Home > Ikea > IKEA FINPUTSAD Integrated Dishwasher

IKEA FINPUTSAD Integrated Dishwasher

ENGLISH  
14  
What to do if ...  
In case your dishwasher doesn’t work properly, check if the problem can be solved by going through the following  
list. For other errors or issues please contact authorized After-sales Service which contact details can be found in  
the guarantee booklet. Spare parts will be available for a period of either up to 7 or up to 10 years, according to the  
specific Regulation requirements.  
Problems... Possible causes...  
Solutions...  
Salt reservoir is empty. (After refill the salt  
indicator may remain lit for several wash  
cycles).  
Salt indicator  
is lit  
Refill reservoir with salt (for more information - see page 8).  
Adjust water hardness - see table, page 8.  
Rinse aid dispenser is empty. (After refill  
the rinse aid indicator may remain lit for  
several wash cycles).  
Rinse aid  
indicator is lit  
Refill dispenser with rinse aid (for more information - see page 8).  
The appliance has not been plugged in  
properly.  
Insert the plug into the socket.  
For safety reasons, dishwasher will not re-start automatically when  
power returns. Open dishwasher door, press START/Pause button  
and close the door within 4 seconds.  
Power outage.  
The dishwasher  
won’t start or  
The dishwasher door is not closed.  
Vigorously push the door until you hear the “click”.  
NATURALDRY pin is not pulled in.  
does not respond  
to commands.  
Cycle is interupted by door opening for  
more than 4 seconds.  
Press START/Pause and close the door within 4 seconds.  
Switch off the appliance by pressing the ON/OFF button, switch it  
back on after approximately one minute and restart the program.  
If problem persists, unplug the appliance for 1 minute, then plug it  
back in.  
It does not respond to commands.  
Display shows: 9 or 12 and On/Off LED is  
blinking rapidly  
The dishwasher  
won’t drain.  
Display shows:  
3 and On/Off  
LED is blinking  
rapidly  
The wash cycle has not finished yet.  
The drain hose is bent.  
Wait until the wash cycle finishes.  
Check that the drain hose is not bent (see INSTALLATION).  
Clean the sink drain pipe.  
The sink drain pipe is blocked.  
The filter is clogged up with food residues. Clean the filter (see CLEANING THE FILTER ASSEMBLY).  
The dishes are rattling against each  
Position the crockery correctly (see LOADING THE RACKS).  
The detergent has not been measured out correctly or it is not  
suitable for use in dishwashers (see FILLING THE DETERGENT  
DISPENSER). Restart the current cycle by switching OFF the  
dishwasher, then switch it on again, select a new program, press  
START/Pause and close the door within 4 seconds. Please do not  
add any detergent.  
The dishwasher  
makes excessive  
noise.  
An excessive amount of foam has been  
produced.  
The crockery has not been arranged  
properly.  
Arrange the crockery correctly (see LOADING THE RACKS).  
Arrange the crockery correctly (see LOADING THE RACKS).  
Select an appropriate wash cycle (see PROGRAMS TABLE).  
The spray arms cannot rotate freely, being  
hindered by the dishes.  
The wash cycle is too gentle and/or  
detergent efficiency is low.  
The dishes are  
not clean.  
An excessive amount of foam has been  
produced.  
The detergent has not been measured out correctly or it is not suita-  
ble for use in dishwashers (see FILLING THE DETERGENT DISPENSER).  
The cap on the rinse aid compartment has  
not been shut correctly.  
Make sure the cap of the rinse aid dispenser is closed.  
The filter is soiled or clogged.  
Clean the filter assembly (see CLEANING AND MAINTENANCE).  
There is no salt.  
Fill the salt reservoir (see FILLING THE SALT RESERVOIR).  
The dishwasher  
does not fill the  
water.  
Display shows: H,  
6 and On/Off  
LED is blinking  
rapidly  
No water in the water supply or the tap is  
closed.  
Make sure there is water in the water supply or the tap running.  
Make sure the inlet hose is not bent (see INSTALLATION) reprogram  
the dishwasher and reboot.  
The inlet hose is bent.  
The sieve in the water inlet hose is clogged; After having carried out the verification and cleaning, turn off and  
it is necessary to clean it turn on the dishwasher and restart a new program.  
GeneralDetails
NameIKEA FINPUTSAD Integrated Dishwasher
MakeIkea
LanguageEnglish
FiletypePDF (Download)
File size3.64 MB
Download PDF
1 Star2 Stars3 Stars4 Stars5 Stars (1 votes, average: 5.00 out of 5)
Loading...
IKEA 404.755.53 Medelstor Dishwasher
IKEA 404.755.53 Medelstor Dishwasher
IKEA 804.621.67 Lagan Dishwasher
IKEA 804.621.67 Lagan Dishwasher
IKEA RENGÖRA 204.756.05 Dishwasher
IKEA RENGÖRA 204.756.05 Dishwasher
IKEA 9001774317 TORSBODA Dishwasher
IKEA 9001774317 TORSBODA Dishwasher
IKEA 9001774318 Dishwasher
IKEA 9001774318 Dishwasher
IKEA SBE8596Z0E DISKAD PROFFSIG Dishwasher
IKEA SBE8596Z0E DISKAD PROFFSIG Dishwasher
IKEA VILLBODA Dishwasher
IKEA VILLBODA Dishwasher
IKEA 504.754.25 HYGIENISK Dishwasher
IKEA 504.754.25 HYGIENISK Dishwasher
IKEA AA-2412057-2-1 RÅGLANDA Dishwasher
IKEA AA-2412057-2-1 RÅGLANDA Dishwasher
IKEA 905.681.49 OSTVEDA Dishwasher
IKEA 905.681.49 OSTVEDA Dishwasher

IKEA FINPUTSAD Integrated Dishwasher