Whirlpool 0000 Place Dishwasher
DAILY USE
1. CHECK WATER CONNECTION
Check that the dishwasher is connected to the water supply and that
the tap is open.
MODIFYING A RUNNING PROGRAM
If a wrong program was selected, it is possible to change it, provid-
ed that it has only just begun: press and hold the ON/OFF button,
the machine will switch off. Switch the machine back on using the
ON/OFF button and select the new wash cycle and any desired op-
tions; start the cycle by pressing the START/PAUSE button.
2. SWITCH ON THE DISHWASHER
Press the ON/OFF button.
3. LOAD THE RACKS (see LOADING THE RACKS).
4. FILLING THE DETERGENT DISPENSER
ADDING EXTRA CROCKERY
Without switching off the machine, open the door (be ware of HOT
steam!) and place the crockery inside the dishwasher. Close the door
and press the START/Pause button the cycle will begin from the point
at which it was interrupted.
5. CHOOSE THE PROGRAM AND CUSTOMISE THE CYCLE
Select the most appropriate program in accordance with the type of
crockery and its soiling level (see PROGRAMS DESCRIPTION) by press-
ing the P button.
Select the desired options (see OPTIONS AND FUNCTIONS).
ACCIDENTAL INTERRUPTIONS
6. START
If the door is opened during the wash cycle, or if there is a power cut,
the cycle stops. Once the door has been closed or the electricity supply
is restored, to start again the cycle from where it was interrupted, press
the START/Pause button.
Start the wash cycle by pressing the START/Pause button.
When the program starts you hear a beep.
7. END OF WASH CYCLE
The end of the wash cycle is indicated by beeps and the display
shows End. Open the door and switch off the appliance by pressing
the ON/OFF button.
Wait for a few minutes before removing the crockery - to avoid
burns. Unload the racks, beginning with the lower one.
To disable the DEMO MODE the following actions must be carried out
in sequence, without breaks. Switch the machine ON and then switch
it OFF again. Press the DELAY button until the buzzer is heard. Switch
the machine on again. The “dOF”indicator flashes and then turns OFF.
The machine will switch off automatically during certain extended
periods of inactivity, in order to minimise electricity consumption.
If the crockery is only lightly soiled or if it has been rinsed with wa-
ter before being placed in the dishwasher, reduce the amount of
detergent used accordingly.
ADVICE AND TIPS
TIPS
DAMAGE TO GLASS AND CROCKERY
Before loading the baskets, remove all food residues from the crockery • Only use glasses and porcelain guaranteed by the manufacturer as
and empty the glasses. You do not need to rinse beforehand under run-
ning water.
dishwasher safe.
• Use a delicate detergent suitable for crockery
Arrange the crockery so that it is held in place firmly and does not tip • Collect glasses and cutlery from the dishwasher as soon as the wash
over; and arrange the containers with the openings facing downwards
and the concave/convex parts placed obliquely, thus allowing the wa-
ter to reach every surface and flow freely.
Warning: lids, handles, trays and frying pans do not prevent the spray-
er arms from rotating.
cycle is over.
TIPS ON ENERGY SAVING
• When the household dishwasher is used according to the manufac-
turer’s instructions, washing tableware in a dishwasher usually con-
sumes less energy and water than hand dishwashing.
Place any small items in the cutlery basket.
Very soiled dishes and pans should be placed in the lower basket be- • In order to maximize dishwasher efficiency it is recommended to initiate
cause in this sector the water sprays are stronger and allow a higher
washing performance.
After loading the appliance, make sure that the sprayer arms can
the wash cycle once dishwasher is fully loaded. Loading the house-
hold dishwasher up to the capacity indicated by the manufacturer will
contribute to energy and water savings. Information on correct load-
ing of tableware can be found in LOADING THE RACKS chapter.
rotate freely.
• In case of partial loading it is recommended to use dedicated wash
options if available (Half load/ Zone Wash, Multizone), fiilling up only
selected racks. Incorrect loading or overloading the dishwasher may
increase resources usage (such as water, energy and time, as well as
increase noise level), reducing cleaning and drying performance.
UNSUITABLE CROCKERY
• Wooden crockery and cutlery.
• Delicate decorated glasses, artistic handicraft and antique crockery.
Their decorations are not resistant.
• Parts in synthetic material which do not withstand high tempera-
tures.
• Manual pre-rinsing of tableware items leads to increased water and
energy consumption and is not recommended.
• Copper and tin crockery.
• Crockery soiled with ash, wax, lubricating grease or ink.
The colours of glass decorations and aluminium/silver pieces can
change and fade during the washing process. Some types of glass (e.g.
crystal objects) can become opaque after a number of wash cycles too.
HYGIENE
To avoid odour and sediment which can be accumulated in the dish-
washer please run a high temperature program at least one a
month. Use a tea spoon of detergent and run it without the loading to
clean your appliance.
6
| General | Details |
|---|---|
| Name | Whirlpool 0000 Place Dishwasher |
| Make | Whirlpool |
| Language | English |
| Filetype | PDF (Download) |
| File size | 85.75 MB |

Whirlpool 2B19 Dishwasher

Whirlpool WFO3O33PLAUS Standard Dishwasher

Whirlpool W11323304G Dishwasher

Whirlpool WH7IPC15BM60 Dishwasher

Whirlpool FINPUTSAD Dishwasher

Whirlpool W7U HS31 X Dishwasher

Whirlpool Thron Dishwasher

Whirlpool WDF332PAMS 24 Front Tall Tub Dishwasher

Whirlpool WRF540CWHZ Dishwasher

Whirlpool W10901596A Dishwasher Internet Connectivity










