Home > SOLT > SOLT GGSDW6013W Dishwasher

SOLT GGSDW6013W Dishwasher

Saving Energy  
Forget to add a dish?  
Maintenance and Cleaning  
1. Pre-rinsing of tableware items leads to increased  
water and energy consumption and is not  
recommended.  
A forgotten dish can be added any time before the  
detergent dispenser opens. If  
External Care  
2 The fine filter can be pulled off the bottom  
this is the case, follow the instructions below:  
of the filter assembly. The coarse filter can  
be detached from the main filter by gently  
squeezing the tabs at the top and pulling it  
away.  
2. Washing tableware in a household dishwasher  
usually consumes less energy and water in the  
use phase than hand dishwashing when the  
household dishwasher is used according to the  
instructions.  
1
Press the Start/Pause button to pause the  
washing.  
The door and the door seal  
Clean the door seals regularly with a soft  
damp cloth to remove food deposits. When the  
dishwasher is being loaded, food and drink  
residues may drip onto the sides of the dishwasher  
door. These surfaces are outside the wash cabinet  
and are not accessed by water from the spray  
arms. Any deposits should be wiped off before the  
door is closed.  
2 After the spray arms stop working, you can  
open the door completely.  
3 Add the forgotten items.  
Main filter  
Coarse filter  
Fine filter  
4 Close the door.  
Starting A Cycle Wash  
5 Press the Start/Pause button after 10 seconds,  
the dishwasher will start.  
1
Draw out the lower and upper basket, load the  
dishes and push them back.  
After 5 sec  
It is commended to load the lower basket first,  
then the upper one.  
The control panel  
If cleaning is required, the control panel should be  
wiped with a soft damp cloth only.  
2 Pour in the detergent.  
3 Larger food remnants can be cleaned by rinsing  
the filter under running water. For a more  
thorough clean, use a soft cleaning brush.  
Warning  
3 Insert the plug into the socket. The power  
supply refer to last page”Product fiche”.  
It is dangerous to open the door mid-cycle, as hot  
steam may scald you.  
Warning  
Make sure that the water supply is turned on to  
full pressure.  
To avoid penetration of water into the door lock  
and electrical components, do not use a spray  
cleaner of any kind.  
4 Close the door, press the Power button, to  
switch on the machine.  
Never use abrasive cleaners or scouring pads on  
the outer surfaces because they may scratch the  
finish.  
5 Choose a program, the response light will turn  
on.  
Then press the Start/Pause button, the  
Some paper towels may also scratch or leave  
marks on the surface.  
dishwasher will start its cycle.  
5. Press the Start/Pause button after 10 seconds, the dishwasher will start.  
After 5 sec  
Internal Care  
Filtering system  
4 Reassemble the filters in the reverse order of the  
disassembly, replace the filter insert, and rotate  
clockwise to the close arrow.  
The filtering system in the base of the wash  
cabinet retains coarse debris from the washing  
cycle. The collected coarse debris may cause the  
filters to clog. Check the condition of the filters  
regularly and clean them if necessary under  
running water.  
Changing The Program Mid-cycle  
A wash cycle can only be changed if it has been  
running for a short time otherwise, the detergent  
may have already been released and the  
dishwasher may have already drained the wash  
water.  
Follow the steps below to clean the filters in the  
wash cabinet.  
If this is the case, the dishwasher needs to be reset  
and the detergent dispenser must be refilled. To  
reset  
1
Hold the coarse filter and rotate it anticlockwise  
to unlock the filter.  
Lift the filter upwards and out of the  
dishwasher.  
the dishwasher, follow the instructions below:  
1
Press the Start/Pause button to pause the  
washing.  
Warning  
Do not over tighten the filters. Put the filters  
back in sequence securely, otherwise coarse  
debris could get into the system and cause a  
blockage.  
2 Press the Program button for more than 3  
seconds, the dishwasher will enter standby  
mode.  
3 Press the Program button to select the desired  
program.  
Never use the dishwasher without filters in  
place. Improper replacement of the filter may  
reduce the performance level of the appliance  
and damage dishes and utensils.  
4 Press the Start/Pause button, the dishwasher  
will run after 10 seconds.  
16  
17  
GeneralDetails
NameSOLT GGSDW6013W Dishwasher
MakeSOLT
LanguageEnglish
FiletypePDF (Download)
File size1.74 MB
Download PDF
1 Star2 Stars3 Stars4 Stars5 Stars (1 votes, average: 5.00 out of 5)
Loading...
SOLT GGSDW6012B Dishwasher
SOLT GGSDW6012B Dishwasher

SOLT GGSDW6013W Dishwasher