Home > GERMAN POOL > GERMAN POOL 450 Series Dishwasher
GERMAN POOL 450 Series Dishwasher
Maintenance and Cleaning
Maintenance and Cleaning
Caring For The Dishwasher
Warning
Frost precaution
•
•
Do not over tighten the filters. Put the filters back in sequence securely, otherwise coarse
debris could get into the system and cause a blockage.
Please take frost protection measures on the dishwasher in winter. After washing cycles, please
operate as follows:
1. Cut off the electrical power to the dishwasher.
2. Turn off the water supply and disconnect the water inlet pipe from the water valve.
3. Drain the water from the inlet pipe and water valve. (Use a pan to gather the water)
4. Reconnect the water inlet pipe to the water valve.
NEVER use the dishwasher without filters in place. Improper replacement of the filter may
reduce the performance level of the appliance and damage dishes and utensils.
Spray arms
It is necessary to clean the spray arms regularly for hard water chemicals will clog the spray arm jets
and bearings.
5. Remove the filter at the bottom of the tub and use a sponge to soak up water in the sump.
After every wash
To clean the spray arms, follow the instructions below:
After every wash, turn off the water supply to the appliance and leave the door slightly open so that
moisture and odour are not trapped inside.
Remove the plug
Before cleaning or performing maintenance, always remove the plug from the socket.
No solvents or abrasive cleaning
To clean the exterior and rubber parts of the dishwasher, do not use solvents or abrasive cleaning
products. Only use a cloth with warm soapy water.
To remove spots or stains from the surface of the interior, use a cloth dampened with water and a little
vinegar, or a cleaning product made specifically for dishwashers.
When not in use for a long time
It is recommend that you run a wash cycle with the dishwasher empty and then remove the plug from
the socket, turn off the water supply and leave the door of the appliance slightly open. This will help the
door seals to last longer and prevent odors from forming within the appliance.
1. To remove the upper spray arm, hold the
nut in the centre still and rotate the spray
arm counterclockwise to remove it.
2. To remove the lower spray arm, pull out the
spray arm upward.
Moving the appliance
If the appliance must be moved, try to keep it in the vertical position. If absolutely necessary, it can be
positioned on its back.
Watch the video clip
3. Wash the arms in soapy and warm water
and use a soft brush to clean the jets.
Replace them after rinsing them thoroughly.
P.12
P.13
| General | Details |
|---|---|
| Name | GERMAN POOL 450 Series Dishwasher |
| Make | GERMAN POOL |
| Language | English |
| Filetype | PDF (Download) |
| File size | 6.37 MB |
(1 votes, average: 5.00 out of 5)
Loading...
