
referenced in your Quick Start Guide.
24"
(620 mm)
B
A. Measured from the lowest point on the underside of the countertop.
May be reduced to 331/2" (851 mm) by removing the wheels and
perforated area of insulation (blanket) on dishwasher.
Location Requirements
Dishwasher must be fully enclosed (top, sides, back, and floor)
upon installation. A side panel kit is available from your dealer for
installing your dishwasher at the end of your cabinetry.
B. Minimum, measured from narrowest point of opening.
NOTE: Shaded areas of cabinet walls show where utility
connections may be installed.
An optional moisture barrier accessory is also available for
installing underneath a wooden countertop.
Drain Requirements
Check location where dishwasher will be installed. The location
must provide:
� Convenient access for loading and unloading dishes. Corner
locations require a 2" (51 mm) minimum clearance between
the side of the dishwasher door and the wall or cabinet.
� A new drain hose is supplied with your dishwasher. If drain
hose is not long enough, use a new drain hose with a
maximum length of 12 ft (3.7 m) that meets all current
AHAM/IAPMO test standards, is resistant to heat and
detergent, and fits the 1" (25 mm) drain connector of the
dishwasher.
� Easy access to water, electricity, and drain:
•
•
Grounded electrical supply is required.
This dishwasher has a water-heating feature and also
requires a connection to a hot water supply line.
NOTE: Do not connect multiple drain hoses together.
� Make sure to connect drain hose to waste tee or disposer inlet
above drain trap in house plumbing and 20" (508 mm)
minimum above the floor. It is recommended that the drain
hose either be looped up and securely fastened to the
underside of the counter or be connected to an air gap.
•
Make sure pipes, wires, and drain hose are within the
shaded area shown in the “Cabinet Opening Dimensions”
section.
•
•
Do not run drain lines, water lines, or electrical wiring where
they can interfere with or contact dishwasher motor or legs.
Shelter dishwasher and water lines leading to dishwasher
against freezing. Damage from freezing is not covered by
the warranty.
� Make sure to use an air gap if the drain hose is connected to
house plumbing lower than 20" (508 mm) above subfloor or
floor.
NOTE: If dishwasher will be left unused for a period of time
or in a location where it may be subject to freezing, have it
winterized by authorized service personnel.
A
•
If installed in new construction, flush the water supply line of
debris before connecting it to the fill valve. If it is not
flushed, debris from the water supply could plug the fill
valve screen.
� A square opening for proper operation and appearance.
� The cabinet front to be perpendicular to floor.
A. Air gap
7
| General | Details |
|---|---|
| Name | Whirlpool WDF341PAPB Dishwasher |
| Make | Whirlpool |
| Language | English |
| Filetype | PDF (Download) |
| File size | 9.65 MB |
(1 votes, average: 5.00 out of 5)
Loading...
Whirlpool 2B19 Dishwasher
Whirlpool WFO3O33PLAUS Standard Dishwasher
Whirlpool W11323304G Dishwasher
Whirlpool WH7IPC15BM60 Dishwasher
Whirlpool FINPUTSAD Dishwasher
Whirlpool W7U HS31 X Dishwasher
Whirlpool Thron Dishwasher
Whirlpool WDF332PAMS 24 Front Tall Tub Dishwasher
Whirlpool WRF540CWHZ Dishwasher
Whirlpool W11049299A Dishwasher
BOSCH SBV4ECX21E Dishwasher
Electrolux EES48400L Dishwasher
ETA 238090000C Dishwasher
Monsher MD 6003 Dishwasher
Electrolux TAPPAN Dishwasher
FISHER AND PAYKEL DW60CHPX1 Dishwasher
JENNAIR JDPSS246LL Dishwasher
CMA DISHMACHINES CMA H-1X Undercounter Dishwasher
BOSCH SMI4HVS33E Dishwasher
KitchenAid KDFE204KPS Dishwasher