FORTE F18DWS250SS 18 Inch Dishwasher
INSTALLATION
STEP 11 – PRETEST CHECKLIST
STEP 12 – DISHWASHER WET TEST
Review this list after installing your dishwasher to avoid charges
for a service call that is not covered by your warranty.
Plug power cord into outlet.
Power on and select Rinse Wash program.
Close door and press the start buttons.
Check to be sure power is OFF.
Check to be sure that water enters the dishwasher. If water
does not enter the dishwasher, check to be sure that water
and power are turned on.
Check for leaks under the dishwasher. If a leak is found, turn
power supply off, then tighten connections. Restore power
after leak is corrected.
Check for leaks around the door. A leak around the door
could be caused by door rubbing or hitting against adjacent
cabinetry. Reposition the dishwasher if necessary.
The dishwasher will drain and turn off about 10 to 12 minutes
after the first fill. Check drain lines. If leaks are found, turn
power off at the breaker and correct plumbing as necessary.
Restore power after corrections are made.
Open door and remove all foam and paper packaging.
Locate the Owner’s Manual in the literature package.
Read the Owner’s Manual for operating instructions.
Check door opening and closing. If door does not open and
close freely or tends to fall, check spring adjustments.
Check to be sure that wiring is secure under the dishwasher,
not pinched or in contact with other components.
Check door alignment with tub. If door hits tub, level
dishwasher.
Pull lower rack out, about halfway. Check to be sure it does
not roll back or forward on the door. If the rack moves, adjust
leveling legs.
Check door alignment with cabinet. If door hits cabinet,
reposition or relevel dishwasher.
Open dishwasher door and make sure most of the water has
drained. If not, check drain line for kinking.
Verify water supply and drain lines are not kinked or in contact
with other components. Contact with dishwasher frame could
cause noise.
Run the dishwasher through another fill and drain cycle.
Check for leaks and correct if required.
At the end of drain, open door and select power off button.
Turn on the sink hot water faucet and verify water temperature.
Incoming water temperature must be between 120 °F and 150°F.
A minimum of 120 °F temperature is required for best wash
performance.
Turn on water supply. Check for leaks. Tighten connections if
needed.
STEP 13 – LITERATURE
Be sure to leave complete literature package and installation
instructions with consumer.
16
| General | Details |
|---|---|
| Name | FORTE F18DWS250SS 18 Inch Dishwasher |
| Make | FORTE |
| Language | English |
| Filetype | PDF (Download) |
| File size | 0.71 MB |
(1 votes, average: 5.00 out of 5)
Loading...
Forte F24DWS650PR Dishwasher
FORTE F18DWS450PR Dishwasher
FORTE F24DWS450PR Dishwasher
FISHER PAYKEL DW60UC6B Built Under Dishwasher
BOSCH 100 Series Dishwasher
Bosch SMS4ETW02E Dishwasher
Fisher and Paykel DW60UN4B2 Built-Under Dishwasher
Whirlpool W11602471 Dishwasher
Electrolux EET43200LX Dishwasher
HOOVER HV-D13SS 13 Place Dishwasher
SIEMENS SN13ES79CS Dishwasher
FARBERWARE FDW05ASBWHA Complete Dishwasher
kogan KAGDWS15CTC Dishwasher