Home > caple > caple DI631 Dishwasher

caple DI631 Dishwasher

TENSION ADJUSTMENT OF THE DOOR SPRING  
DISHWASHER INSTALLATION STEPS  
The door springs are set at the factory to the proper tension for the outer door. When the aesthetic  
door panel is installed, you will have to adjust the door spring tension. Rotate the adjusting screw  
to drive the adjuster to strain or relax the steel cable (see figure 5).  
1. Install the furniture door to the outer door of the dishwasher using the brackets provided.  
Refer to the template for positioning of the brackets.  
2. Adjust the tension of the door springs by using an Allen key turning in a clockwise motion to  
tighten the left and right door springs. Failure to do this could cause damage to  
your dishwasher. (2)  
Door spring tension is correct when  
the door remains horizontal in the  
fully opened position, yet rises to a  
close with the slight lift of a finger.  
3. Connect the inlet hose to the cold water supply.  
4. Connect the drain hose. Refer to diagram.(6)  
5. Connect the power cord.  
6. Affix the condensation strip under the work surface of cabinet. Please ensure the condensation  
strip is flush with edge of work surface. (3)  
Figure 5  
Tension adjustment  
of the door spring  
7. Place the dishwasher into position.(4)  
8. Level the dishwasher. The rear foot can be adjusted from the front of the dishwasher by turning  
the Allen screw in the middle of the base of dishwasher use an Allen key (5A). To adjust the  
front feet, use a flat screw driver and turn the front feet until the dishwasher is level (5B).  
CONNECTION OF DRAIN HOSES  
Insert the drain hose into a drain pipe with a minimum diameter of 40mm, or let it run into the  
sink, making sure to avoid bending or crimping it. The top of the hose must be less than 1000mm.  
9. The dishwasher must be secured in place. There are two ways to do this:  
»
Normal work surface: Put the installation hook into the slot of the side plane and secure it to  
the work surface with the wood screws.(6)  
»
Marble or granite work top: Fix the side with Screw. (7)  
Front  
Counter  
NOTE  
The top of the hose  
must be less than  
1000mm.  
A
B
Drain pipe  
φ 40mm  
Figure 7  
36 Instruction manual DI631 Please keep this instruction manual for future reference  
Please keep this instruction manual for future reference Instruction manual DI631  
37  
GeneralDetails
Namecaple DI631 Dishwasher
Makecaple
LanguageEnglish
FiletypePDF (Download)
File size2.41 MB
Download PDF
1 Star2 Stars3 Stars4 Stars5 Stars (1 votes, average: 5.00 out of 5)
Loading...
caple DI654 Dishwasher
caple DI654 Dishwasher
caple DI641 Dishwasher
caple DI641 Dishwasher

caple DI631 Dishwasher