Home > Westinghouse > Westinghouse WSF6602XB 14 Place Dishwasher

Westinghouse WSF6602XB 14 Place Dishwasher

INSTALLING THE MACHINE  
Positioning the machine  
When considering the location for the dishwasher, ensure that  
there is adequate space to enable loading and unloading of the  
dishes  
After the connections are made, the tap should be turned on fully and  
checked for water tightness. For the safety of your machine, make  
sure to always turn off the water inlet tap after each wash program is  
finished.  
Do not put your machine in any location where  
the ambient temperature can fall below 5°C.  
Before positioning, take the machine out of its packaging by  
following the warnings located on  
the package.  
WARNING  
NOTE: Aquastop inlet hose has components using 240V. Do not  
cut Aquastop inlet hose. Do not let it get folded, twisted, kinked or  
crushed.  
Position the machine close to a water tap and drain. You need  
to postion your machine, taking into consideration that its  
connections will not be altered once they are made.  
Do not grip the machine by its door or panel in  
order to move it.  
WARNING  
NOTE: A water tempering valve is required if  
the water temperature is over 60°C.  
Take care to leave a certain clearance from all sides of the  
machine so that you can comfortably move  
it back and forth during cleaning.  
Make sure that the water inlet and outlet hoses do not get  
squeezed while positioning the machine. Also, make sure that  
the machine does not stand on the electrical cable. Adjust the  
machine’s feet so that it is level and stable. Proper positioning  
of the machine ensures problem-free opening and closing of its  
door.  
CAUTION  
Always use new hoses when you connect the  
appliance to the water mains. Old hoses must  
not be used. The water inlet hose must be examined at an interval of  
twelve months for deterioration and replaced if necessary.  
If the door of your machine does not close properly, check if the  
machine is stable on the floor; if not, adjust the feet and ensure it  
is level and stable.  
BEFORE FIRST USE  
In order to pass the safety valve through the kitchen cabinets, an  
opening of at least 45mm x 90mm is needed.  
NOTE: During installation or before first use you may observe some  
water in the machine. This is a residual water left in the machine  
after a full functional test in the factory to ensure the machine is  
delivered to customers in perfect working order and is no cause for  
concern.  
Water connection  
30cm  
min.  
Ensure that the indoor plumbing is suitable for installing  
a dishwasher and complies with AS/NZS 3500.1.  
Also, we recommend that you fit a filter at the entrance of your place  
or apartment so as to avoid any damage to your machine because of  
any contamination (sand, clay, rust etc) that might be occasionally  
carried in through the main’s water supply or the indoor plumbing,  
and to avoid problems of staining and formation of deposits after  
washing.  
Water inlet hose  
Do not use the water inlet hose of your old machine, you must use the  
new water inlet hose supplied with your machine. Before connecting  
the water inlet hose to the water tap, ensure clean water is flowing  
from the tap before making the connection. Connect the water inlet  
hose directly to the water inlet tap. The  
Water drain hose  
pressure supplied by the tap should be at a  
If you connect the water drain hose to a trap spigot under the sink,  
remove the plastic membrane. If you do not remove the entire  
membrane, remaining food can cause a blockage in the drain hose  
spigot. Ensure a hose clamp is used to secure the hose to the spigot.  
minimum of 0.03 MPa and at a maximum of  
1 MPa. If the water pressure is above 1 MPa, a  
pressure-relief valve should be installed.  
WARNING  
Only turn the locking nut to secure hose - do  
not turn the hose.  
Remove  
entire  
internal  
membrane  
The first time you use the appliance, make sure that there is no  
leakage.  
The water inlet hose has a safety valve and a sheath with an  
inner mains cable.  
8
INSTALLING THE MACHINE  
GeneralDetails
NameWestinghouse WSF6602XB 14 Place Dishwasher
MakeWestinghouse
LanguageEnglish
FiletypePDF (Download)
File size0.75 MB
Download PDF
1 Star2 Stars3 Stars4 Stars5 Stars (1 votes, average: 5.00 out of 5)
Loading...
Westinghouse WSF6606 Dishwasher
Westinghouse WSF6606 Dishwasher
Westinghouse WSF6604WA Dishwasher
Westinghouse WSF6604WA Dishwasher
Westinghouse WSF6604XB Dishwasher
Westinghouse WSF6604XB Dishwasher
Westinghouse WSF6606XB Dishwasher
Westinghouse WSF6606XB Dishwasher
Westinghouse WSF6604WB Dishwasher
Westinghouse WSF6604WB Dishwasher
Westinghouse WSU6608XB Dishwasher
Westinghouse WSU6608XB Dishwasher
Westinghouse WSF6608XB Dishwasher
Westinghouse WSF6608XB Dishwasher
Westinghouse WSF6608KXB Sensor Wash Dishwasher
Westinghouse WSF6608KXB Sensor Wash Dishwasher
Westinghouse WSF6602WB Dishwasher
Westinghouse WSF6602WB Dishwasher
Westinghouse WSF6606KXB Dishwasher
Westinghouse WSF6606KXB Dishwasher

Westinghouse WSF6602XB 14 Place Dishwasher