ZLINE Classic Dishwasher
INSTALLATION
Step 6: Preparing the Dishwasher
Ensure that the circuit breaker and water supply valve are turned off
before proceeding with the following steps.
1. Before you move or lay down the dishwasher for installation, adjust the height of the
legs so they are as short as possible. This prevents the legs from breaking. Level the
dishwasher by adjusting the legs after you have the dishwasher in place.
2. Make sure there are no kinks and that the hose is not bent at any extreme angles that
might constrict the flow of water.
3. Remove the junction box cover located at the bottom front right of the dishwasher using
a screwdriver, and then install the strain relief (see Figure 4-C). Make sure to keep the
junction box cover; it is used in "Step 11: Electrical Wiring Connections" on page 21.
4. If the countertop is made of wood or a material not damaged by drilling, attach the two
installation brackets supplied with the dishwasher using the supplied screws (see Figure
4-A). They will be used in "Step 9: Securing the Dishwasher" on page 17.
5. Fasten a 90° Elbow joint onto the water inlet valve located at the bottom front left of the
dishwasher (see Figure 5); wrap Teflon tape or sealing compound around the thread of
the 90° Elbow to ensure a snug seal.
Do not overtighten the 90° elbow� Doing so may damage the water
inlet valve and cause a water leak�
WARNING
Figure 5
Figure 4
14
| General | Details |
|---|---|
| Name | ZLINE Classic Dishwasher |
| Make | Zline |
| Language | English |
| Filetype | PDF (Download) |
| File size | 0.96 MB |

ZLINE Monument Top Touch Dishwasher

ZLINE Monument Series 24 Red Matte Dishwasher

ZLINE 65286410 Monument Dishwasher

ZLINE 65286411 Monument Dishwasher

ZLINE DWV-18 Tallac Dishwasher












































