Home > Tesla > TESLA WDI461M Dishwasher

TESLA WDI461M Dishwasher

ENG  
Water Softener  
The water softener must be set manually, using the water hardness dial.  
The water softener is designed to remove minerals and salts from the water, which would have a detrimental or  
adverse effect on the operation of the appliance.  
The more minerals there are, the harder your water is.  
The softener should be adjusted according to the hardness of the water in your area. Your local Water Authority can  
advise you on the hardness of the water in your area.  
Adjusting salt consumption  
The dishwasher is designed to allow for adjustment in the amount of salt consumed based on the hardness of the  
water used. This is intended to optimise and customise the level o f salt consumption.  
Please follow the steps below for adjustment in salt consumption.  
1. Open the door, switch on the appliance;  
2. Within 60 seconds after the appliance was switched on press the Rapid button for more than 5 seconds to enter the  
water softener setting mode.  
3. Press the Rapid button again to select the proper set according to your local environment, the setting will change in  
the following sequence:  
H3->H4->H5->H6->H1->H2->H3;  
4. Press the Power button to end the setting mode.  
WATER HARDNESS  
Regeneration occurs  
every X program  
sequence 1)  
Salt  
consumption  
(gram/cycle)  
Water softener level  
German  
dH *  
French  
fH **  
British  
Clarke ***  
Mmol/l  
0 - 0.94  
0 - 5  
0 - 9  
0 - 6  
H1->Rapid Light bright  
No regeneration  
10  
0
9
6 - 11  
10 - 20  
7 - 14  
1.0 - 2.0 H2->90 min Light bright  
H3->90 min, Rapid Light  
12 - 17  
18 - 22  
23 - 34  
21 - 30  
31 - 40  
41 - 60  
15 - 21  
22 - 28  
29 - 42  
2.1 - 3.0  
bright  
5
3
2
12  
20  
30  
3.1 - 4.0  
H4->ECO Light bright  
H5->ECO, Rapid Light  
bright  
4.1 - 6.0  
H6->ECO, 90 min Light  
35 - 55  
61 - 98  
43 - 69  
6.1 - 9.8  
1
60  
bright  
1 dH=1.25 Clarke=1.78 fH=0.178mmol/l  
The manufactory setting: H3  
Contact your local water board for information on the hardness of your water supply.  
1) Every cycle with a regeneration operation consumes additional 2.0 litres of water, the energy consumption  
increases by 0.02 kWh and the program extents by 4 minutes.  
NOTE  
Please check the section 3 “Loading The Salt Into The Softener” of PART I: Generic Version, If your dishwasher lacks  
salt.  
NOTE  
If your model does not have any water softener, you may skip this section.  
Water Softener  
The hardness of the water varies from place to place. If hard water is used in the dishwasher,  
deposits will form on the dishes and utensils.  
The appliance is equipped with a special softener that uses a salt container specifically designed to  
eliminate lime and minerals from the water.  
24  
GeneralDetails
NameTESLA WDI461M Dishwasher
MakeTesla
LanguageEnglish
FiletypePDF (Download)
File size32.11 MB
Download PDF
1 Star2 Stars3 Stars4 Stars5 Stars (1 votes, average: 5.00 out of 5)
Loading...
TESLA WDI661M Dishwasher
TESLA WDI661M Dishwasher
TESLA WD461MX Dishwasher
TESLA WD461MX Dishwasher
TESLA WD690MW Dishwasher
TESLA WD690MW Dishwasher

TESLA WDI461M Dishwasher