Home > Bauknecht > Bauknecht B7I HF60 Dishwasher

Bauknecht B7I HF60 Dishwasher

DAILY USE  
1. CHECK WATER CONNECTION  
Check that the dishwasher is connected to the water supply and that  
the tap is open.  
The machine will switch off automatically during certain extended  
periods of inactivity, in order to minimise electricity consumption.  
If the crockery is only lightly soiled or if it has been rinsed with wa-  
ter before being placed in the dishwasher, reduce the amount of  
detergent used accordingly.  
2. SWITCH ON THE DISHWASHER  
Press the ON/OFF button.  
3. LOAD THE RACKS  
MODIFYING A RUNNING PROGRAM  
(see LOADING THE RACKS).  
If a wrong program was selected, it is possible to change it, provid-  
ed that it has only just begun: press and hold the ON/OFF button,  
the machine will switch off. Switch the machine back on using the  
ON/OFF button and select the new wash cycle and any desired op-  
tions; start the cycle by pressing the START/PAUSE button.  
4. FILLING THE DETERGENT DISPENSER  
5. CHOOSE THE PROGRAM AND CUSTOMISE THE CYCLE  
Select the most appropriate program in accordance with the type of  
crockery and its soiling level (see PROGRAMS DESCRIPTION) by press-  
ing the P button.  
ADDING EXTRA CROCKERY  
Select the desired options (see OPTIONS AND FUNCTIONS).  
Without switching off the machine, open the door (be ware of HOT  
steam!) and place the crockery inside the dishwasher. Close the door  
and press the START/Pause button the cycle will begin from the point  
at which it was interrupted.  
6. START  
Start the wash cycle by pressing the START/Pause button. When the  
program starts you hear a beep.  
7. END OF WASH CYCLE  
ACCIDENTAL INTERRUPTIONS  
The end of the wash cycle is indicated by beeps and the display  
shows END. Open the door and switch off the appliance by pressing  
the ON/OFF button.  
If the door is opened during the wash cycle, or if there is a power cut,  
the cycle stops. Once the door has been closed or the electricity supply  
is restored, to start again the cycle from where it was interrupted, press  
the START/Pause button.  
Wait for a few minutes before removing the crockery - to avoid  
burns. Unload the racks, beginning with the lower one.  
To disable the DEMO MODE the following actions must be carried out  
in sequence, without breaks. Switch the machine ON and then switch  
it OFF again. Press the DELAY button until the buzzer is heard. Switch  
the machine on again. The “dOFindicator flashes and then turns OFF.  
ADVICE AND TIPS  
TIPS  
DAMAGE TO GLASS AND CROCKERY  
Before loading the baskets, remove all food residues from the crockery • Only use glasses and porcelain guaranteed by the manufacturer as  
and empty the glasses. You do not need to rinse beforehand under run-  
ning water.  
dishwasher safe.  
• Use a delicate detergent suitable for crockery  
Arrange the crockery so that it is held in place firmly and does not tip • Collect glasses and cutlery from the dishwasher as soon as the wash  
over; and arrange the containers with the openings facing downwards  
and the concave/convex parts placed obliquely, thus allowing the wa-  
ter to reach every surface and flow freely.  
Warning: lids, handles, trays and frying pans do not prevent the spray-  
er arms from rotating.  
cycle is over.  
TIPS ON ENERGY SAVING  
• When the household dishwasher is used according to the manufac-  
turer’s instructions, washing tableware in a dishwasher usually con-  
sumes less energy and water than hand dishwashing.  
Place any small items in the cutlery basket.  
Very soiled dishes and pans should be placed in the lower basket be-  
cause in this sector the water sprays are stronger and allow a higher  
washing performance.  
After loading the appliance, make sure that the sprayer arms can  
rotate freely.  
• In order to maximize dishwasher efficiency it is recommended to initiate  
the wash cycle once dishwasher is fully loaded. Loading the house-  
hold dishwasher up to the capacity indicated by the manufacturer will  
contribute to energy and water savings. Information on correct load-  
ing of tableware can be found in LOADING THE RACKS chapter.  
• In case of partial loading it is recommended to use dedicated wash  
options if available (Half load/ Zone Wash, Multizone), fiilling up only  
selected racks. Incorrect loading or overloading the dishwasher may  
increase resources usage (such as water, energy and time, as well as  
increase noise level), reducing cleaning and drying performance.  
UNSUITABLE CROCKERY  
• Wooden crockery and cutlery.  
• Delicate decorated glasses, artistic handicraft and antique crockery.  
Their decorations are not resistant.  
• Parts in synthetic material which do not withstand high tempera-  
tures.  
• Manual pre-rinsing of tableware items leads to increased water and  
energy consumption and is not recommended.  
• Copper and tin crockery.  
• Crockery soiled with ash, wax, lubricating grease or ink.  
The colours of glass decorations and aluminium/silver pieces can  
change and fade during the washing process. Some types of glass (e.g.  
crystal objects) can become opaque after a number of wash cycles too.  
HYGIENE  
To avoid odour and sediment which can be accumulated in the  
dishwasher please run a high temperature program at least one  
a month. Use a tea spoon of detergent and run it without the loading  
to clean your appliance.  
6
GeneralDetails
NameBauknecht B7I HF60 Dishwasher
MakeBauknecht
LanguageEnglish
FiletypePDF (Download)
File size9.34 MB
Download PDF
1 Star2 Stars3 Stars4 Stars5 Stars (1 votes, average: 5.00 out of 5)
Loading...
Bauknecht BK6UC11BS7A0X Dishwasher
Bauknecht BK6UC11BS7A0X Dishwasher
BAUKNECHT 295f471f27d55b Dishwasher
BAUKNECHT 295f471f27d55b Dishwasher
Bauknecht Dishwasher
Bauknecht Dishwasher
Bauknecht 3O35 PF Dishwasher
Bauknecht 3O35 PF Dishwasher
Bauknecht AUTBFC3C26 Dishwasher
Bauknecht AUTBFC3C26 Dishwasher
BAUKNECHT B2I HD526 A Dishwasher
BAUKNECHT B2I HD526 A Dishwasher
Bauknecht ‎BFP 5O41 PLT X Dishwasher
Bauknecht ‎BFP 5O41 PLT X Dishwasher

Bauknecht B7I HF60 Dishwasher