Home > KitchenAid > KitchenAid KDSDM82143 Dishwasher

KitchenAid KDSDM82143 Dishwasher

TROUBLESHOOTING  
Your dishwasher may not work properly.  
Before contacting the After-sales Service, check if the problem can be solved by going through the following list.  
PROBLEMS  
POSSIBLE CAUSES  
SOLUTIONS  
Display shows:  
CHECK SALT or  
ADD SALT  
Refill reservoir with salt (see page 6).  
Adjust water hardness (see page 6).  
Salt reservoir is empty.  
Display shows:  
Rinse aid dispenser is empty.  
Refill dispenser with rinse aid (see page 6).  
CHECK RINSE AIDor  
ADD RINSE AID  
The appliance must be switched on. Check the household circuit fuse if there is no power supply.  
The appliance door doesn’t close.  
Check if the appliance door is closed.  
... is not working / will not  
start.  
Check whether theStart Delayoption has been selected. If it has, the  
appliance will start once the set time has elapsed. If necessary, Reset  
the current cycle by switching OFF the dishwasher, then switch it on  
again, select a new cycle, press START and close the door.  
“Start Delayoption is ON.  
The water tap must be fully open during water inlet (minimum capaci-  
ty: 0.5 litres per minute).  
Water pressure is too low.  
Display shows: F6  
symbol on the display  
indicators  
Kinked water inlet hose or cloged  
inlet filters.  
The water inlet hose must not be kinked and the inlet filter in the water  
tap connector must not be dirty or clogged.  
Dirty filters.  
Clean the filters.  
Kinked drain hose.  
The drain hose must not be kinked.  
Display shows: F3  
The closure disk of the syphon hose connection  
must be removed.  
Syphon hose connection closed.  
Dirty filters or spray arms.  
Clean filters and spray arms.  
Too little water in the appliance  
system.  
Concave items (e.g. bowls, cups) must be arranged  
facing downwards in the rack.  
The drain hose must be fitted correctly (for high mounted appliances,  
leave min. 200 - 400mm from the lower edge of the appliance) - see  
Installation.  
Drain hose incorrectly fitted.  
Display shows: F2  
Repeat without detergent or wait until foam  
disappears..  
High level of foam inside.  
Water pressure is too low.  
The water tap must be fully open during water inlet (minimum capaci-  
ty: 0.5 litres per minute).  
Kinked water inlet hose or cloged  
inlet filters.  
The water inlet hose must not be kinked and the inlet filter in the water  
tap connector must not be dirty or clogged.  
Display shows:  
PRESS START AND  
CLOSE THE DOOR  
Door is not closed within  
4 seconds of button press.  
Press again and close the appliance door within 4 seconds.  
Display shows:  
OPEN AND CLOSE  
THE DOOR  
The door was not open between  
cycles.  
Unload appliance (if not unloaded before), open and close the door.  
Call customer service (state fault displayed).  
Close the water tap.  
Appliance has technical defect.  
Display shows: Fx  
15  
GeneralDetails
NameKitchenAid KDSDM82143 Dishwasher
MakeKitchenAid
LanguageEnglish
FiletypePDF (Download)
File size1.99 MB
Download PDF
1 Star2 Stars3 Stars4 Stars5 Stars (1 votes, average: 5.00 out of 5)
Loading...
KitchenAid KDTE304RBS Third Level Jet Rack Dishwasher
KitchenAid KDTE304RBS Third Level Jet Rack Dishwasher
KitchenAid KDTF324PPA Dishwasher
KitchenAid KDTF324PPA Dishwasher
Kitchenaid MVWC565FW1 Dishwasher
Kitchenaid MVWC565FW1 Dishwasher
KitchenAid w11323304 Dishwasher
KitchenAid w11323304 Dishwasher
KitchenAid KDFE104KWH Two Rack Dishwasher
KitchenAid KDFE104KWH Two Rack Dishwasher
KitchenAid KDTE104KPS Dishwasher
KitchenAid KDTE104KPS Dishwasher
KitchenAid KDFE104KBL Front Dishwasher
KitchenAid KDFE104KBL Front Dishwasher
KitchenAid KDTF924PPS Flush Cabinet Dishwasher
KitchenAid KDTF924PPS Flush Cabinet Dishwasher
KitchenAid KDTE304RBS Level Jet Rack Dishwasher
KitchenAid KDTE304RBS Level Jet Rack Dishwasher
KitchenAid KDF Series Dishwasher
KitchenAid KDF Series Dishwasher

KitchenAid KDSDM82143 Dishwasher