Home > KitchenAid > KitchenAid KDSDM82143 Dishwasher
KitchenAid KDSDM82143 Dishwasher
PROBLEMS
POSSIBLE CAUSES
SOLUTIONS
Racks are not fit to the end.
The door is not lock.
Verify that racks are fit to the end.
The door doesn’t
lock.
Vigorously push the door until you hear the “clack” sound.
Arrange the crockery correctly (see Loading the Racks).
The dishes are rattling against each.
The detergent has not been measured out correctly or it is not suitable for
use in dishwashers (see Filling the Detergent Dispenser). Reset the current
cycle by switching OFF the dishwasher, then switch it on again, select
a new program, press START and close the door. Please do not add any
detergent.
The dishwasher
makes excessive
noise.
An excessive amount of foam has been
produced.
The selected program hasn’t any drying
phase.
Verify on the programs table if the selected program has the drying phase.
The dishes have not The rinse aid has run out or the resolution Add the rinse aid or adjust the dosage levels higher (see Filling the Rinse
been dried.
is not adequate.
Aid Dispenser).
The dishes are made of non-stick or
plastic.
It is normal the presence of drops of water (see Tips).
The crockery has not been arranged
properly.
Arrange the crockery correctly (see Loading the Racks).
Arrange the crockery correctly (see Loading the Racks).
Select an appropriate wash cycle (see Programs Table).
The spray arms cannot rotate freely, being
hindered by the dishes.
The wash cycle is too gentle and/or deter-
gent eꢀciency is low.
The detergent has not been measured out correctly or it is not suitable for
use in dishwashers (see Filling the Detergent Dispenser). Reset the current
cycle by switching OFF the dishwasher, then switch it on again, select
a new program, press START and close the door. Please do not add any
detergent.
The dishes are not
clean.
An excessive amount of foam has been
produced (see AFTER-SALES SERVICE).
The cap on the rinse aid compartment has
not been shut correctly.
Make sure the cap of the rinse aid dispenser is closed.
The filter is soiled or clogged.
There is no salt.
Clean the filter assembly (see Care and Maintenance).
Fill the salt reservoir (see Filling the Salt Reservoir).
Fill the salt reservoir (see Filling the Salt Reservoir).
The salt level is too low.
The adjustment of the water hardness is
not adequate.
Increase the values (see Water Hardness Table).
Check to have properly closed the salt reservoir cap.
Add the rinse aid or adjust the dosage levels higher.
The dishes and glas-
ses show calcination
or a whitish film.
The cap of the salt reservoir is not proper-
ly closed.
The rinse aid is used up or the dosage is
insuꢀcient.
The dishes and
glasses are blue
streaked or have a
bluish tinge.
The rinse aid dosage is excessive.
Adjust the dosage rates below.
16
| General | Details |
|---|---|
| Name | KitchenAid KDSDM82143 Dishwasher |
| Make | KitchenAid |
| Language | English |
| Filetype | PDF (Download) |
| File size | 1.99 MB |
(1 votes, average: 5.00 out of 5)
Loading...
KitchenAid KDTE304RBS Third Level Jet Rack Dishwasher
KitchenAid KDTF324PPA Dishwasher
Kitchenaid MVWC565FW1 Dishwasher
KitchenAid w11323304 Dishwasher
KitchenAid KDFE104KWH Two Rack Dishwasher
KitchenAid KDTE104KPS Dishwasher
KitchenAid KDFE104KBL Front Dishwasher
KitchenAid KDTF924PPS Flush Cabinet Dishwasher
KitchenAid KDTE304RBS Level Jet Rack Dishwasher
KitchenAid KDF Series Dishwasher
BOSCH SMV6ZCX02E-39 Dishwasher
BOSCH SMS2ITI12E Dishwasher
GE APPLIANCES PDP715SYNFS Dishwasher
SAMSUNG DW60CB750UAPSA Bespoke Built Under Dishwasher
CMA DISHMACHINES EST-AH Door Type Rack Low Dishwasher
BOSCH SMI8ZDS81T Dishwasher
Electrolux EEC87400W Sliding Door Dishwasher
FISHER PAYKEL DD24DCHTX9 N Sanitize Dishwasher
BOSCH SMV6ZB803E Dishwasher
FISHER PAYKEL DD60STX6I1 Dishwasher