Home > Thermador > Thermador DWHD640EFM Dishwasher

Thermador DWHD640EFM Dishwasher

en-usꢀInstallation Procedure  
Teflon tape  
Do not use Teflon tape; it could cause leaks and  
damage floors or cabinetry.  
1. Attach elbow joint to the water inlet valve with the open  
end facing towards the direction of the sink, either to the  
left or the right. . Turn by hand and do not over tighten  
.
4.2ꢀVisual Leak Check  
1. Temporarily hook up water supply under the sink by  
going through the front of the sink cabinet. Do not turn  
on the power or push the dishwasher into the niche.  
2. Turn the water on and check for leaks at the water inlet  
hose connection on the back of the dishwasher.  
4.3ꢀPre-level the Dishwasher  
Set the dishwasher to the correct height before it goes into  
the cabinet.  
1. Measure the height of the cabinet opening.  
2. Raise the front of the dishwasher to approximately 1/2"  
lower than the height of the opening by turning the feet  
clockwise.  
2. Attach hot water line to elbow.  
You can raise the rear foot after the unit is in the  
cabinet opening.  
3. Use two wrenches to tighten, using one to stabilize and  
avoid putting stress on the water inlet valve.  
The maximum height the unit can be raised to is 34.5"  
(867.3 mm)  
8
   
GeneralDetails
NameThermador DWHD640EFM Dishwasher
MakeThermador
LanguageEnglish
FiletypePDF (Download)
File size4.05 MB
Download PDF
1 Star2 Stars3 Stars4 Stars5 Stars (1 votes, average: 5.00 out of 5)
Loading...
Thermador DWHD660EFP Sapphire Dishwasher
Thermador DWHD660EFP Sapphire Dishwasher
Thermador DWHD660EFM Dishwasher
Thermador DWHD660EFM Dishwasher
Thermador DWHD640EFP Dishwasher
Thermador DWHD640EFP Dishwasher
Thermador Dishwasher : for DWHD650W and More
Thermador Dishwasher : for DWHD650W and More

Thermador DWHD640EFM Dishwasher