Home > GE Appliances > GE APPLIANCES GDF650SYVFS Dishwasher
GE APPLIANCES GDF650SYVFS Dishwasher
Troubleshooting Tips... Before you call for service
Problem
Possible Cause
What To Do
Dishes dont dry
Low inlet water temperature Make sure inlet water temperature is at least 120°F.
Select Boost Dry.
Use Boost option.
Select a higher cycle, such as Steam-Sani, Presoak-
Sani, or Sanitize.
Rinse agent dispenser is empty Check the rinse agent dispenser and fill as required.
Additional drying time is
needed
Leave door closed after the Clean light appears to allow
the fan to run an additional 90 minutes.
Note: If you open the door, this fan extension will be cancelled.
Control panel
Door may not be completely Make sure the door is firmly closed.
responded to inputs closed
but dishwasher
Water valve may be turned
Make sure water valve (usually located under the sink) is
turned on.
never filled with
water
off
Flood float may be stuck
Remove Ultra-Fine filter and lightly tap the piece under the
ultra fine filter that looks like a salt shaker. Replace the filter.
Stained tub interior
White film on inside
surface hard water
minerals
GE Appliances recommends high quality rinse agents such as
Cascade® Platinum Power Dry Rinse Aid or Finish®
Jet-Dry® Rinse Aid to help prevent hard water mineral
deposits from forming.
Run dishwasher with citric acid to remove mineral deposits.
WD35X151) can be ordered
through GE Appliances Parts. See back cover for ordering
information. Alternatively, purchase Cascade® Platinum
Dishwasher Cleaner or Finish® Dishwasher Cleaner
and follow the directions on the label.
Dishwasher wont
run
Fuse is blown or circuit
breaker is tripped
Replace fuse or reset circuit breaker. Remove any other
appliances from the circuit.
Power is turned off
In some installations, the power to the dishwasher is
provided through a wall switch, often located next to the
disposer switch. Make sure it is on.
Control panel is locked
Possible leak is detected
Unlock control panel. See the Getting started section.
Some models are equipped with leak detection and the
cycle will be cancelled if a leak is detected. The display
will show LEAK DETECTED. Contact us for service.
Proper Start sequence was
not followed
See the Using the dishwasher section.
Control panel lights
go off when youre
setting controls
Time too long between
touching of selected pads
Each pad must be touched within 30 seconds of the
others. To relight, touch any pad again or open the door
and unlock (top control).
Water standing in
the bottom of the
tub
Air gap is clogged
Clean the air gap. See the Care and Cleaning section.
High drain loop or air gap
not installed
Refer to the Installation Instructions for proper drain line
installation.
Water wont pump
out of the tub
Drain is clogged
If you have an air gap, clean it. See the Care and
Cleaning section.
If the dishwasher drains into a disposer, run disposer clear.
Check to see if your kitchen sink is draining well. If not,
you may need a plumber.
49-4000283 Rev 1
23
| General | Details |
|---|---|
| Name | GE APPLIANCES GDF650SYVFS Dishwasher |
| Make | GE Appliances |
| Language | English |
| Filetype | PDF (Download) |
| File size | 2.89 MB |

GE APPLIANCES GTW845 Dishwasher

GE APPLIANCES GSD2100VBB Dishwasher

GE APPLIANCES GDF550PGR Plastic Interior Dishwasher with Front Controls

GE APPLIANCES PDT755SYV/BTV UltraFresh System Dishwasher with Interior

GE APPLIANCES GDT650SYV Interior Dishwasher with Hidden Controls

GE APPLIANCES PDP715SYVFS GE Profile Series Interior Dishwasher

GE APPLIANCES PDT715SYV Interior Dishwasher with Hidden Controls

GE APPLIANCES GDT670SGV Interior Dishwasher with Hidden Controls

GE APPLIANCES PDT705SYWFS Dishwasher

GE APPLIANCES GDT565HSYSS Energy Star Hybrid Tub Dishwasher







































