Hotpoint H8I HT59 LS UK Dishwasher
EN
PROBLEMS POSSIBLE CAUSES
SOLUTIONS
No water in the water supply or the tap is closed. Make sure there is water in the water supply and the water tap is open.
The dishwasher does
not fill the water.
Display shows:
Check the inlet hose (see INSTALLATION). Open dishwasher door, press START/Pause button
and close the door within 4 seconds.
The water inlet hose is kinked.
H O and is
2
lit; acoustic alarm
sounds.
The screen in the water inlet hose is clogged; it is Check and clean the screen in the water inlet hose. Open dishwasher door, press START/Pause
necessary to clean it.
button and close the door within 4 seconds.
Clean the filter and descale the appliance (see CLEANING THE FILTER ASSEMBLY and DESCALE
INSTRUCTION).
The filter is clogged with food residues or limescal.
Check if end of the drain hose is placed at the correct height (see INSTALLATION). Check for
siphoning into the home sewage system, and install a siphon breaker/air admittance valve if
necessary.
The dishwasher
finishes the cycle
prematurely.
Drain hose positioned too low or siphoning into
the home sewage system.
Display shows: F8 E3
The detergent has not been measured out correctly or it is not suitable for use in dishwashers
(see FILLING THE DETERGENT DISPENSER).
An excessive amount of foam is present.
Air in the water supply.
Check water supply for leaks or other issues letting air inside.
Make sure the rinse aid dispenser is filled (see FILLING THE RINSE AID DISPENSER). Multifunctional
tablets only will not provide as good drying effects as the actual use of liquid rinse aid.
Rinse aid is not present or the dosage is too low.
The dishes have been unloaded after the door
Make sure the cycle has ended before starting to unload the dishes (the display shows "END" or
was opened automatically but before the actual is blank). For even better drying results, it is recommended to let the dishes sit inside the dishwa-
cycle end.
sher with the door open for additional 15 minutes after the cycle ends.
The dishes are not
dried well.
If you notice puddles of water inside cavities of cups, mugs or bowls, try loading the dishes
(especially in the upper rack) providing more inclination to let larger amounts of water drip
down before drying starts.
The dishes are sitting too flat.
Please check in the PROGRAMS TABLE if the selected program is equipped in the drying phase.
Cycle without the drying phase may not deliver desired drying efficiency, so it is recommended
to change cycle selection for the one that has the drying phase.
The selected cycle does not have the drying
phase.
The dishes are made of non-stick or plastic.
Rinse aid dosage is excessive.
Some water drops remaining on this type of material are normal.
Dishes and glasses
have blue streaks
or bluish tinges.
Adjust the dosage to a lower setting.
Refill the reservoir with salt as soon as possible. Using the appliance without salt may cause
damage to its internal components.
Salt reservoir is empty.
Dishes and glasses
are covered with li-
mescale or a whitish
film.
The water hardness setting is too low.
Increase the setting (see WATER HARDNESS TABLE).
The cap of the salt reservoir is not properly closed. Check and close the salt reservoir cap.
The rinse aid reservoir is empty or rinse aid
dosage is insufficient.
Refill the dispenser with rinse aid and check dosage setting (for more information - see FILLING
THE RINSE AID DISPENSER).
Dishwasher shows
F8 E5
Valve is blocked or faulty.
Close the water tap, if possible. Do not switch off the power supply. Call the service.
Policies, standard documentation, ordering of spare parts and additional product information
can be found by:
• Using QR code and visiting our website: docs.hotpoint.eu
• Visiting our website: parts-selfservice.whirlpool.com
• Alternatively, contact our After-sales Service (See phone number in the warranty booklet). When contacting
our After-sales Service, please state the codes provided on your product’s identification plate.
IEC 436
:
The model information can be retrieved using the QR-Code reported in the energy label. The label also includes
6
| General | Details |
|---|---|
| Name | Hotpoint H8I HT59 LS UK Dishwasher |
| Make | Hotpoint |
| Language | English |
| Filetype | PDF (Download) |
| File size | 8.93 MB |

Hotpoint H7I HP42 L UK Dishwasher

Hotpoint H7F HP33 UK Dishwasher

Hotpoint H7F HS41 UK Full Size Dishwasher

Hotpoint H7F HS51 Dishwasher

Hotpoint H7FHS41 Dishwasher

Hotpoint HA3FC10BS7A0S Dishwasher

Hotpoint H7F HS41 X Dishwasher

Hotpoint 869991662940 Dishwasher

Hotpoint H7I HT59 L Dishwasher

Hotpoint HFC 3C26 WCUK Dishwasher



















