JOCEL JLLI023124 Dishwasher
FILTER ASSEMBLY
For best performance and results, the filter assembly must be cleaned. The filter efficiently
removes food particles from the wash water, allowing it to be recirculated during the cycle.
For this reason, it is a good idea to remove the larger food particles trapped in the filter after
each wash cycle by rinsing the semicircular filter and cup under running water. To remove
the filter assembly, pull on the cup handle in the upward direction. The entire filter assembly
should be cleaned once a week. To clean the coarse filter and the micro filter, use a cleaning
brush. Then, reassemble the filter parts as shown in the figures above and reinsert the entire
assembly in the dishwasher, positioning in its seat and pressing downward. The dishwasher
must never be used without the filters. Improper replacement of the filter may reduce the
performance level of the appliance and damage dishes and utensils.
WARNING!
Never run the dishwasher without the filters in place. When cleaning the filters, don't knock
on them.
Otherwise, the filters could be contorted and the performance of dishwasher could be
debased.
CLEANING THE SPRAY ARMS
It is necessary to clean the spray arms regularly for hard water chemicals will clog the spray
arm jets and bearings. To remove the spray arms, screw off the nut clockwise to take out
the washer on top of the spray arm and remove the arm. Wash the arms in soapy and warm
water and use a soft brush to clean the jets. Replace them after rinsing thoroughly.
CARING FOR THE DISHWASHER
To clean the control panel, use a lightly dampened cloth then dry thoroughly.
To clean the exterior, use a good appliance polish wax.
Never use sharp objects, scouring pads or harsh cleaners on any part of the dishwasher.
PROTECT AGAINST FREEZING
If your dishwasher is left in an unheated place during the winter, ask a service technical to:
1. Cut off electrical power to the dishwasher.
2. Turn off the water supply and disconnect the water inlet pipe from the water valve.
3. Drain water from the inlet pipe and water valve. (Use a pan to catch the water)
4. Reconnect the water inlet pipe to the water valve.
5. Remove the filter in the tub and the bottom and use a sponge to use up water in sump.
94
CLEANING THE DOOR
To clean the edge around the door, you should use only a soft warm, damp rag. To prevent
penetration of water into the door lock and electrical components, do not use a spray cleaner
of any kind.
Also, never use abrasive cleaners or scouring pads on the outer surfaces because they will
scratch the finish. Some papers towels can also scratch or leave marks on the surface.
Follow these steps when there is foreign material in the dishwasher.
WARNING!
Never use a spray cleaner to clean the door panel for it could damage the door lock and
electrical components. It is not allowed to use the abrasive agent or some paper towel
because of the risk of scratching or leaving spots on the stainless-steel surface.
HOW TO KEEP YOUR DISHWASHER IN SHAPE
AFTER EVERY WASH
After every wash, turn off the water supply to the appliance and leave the door slightly ajar
so that moisture and odors are not trapped inside.
REMOVE THE PLUG
Before cleaning or performing maintenance, always remove the plug from the socket. Do
not run risks.
NO SOLVENTS OR ABRASIVE CLEANING
To clean the exterior and rubber parts of the dishwasher, do not use solvents or abrasive
cleaning products. Use only a cloth and warm soapy water. To remove spots or stains from
the surface of the interior, use a cloth dampened with water and a little white vinegar, or a
cleaning product made specifically for dishwashers.
WHEN YOU GO ON HOLIDAY
When you go on holiday, it is recommended that you run a wash cycle with the dishwasher
empty and then remove the plug from the socket, turn off the water supply and leave the
door of the appliance slightly ajar. This will help the seals last longer and prevent odors from
forming in the appliance.
MOVING THE APPLIANCE
If the appliance must be moved, try to keep it in the vertical position. If absolutely necessary,
it can be positioned on its back.
SEALS
One of the factors that cause odors to form in the dishwasher is food that remains trapped
in the seals. Periodic cleaning with a damp sponge will prevent this.
95
ATTENTION:
The installation of the pipes and electrical equipments should be done by professionals.
Warning!
Electrical Shock Hazard!
Disconnect electrical power before installing dishwasher.
Failure to do so can result in death or electrical shock.
INSTALLATION
Keep this instruction manual in a safe place for future reference. If the appliance is
sold, given away or moved, please ensure the manual is kept with the machine, so
that the new owner may benefit from the advice contained within it.
Please read this instruction manual carefully: it contains important information
regarding the safe installation, use and maintenance of the appliance.
If the appliance must be moved at any time, keep it in an upright position; if absolutely
necessary, it may be tilted onto its back.
POSITIONING AND LEVELING
1. Remove the appliance from all packaging and check that it has not been damaged during
transportation. If it has been damaged, contact the retailer and do not proceed and
further with the installation process.
2. Check the dishwasher by placing it so that its sides or back panel are in contact with the
adjacent cabinets or even with the wall. This appliance can also be recessed under a
single worktop (see the Assembly instruction sheet).
3. Position the dishwasher on a level and sturdy floor. If the floor is uneven, the front feet
of the appliance may be adjusted until it reaches a horizontal position (the angle of
inclination must not exceed 2 degrees). If the appliance is levelled correctly, it will be
more stable and much less likely to move or cause vibrations and noise while it is
operation.
CONNECTING THE WATER AND ELECTRICITY SUPPLIES
Connection to the water and electricity supplies should only be performed by a
qualified technician.
The dishwasher should not stand on top of the water hoses or the electricity supply
cable.
The appliance must be connected to the water supply network using new piping. Do
not use old piping.
96
| General | Details |
|---|---|
| Name | JOCEL JLLI023124 Dishwasher |
| Make | JOCEL |
| Language | English |
| Filetype | PDF (Download) |
| File size | 1.44 MB |
(1 votes, average: 5.00 out of 5)
Loading...
Electrolux GA55GLICN Dishwasher
BOSCH SPS4HMW49G Dishwasher
ZLINE DWV-18 Tallac Dishwasher
Midea MDF18A1A Series Dishwasher
FISHER and PAYKEL DW24UNT4X2 Dishwasher
Hotpoint HD8I Integrated Dishwasher
FISHER PAYKEL DD24DTX6HI1 Sanitize Dishwasher
IKEA HYGIENISK Dishwasher
PHILCO PD 1466 CBIT Dishwasher
Haier 500 Series Dishwasher