Home > KitchenAid > KitchenAid w11323304 Dishwasher
KitchenAid w11323304 Dishwasher
INSTALL ACCESS PANELS
48. Power supply cord—Plug into
a grounded 3 prong outlet
50. Reinstall access panels and fasteners
Insulation
(on some models)
Plug into a grounded 3 prong outlet.
49. Reconnect power
Reconnect electrical power at the fuse box or circuit
breaker box.
Place the toe panel behind the access panel against the
dishwasher leg. If insulation is included on this model, make sure
insulation does not interfere with the float assembly. Push the
access panel up toward the top of the product so that it hangs on
the hooks on the plastic side members.
NOTE: With the access panel off, start the dishwasher and allow
it to complete the shortest Installation Cycle while checking unit
for leaks. See instructions on this manual under Check Operations
section.
■ Reinstall the toe/access panel assembly, with side shield
between the toe/access panel assembly and the side member.
Align the rectangular slot in the foam and assemble the
toe/access panel assembly to the unit using the screw.
CHECK OPERATION
■ Read the dishwasher Quick Start Guide that came with your
dishwasher.
■ Check that all parts have been installed and no steps were
skipped. Check that you have all tools used.
■ Run the Installation Cycles as follows (Note that it can be
beneficial to run this with the access panel removed in order
to look for presence of water under the unit. If running in this
state, the float switch wire MUST still be connected to the float
switch.)
NOTE: Remove film on door Score around door for easier
removal.
■ If the dishwasher is not working properly, disconnect power
or unplug dishwasher and refer to the “If Dishwasher Does Not
Operate” section.
■ Press any 3 keys (except Delay or Cancel) in the sequence
1-2-3-1-2-3-1-2-3 with no more than 1 second between key
presses to enter the Installation cycle then press button #2.
■ Close the door and the cycle will start.
■ All LEDs turn on immediately upon receiving entry sequence.
■ A tone may play depending on the model.
■ The cycle will pause when the door is opened and resume
when closed.
■ No Start/Resume key press required to resume.
■ The installation cycle may last several minutes.
51. Check access panel edge
■ Press Cancel key to exit installation cyle mode. The product
will exit this mode after 10 minutes or if power is removed from
the appliance.
■ If any error codes or blinking lights are found, see Error Code
section in this Manual prior to calling for service.
NOTE: It is normal for the drain pump to sound loud upon the
first run since no water is present in the system.
All
LEDs
on
5
Numeric
Display
1
2
3
4
(Some
models
6
7
Approximate
interval
0:30
(Maximum
5:00)
1:00
(Maximum
5:00)
0:01
2:00
0:20
0:20
0:20
0:30
Check that the lower edge of the access panel touches the floor.
Adjust if necessary.
Time
Wash+
Third
Wash+
Dispenser
(Middle
spray
Fill 3.8
L+
Wash+
Fan
Wash+
Heater
(Lower
spray
arm)
Level
Machine
Action
Initial
Drain
Drain
Pause
Wash
motor
pulses
(Ceiling
spray
arm)
Rack. If
present
in this
model
Pracess
pulses
arm)
27
| General | Details |
|---|---|
| Name | KitchenAid w11323304 Dishwasher |
| Make | KitchenAid |
| Language | English |
| Filetype | PDF (Download) |
| File size | 12.18 MB |
(1 votes, average: 5.00 out of 5)
Loading...
KitchenAid KDTE304RBS Third Level Jet Rack Dishwasher
KitchenAid KDTF324PPA Dishwasher
Kitchenaid MVWC565FW1 Dishwasher
KitchenAid KDFE104KWH Two Rack Dishwasher
KitchenAid KDTE104KPS Dishwasher
KitchenAid KDFE104KBL Front Dishwasher
KitchenAid KDTF924PPS Flush Cabinet Dishwasher
KitchenAid KDTE304RBS Level Jet Rack Dishwasher
KitchenAid KDF Series Dishwasher
KitchenAid W11589937B Dishwasher
ChuMaste CM-XWJ01 Tabletop Dishwasher
FISHER and PAYKEL DD24DTX6I1 Tall Dishwasher
Bosch SMV6ZDX16E Fully Integrated Dishwasher
AVG DW-WQP12 Dishwasher
FISHER PAYKEL DD60SHTI9 Integrated Single Dishwasher
FISHER PAYKEL DD24DDFT9 Series Dishwasher
Town Appliance W11711835A Dishwasher
BOSCH SHP78CP5N Dishwasher
belling BD14FSDX-2 Dishwasher
ASKO D5233 Dishwasher